Hostname: page-component-cd9895bd7-jkksz Total loading time: 0 Render date: 2024-12-24T13:06:26.792Z Has data issue: false hasContentIssue false
  • English
  • Français

Experimental investigation on the effect of the switchingfrequency on the performance of a thermal wave adsorption heat pump

Published online by Cambridge University Press:  04 December 2013

Mostafa Gad El-Rab ,
Mahmoud Khaled ,
Belal Dawoud  and
Emad Amer
Mostafa Gad El-Rab
Affiliation:
Energy and Thermo-Fluids Group ETF, School of Engineering, Lebanese International University LIU, 146404 Mazraa, Beirut, Lebanon Mechanical Power Engineering Department, Faculty of Engineering, El-Menoufiya University, Shebin El-Kom, Egypt
Mahmoud Khaled*
Affiliation:
Energy and Thermo-Fluids Group ETF, School of Engineering, Lebanese International University LIU, 146404 Mazraa, Beirut, Lebanon
Belal Dawoud
Affiliation:
R&D New Technologies, Viessmann Werke GmbH & Co KG, 35107 Allendorf/Eder, Germany
Emad Amer
Affiliation:
Mechanical Power Engineering Department, Faculty of Engineering, El-Menoufiya University, Shebin El-Kom, Egypt
*
a Corresponding author: [email protected]
Get access

Abstract

In this paper, a two modular zeolite water adsorption heat pump (AHP) based on thethermal wave concept has been experimentally investigated. Each module composes of twoheat exchangers contained in a hermetic stainless steel vessel. The first heat exchangeris the adsorber/desorber located on the top of the vessel, while the second is theevaporator/condenser heat exchanger located on the bottom of the vessel. Throughout thiswork, the effect of the non-dimensional switching frequency, which has been introduced andtheoretically investigated by Alam et al. [Int. J. Heat Mass Transfer 43 (2000)4419–4431], on COP and the mean heating power of an adsorption heat pump has beenexperimentally investigated under one typical working condition of AHPs. The resultsshowed that the switching frequency and adsorber/desorber flow rate have strong influenceson both COP and the mean heating power. It has been also found that there is an optimumswitching frequency corresponding to each flow rate, at which the COP attains its maximumvalue. The obtained optimum switching frequencies vary slightly from 0.28 at an adsorberfluid flow rate of 0.6 l.min-1 to 0.32 at 1 l.min-1.

Keywords

Adsorptionheat pumpzeolite-waterswitching frequencythermal wave
Type
Research Article
Information
Mechanics & Industry , Volume 14 , Issue 5 , 2013 , pp. 383 - 387
Copyright
© AFM, EDP Sciences 2013

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

Alam, K.C.A., Saha, B.B., Kang, Y.T., Akisawa, A., Kashiwagi, T., Heat exchanger design effect on the system performance of silica gel–water adsorption system, Int. J. Heat Mass Transfer 43 (2000) 4419–4431 CrossRefGoogle Scholar
Meunier, F., Theoretical performances of solid adsorbent cascading cycles using the zeolite-water and active carbon-methanol Paris: four case studies, J. Heat Recovery Systems 6 (1986) 491–498 CrossRefGoogle Scholar
Douss, N., Meunier, F., Experimental study of cascading adsorption cycles, Chem. Eng. Sci. 44 (1989) 225–235 CrossRefGoogle Scholar
D.I. Tchernev, D. Emerson, Closed Cycle Regenerative Heat Pump, 2nd International Workshop on Research Activities on Advanced Heat Pumps, Graz, 1988
Amar, N.B., Sun, L.M., Meunier, F., Numerical analysis of adsorptive temperature wave regenerative heat pump, Appl. Thermal Eng. 6 (1996) 405–418 CrossRefGoogle Scholar
Haji, A., Worek, W.M., Simulation of a regenerative closed-cycle adsorption cooling/heating system, Energy 16 (1991) 643–654 CrossRefGoogle Scholar
Zheng, W., Worek, W.M., Nowakowski, G., Performance optimization of two-bed closed cycle solid-adsorption heat pump systems, Heat Mass Transfer 31 (1995) 1–9 CrossRefGoogle Scholar
Zheng, W., Worek, W.M., Nowakowski, G., Effect of operating conditions on the performance of two-bed closed cycle solid-sorption heat pump systems, ASME Trans. – J. Solar Energ. Eng. 117 (1995) 181–186 CrossRefGoogle Scholar
Voyiatzis, E., Palyvos, A.J., Markatos, N., Heat-exchanger design and switching-frequency effects on the performance of a continuous type solar adsorption chiller, Applied Energy 85 (2008) 1237–1250 CrossRefGoogle Scholar
R. Lang, B. Dawoud, T. Miltkau, M. Stricker, A Sorption Heat Pump Module, European Patent, EP 1178269 B1, 2003, pp. 1–12
T. Hocker, R. Lang, F. Marth, U. Marx, R. Prescha, J. Wienen, B. Dawoud, R. Gasper, T. Miltkau, M. Stricker, A Method of Operating an Adsorption Heat Pump, European Patent, EP 1245910 B1, 2003, pp. 1–26