Hostname: page-component-78c5997874-dh8gc Total loading time: 0 Render date: 2024-11-17T04:20:19.332Z Has data issue: false hasContentIssue false

Direct-indirect mixture implosion in heavy ion fusion

Published online by Cambridge University Press:  21 September 2006

TETSUO SOMEYA
Affiliation:
Department of Energy and Environmental Science, Graduate School of Engineering, Utsunomiya University, Utsunomiya, Japan
KENTAROU MIYAZAWA
Affiliation:
Department of Energy and Environmental Science, Graduate School of Engineering, Utsunomiya University, Utsunomiya, Japan
TAKASHI KIKUCHI
Affiliation:
Department of Energy and Environmental Science, Graduate School of Engineering, Utsunomiya University, Utsunomiya, Japan
SHIGEO KAWATA
Affiliation:
Department of Energy and Environmental Science, Graduate School of Engineering, Utsunomiya University, Utsunomiya, Japan

Abstract

In order to realize an effective implosion, the beam illumination non-uniformity and implosion non-uniformity must be suppressed to less than a few percent. In this paper, a direct-indirect mixture implosion mode is proposed and discussed in heavy ion beam (HIB) inertial confinement fusion (HIF) in order to release sufficient fusion energy in a robust manner. On the other hand, the HIB illumination non-uniformity depends strongly on a target displacement (dz) in a reactor. In a direct-driven implosion mode dz of ∼20 μm was tolerance and in an indirect-implosion mode dz of ∼100 μm was allowable. In the direct-indirect mixture mode target, a low-density foam layer is inserted, and radiation is confined in the foam layer. In the foam layer the radiation transport is expected in the lateral direction for the HIB illumination non-uniformity smoothing. Two-dimensional implosion simulations are performed and show that the HIB illumination non-uniformity is well smoothed. The simulation results present that a large pellet displacement of ∼300 μm is tolerable in order to obtain sufficient fusion energy in HIF.

Type
Research Article
Copyright
© 2006 Cambridge University Press

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

Barnard, J.J., Ahle, L.E., Bieniosek, F.M., Celata, C.M., Davidson, R.C., Henestroze, E., Friedman, A., Kwan, J.W., Logan, B.G., Lee, E.P., Lund, S.M., Meier, W.R., Sabbi, G.-L., Seidl, P.A., Sharp, W.M., Shuman, D.B., Waldron, W.L., Qin, H. & Yu, S.S. (2003). Integrated experiments for heavy ion fusion. Laser Part. Beams 21, 553560.
Basko, M.M. (1993). Simple spherical D-T targets for heavy-ion beam fusion. Laser Part. Beams 11, 733750.
Bell, A.R. (1981). New equations of state for MEDUSA. Rutherford Lab. Report. RL-80-091.
Callahan, D.A. (1995). Interaction between neighboring beams in heavy ion fusion reactor chamber. Appl. Phys. Lett. 67, 32543256.
Callahan, D.A., Herrmann, M.C. & Tabak, M. (2002). Progress in heavy ion target capsule and hohlraum design. Laser Part. Beams 20, 405410.
Davidson, R.C., Kaganovich, I.D., Lee, W.W., Qin, H., Startsev, E.A., Tzenov, S., Friedman, A., Barnard, J.J., Cohen, R.H., Grote, D.P., Lund, S.M., Sharp, W.M., Celata, C.M., De Hoon, M., Henestroza, E., Lee, E.P., Yu, S.S., Vay, J.-L., Welch, D.R., Rose, D.V. & Olson, C.L. (2002). Overview of theory and modeling in the heavy ion fusion virtual national laboratory. Laser Part. Beams 20, 377384.
Emery, M.H., Orens, J.H., Gardner, J.H. & Boris, J.P. (1982). Influence of nonuniform laser intensities on ablatively accelerated targets. Phys. Rev. Lett. 48, 253256.
Emery, M.H., Gardner, J.H., Lehmberg, R.H. & Obenschain, S.P. (1991). Hydrodynamic target response to an induced spatial incoherence-smoothed laser beam. Phys. Fluids B 3, 26402651.
Goodin, D.T., Alexander, N.B., Gibson, C.R., Nobile, A., Petzoldt, R.W., Siegel, N.P. & Thompson, L. (2001). Developing target injection and tracking for inertial fusion energy power plants. Nucl. Fus. 41, 527535.
Hogan, W.J., Bangerter, R. & Kulcinski, G.L. (1992). Energy from inertial fusion. Phys. Today 45, 4250.
Kawata, S. Someya, T., Nakamura, T., Miyazaki, S., Shimizu, K., &Ogoyski, A.I. (2002). Heavy ion beam final transport through an insulator guide in heavy ion fusion. Laser Part. Beams 21, 2732.
Kikuchi, T., Someya, T. & Kawata, S. (2005). Beam pulse duration dependence on target implosion in heavy ion fusion. IEE. Jpn. 125, 515520.
Lindl, J.D., Morory, R.W. & Campbell, M. (1992). Progress toward ignition and burn propagation in inertial confinement fusion. Phys. Today 45, 3240.
Ogoyski, A.I., Someya, T. & Kawata, S. (2004). Code OK1—Simulation of multi-beam irradiation on a spherical target in heavy ion fusion. Comp. Phys. Comm. 157, 160172.
Petzoldt, P.W., Alexander, N.B., Drake, T.J., Goodin, D.T., Jonestrask, K. & Stemke, R.W. (2003). Experimental target injection and tracking system. Fusion Sci. Tech. 44, 138141.
Qin, H., Davidson, R.C., Lee, W.W. & Kolesnikov, R. (2001). 3D multispecies nonlinear perturbative particle simulations of collective processes in intense particle beams for heavy ion fusion. Nucl. Instr. Meth. Phys. Res. A464, 477483.
Someya, T., Ogoyski, A.I., Kawata, S. & Sasaki, T. (2004). Heavy-ion beam illumination on a direct-driven pellet in heavy-ion inertial fusion. Phys. Rev. ST-AB 7, 044701.
Tabak, M. & Miller, D.C. (1998). Design of a distributed radiator target for inertial fusion driven from two sides with heavy ion beams. Phys. Plasmas 5, 18951900.
Turner, N.J. & Stone, J.M. (2001). A module for radiation hydrodynamics calculations with ZEUS-2D using flux-limited diffusion. The Astrophys. J. Supp. 135, 95107.
Welch, D.R., Rose, D.V., Oliver, B.V., Genoni, T.C. & Clark, R.E. (2002). Simulation of intense heavy ion beams propagating through a gaseous fusion target chamber. Phys. Plasmas 9, 23442353.
Xiao, F. (2001). Implementations of multi-fluid hydrodynamic simulations on distributed memory computer with a fully parallelizable preconditioned Bi-CGSTAB method. Comp. Phys. Comm. 137, 274285.