Hostname: page-component-848d4c4894-pjpqr Total loading time: 0 Render date: 2024-07-08T00:21:18.820Z Has data issue: false hasContentIssue false
  • English
  • Français

High-resolution imaging of biotite dissolution and measurement of activation energy

Published online by Cambridge University Press:  05 July 2018

T. J. McMaster ,
M. M. Smits ,
S. J. Haward ,
J. R. Leake ,
S. Banwart  and
K. V. Ragnarsdottir
T. J. McMaster*
Affiliation:
H.H. Wills Physics Laboratory, University of Bristol, Bristol BS8 1TL, UK
M. M. Smits
Affiliation:
Department of Animal and Plant Sciences, Alfred Denny Building, University of Sheffield, Western Bank, Sheffield S10 2TN, UK
S. J. Haward
Affiliation:
H.H. Wills Physics Laboratory, University of Bristol, Bristol BS8 1TL, UK Department of Earth Sciences, University of Bristol, Wills Memorial Building, Queen’s Road, Bristol BS8 1RJ, UK
J. R. Leake
Affiliation:
Department of Animal and Plant Sciences, Alfred Denny Building, University of Sheffield, Western Bank, Sheffield S10 2TN, UK
S. Banwart
Affiliation:
Department of Civil and Structural Engineering, Kroto Research Institute, North Campus, University of Sheffield, Broad Lane, Sheffield S3 7HQ, UK
K. V. Ragnarsdottir
Affiliation:
Department of Earth Sciences, University of Bristol, Wills Memorial Building, Queen’s Road, Bristol BS8 1RJ, UK
*
*E-mail: [email protected]
Get access Rights & Permissions [Opens in a new window]

Abstract

We have used a direct imaging technique, in situ atomic force microscopy(AFM) to observe the earliest stages of the dissolution of a biotite surface byoxalic acid at temperatures close to ambient conditions, using a speciallydesigned AFM liquid cell and non-invasive intermittent contact mode of operation. From the nm-resolution data sets in x, yand z dimensions, we have measured dissolution rates and determined activation energies for the process as a function of temperature, via a mass-loss calculation. The value of Ea obtained, 49±2 kJ mol-1, appears to be too high to indicate a diffusion-controlled process and is more in line with expectations based on a process limited by the rate of ligand-induced metal cation detachment from the (001) surface. This is consistent with visual observations of the relative rates of etch-pit formation and growth, and accepted knowledge of the biotite crystal structure. Separate calculations based on planar area etch-pit growth, and measurements of etch-pit perimeters confirm this result, and also indicate substantiallyhigher activation energy, up to 80 kJ mol-1, when the edge pits are in an incipient stage.

Type
Research Article
Information
Mineralogical Magazine , Volume 72 , Issue 1 , February 2008 , pp. 115 - 120
Copyright
Copyright © The Mineralogical Society of Great Britain and Ireland 2008

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

Dove, P.M. and Platt, F.M. (1996) Compatible real-time rates of mineral dissolution by Atomic Force Microscopy (AFM). Chemical Geology, 12, 331–338.Google Scholar
Jordan, G. and Rammensee, W. (1996) Dissolution rates and activation energy for dissolution of brucite (001): A new method based on the mierotopography of crystal surfaces. Geochimical et Cosmochimica Ada, 60, 5055–5062.Google Scholar
Kalinowski, B.E. and Schweda, P. (1996) Kinetics of muscovite, phlogopite, and biotite dissolution and alteration at pH 1–4, room temperature. Geochimica et Cosmochimica Ada, 60, 367–385.CrossRefGoogle Scholar
Malmstrom, M. and Banwart, S.A. (1997) Biotite dissolution at 25 degrees C: The pH dependence of dissolution rate and stoichiometry. Geochimica et Cosmochimica Ada, 61, 2779–2799.CrossRefGoogle Scholar
Maurice, P.A., McKnight, D.M., Leff, L., Fulghum, J.E. and Gooseff, M. (2002) Direct observations of alumino silicate weathering in the hyporheic zone of an Antarctic Dry Valley stream. Geochimica et Cosmochimica Ada, 66, 1335–1347.CrossRefGoogle Scholar
White, A.F., Blum, A.E., Bullen, T.D., Vivit, D.V., Schulz, M. and Fitzpatrick, J. (1999) The effect of temperature on experimental and natural chemical weathering rates of granitoid rocks. Geochimica et Cosmochimica Ada, 63, 3277–3291.CrossRefGoogle Scholar