Published online by Cambridge University Press: 13 December 2011
The hot spot heating process by an assumed deuteron beam is evaluated in order to estimate the contribution of the energy produced by the deuteron beam-target fusion to the heating process. The deuteron beam energy versus the number of deuterons is evaluated through the experimentally achieved proton beam energy distribution using the TRIDENT short pulse laser at the Los Alamos National Laboratory (LANL). The corresponding hot spot heating is then calculated using this assumed deuteron beam spectrum. The resulting first order heating dynamics is employed in the expanded “bonus” energy calculation, and a 12.73% extra energy from deuteron beam-target fusion was found with the assumed deuteron spectrum when ρrb = 4.5 g/cm2 is considered, where ρ is the fuel density, and rb is the ion beam focusing radius on the target. The results provide further insight into the contribution of the extra heat produced by deuteron beam-target fusion to the hot spot ignition process. A further analysis of how a converter foil using ultra-high-density cluster materials can help to achieve the yield requirements for ignition is presented.