Hostname: page-component-586b7cd67f-g8jcs Total loading time: 0 Render date: 2024-11-23T05:21:08.407Z Has data issue: false hasContentIssue false
  • English
  • Français

The Effect of Solvent Viscosity on Production of Few-layer Graphene from Liquid-phase Exfoliation of Graphite

Published online by Cambridge University Press:  14 January 2019

Matthew A. Diasio Open the ORCID record for Matthew A. Diasio [Opens in a new window]  and
David L. Green
Matthew A. Diasio
Affiliation:
Department of Materials Science and Engineering, University of Virginia, 395 McCormick Road, Charlottesville, VA22904, U.S.A.
David L. Green*
Affiliation:
Department of Materials Science and Engineering, University of Virginia, 395 McCormick Road, Charlottesville, VA22904, U.S.A. Department of Chemical Engineering, University of Virginia, Charlottesville, VA22904, U.S.A. Department of Mechanical and Aerospace Engineering, University of Virginia, Charlottesville, VA22904, U.S.A.
*
*(Email: [email protected])
Get access

Abstract:

Prior research into the liquid-phase exfoliation of graphite to produce few-layer graphene has focused primarily on the surface energy matching between graphite and solvent; however, the effect of other solvent properties, such as liquid viscosity, have not been systematically explored. In principle, a higher viscosity solvent should enable the production of graphene and other graphitic nanomaterials by liquid-phase exfoliation at lower shear rates than traditionally used organic solvents of low viscosity, such as N-methyl-2-pyrrolidone (NMP). Thus, at a given shear rate, more material should be exfoliated in the higher viscosity solvent. Hence, graphite suspensions in NMP, benzyl benzoate, and propylene glycol were exfoliated at various shear rates in a rheometer. Exfoliant concentrations were measured by ultraviolet- visual (UV-vis) spectroscopy and quality characterization was performed by Raman spectroscopy and scanning electron microscopy (SEM). Graphite exfoliation in the more viscous propylene glycol solvent resulted in a higher exfoliant concentration than in the less viscous NMP and benzyl benzoate solvents across all shear rates. Benzyl benzoate lowered exfoliant levels, likely due to a poor surface energy match, resulting in particle attraction and aggregation. Characterization showed that at least some of our material is few-layer graphene.

Keywords

2D materialscolloidgraphene
Type
Articles
Information
MRS Advances , Volume 4 , Issue 3-4: Nanomaterials , 2019 , pp. 241 - 247
Copyright
Copyright © Materials Research Society 2019 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

References:

Geim, A. K. and Novoselov, K. S., “The rise of graphene,” Nat. Mater. , vol. 6, no. 3, pp. 183-191, Mar. 2007.Google Scholar
Lee, C., Wei, X., Kysar, J. W., and Hone, J., “Measurement of the Elastic Properties and Intrinsic Strength of Monolayer Graphene,” Science (80-. ) ., vol. 321, no. 5887, pp. 385-388, Jul. 2008.CrossRefGoogle ScholarPubMed
Perreault, F., Fonseca de Faria, A., and Elimelech, M., “Environmental applications of graphene- based nanomaterials,” Chem. Soc. Rev. , vol. 44, no. 16, pp. 5861-5896, 2015.CrossRefGoogle ScholarPubMed
Choi, W., Lahiri, I., Seelaboyina, R., and Kang, Y. S., “Synthesis of Graphene and Its Applications: A Review,” Crit. Rev. Solid State Mater. Sci. , vol. 35, no. 1, pp. 52-71, 2010.CrossRefGoogle Scholar
Aghigh, A., Alizadeh, V., Wong, H. Y., Islam, M. S., Amin, N., and Zaman, M., “Recent advances in utilization of graphene for filtration and desalination of water: A review,” Desalination , vol. 365, pp. 389-397, 2015.CrossRefGoogle Scholar
Unalan, I., Cerri, G., and Marcuzzo, E., “Nanocomposite films and coatings using inorganic nanobuilding blocks (NBB): current applications and future opportunities in the food packaging sector,” RSC Adv. , pp. 29393-29428, 2014.CrossRefGoogle Scholar
Khurana, I., Saxena, A., Bharti, , Khurana, J. M., and Rai, P. K., “Removal of Dyes Using Graphene-Based Composites: a Review,” Water, Air, SoilPollut. , vol. 228, no. 5, p. 180, 2017.CrossRefGoogle Scholar
Ferrari, A. C. et al. , “Science and technology roadmap for graphene, related two-dimensional crystals, and hybrid systems,” Nanoscale , vol. 7, no. 11, pp. 4598-4810, 2014.CrossRefGoogle Scholar
Yi, M. and Shen, Z., “A review on mechanical exfoliation for the scalable production of graphene,” J. Mater. Chem. A , vol. 3, no. 22, pp. 11700-11715, 2015.CrossRefGoogle Scholar
Arao, Y., Mizuno, Y., Araki, K., and Kubouchi, M., “Mass production of high-aspect-ratio few- layer-graphene by high-speed laminar flow,” Carbon N. Y. , vol. 102, pp. 330-338, 2016.CrossRefGoogle Scholar
Johnson, D. W., Dobson, B. P., and Coleman, K. S., “A manufacturing perspective on graphene dispersions,” Curr. Opin. Colloid Interface Sci. , vol. 20, no. 5-6, pp. 367-382, 2015.CrossRefGoogle Scholar
Bracamonte, M. V., Lacconi, G. I., Urreta, S. E., and Foa Torres, L. E. F., “On the Nature of Defects in Liquid-Phase Exfoliated Graphene,” J. Phys. Chem. C , vol. 118, no. 28, pp. 15455-15459, Jul. 2014.CrossRefGoogle Scholar
Paton, K. R. et al. , “Scalable production of large quantities of defect-free few-layer graphene by shear exfoliation in liquids,” Nat. Mater. , vol. 13, no. June, pp. 624-630, 2014.Google Scholar
Varrla, E. et al. , “Turbulence-assisted shear exfoliation of graphene using household detergent and a kitchen blender,” Nanoscale , vol. 6, no. 20, pp. 11810-11819, Aug. 2014.CrossRefGoogle Scholar
Yi, M. and Shen, Z., “Kitchen blender for producing high-quality few-layer graphene,” Carbon N. Y. , vol. 78, no. July, pp. 622-626, Nov. 2014.Google Scholar
Lyklema, J., “The surface tension of pure liquids: Thermodynamic components and corresponding states,” Colloids Surfaces A Physicochem. Eng. Asp. , vol. 156, no. 1-3, pp. 413-421, Oct. 1999.CrossRefGoogle Scholar
Hernandez, Y. et al. , “High-yield production of graphene by liquid-phase exfoliation of graphite,” Nat. Nanotechnol. , vol. 3, no. 9, pp. 563-568, Sep. 2008.CrossRefGoogle ScholarPubMed
Hernandez, Y., Lotya, M., Rickard, D., Bergin, S. D., and Coleman, J. N., “Measurement of Multicomponent Solubility Parameters for Graphene Facilitates Solvent Discovery,” Langmuir , vol. 26, no. 5, pp. 3208-3213, Mar. 2010.CrossRefGoogle ScholarPubMed
Shen, J. et al. , “Liquid Phase Exfoliation of Two-Dimensional Materials by Directly Probing and Matching Surface Tension Components,” Nano Lett. , vol. 15, no. 8, pp. 5449-5454, Aug. 2015.CrossRefGoogle ScholarPubMed
Zhang, B. et al. , “Stable dispersions of reduced graphene oxide in ionic liquids,” J. Mater. Chem. , vol. 20, no. 26, p. 5401, 2010.CrossRefGoogle Scholar
Naficy, S. et al. , “Graphene oxide dispersions: tuning rheology to enable fabrication,” Mater. Horizons , vol. 1, no. 3, p. 326, 2014.CrossRefGoogle Scholar
Barwich, S., Coleman, J. N., and Möbius, M. E., “Yielding and flow of highly concentrated, few- layer graphene suspensions,” Soft Matter , vol. 11, no. 16, pp. 3159-3164, 2015.CrossRefGoogle ScholarPubMed
Dong, L. et al. , “A non-dispersion strategy for large-scale production of ultra-high concentration graphene slurries in water,” Nat. Commun. , vol. 9, no. 1, pp. 1-8, 2018.CrossRefGoogle ScholarPubMed
Rumble, J., John, R., Bruno, T. J., Martinsen, D., and Lide, D. R., Eds., “Viscosity of Liquids as a Function of Temperature,” in CRC Handbook of Chemistry and Physics , 99th ed., CRC Press, 2018.Google Scholar
Henni, A., Hromek, J. J., Tontiwachwuthikul, P., and Chakma, A., “Volumetric Properties and Viscosities for Aqueous N -Methyl-2-pyrrolidone Solutions from 25 °C to 70 °C,” J. Chem. Eng. Data , vol. 49, no. 2, pp. 231-234, Mar. 2004.CrossRefGoogle Scholar
Yaws, C. L. and Richmond, P. C., “Surface tension—Organic compounds,” in Thermophysical Properties of Chemicals and Hydrocarbons, Elsevier, 2009, pp. 686-781.Google Scholar
Rumble, J., John, R., Bruno, T. J., Martinsen, D., and Lide, D. R., Eds., “Surface Tension of Common Liquids,” in CRC Handbook of Chemistry and Physics , 99th ed., CRC Press, 2018.Google Scholar
Israelachvili, J., “Interactions Involving the Polarization of Molecules,” in Intermolecular and Surface Forces , 2nd ed., London: Academic Press, 1992, pp. 67-82.Google Scholar
Hamilton, C. E., Lomeda, J. R., Sun, Z., Tour, J. M., and Barron, A. R., “High-Yield Organic Dispersions of Unfunctionalized Graphene,” Nano Lett. , vol. 9, no. 10, pp. 3460-3462, Oct. 2009.CrossRefGoogle ScholarPubMed
Paton, K. R. et al. , “Scalable production of large quantities of defect-free few-layer graphene by shear exfoliation in liquids,” Nat. Mater. , vol. 13, no. 6, pp. 624-630, Apr. 2014.CrossRefGoogle Scholar
Seiler, H., “Secondary electron emission in the scanning electron microscope,” J. Appl. Phys. , vol. 54, no. 11, pp. R1-R18, Nov. 1983.CrossRefGoogle Scholar