Hostname: page-component-cd9895bd7-gxg78 Total loading time: 0 Render date: 2024-12-27T14:36:11.868Z Has data issue: false hasContentIssue false
  • English
  • Français

Effects of diode current on high power microwave generation in a vircator

Published online by Cambridge University Press:  15 April 2009

GUOZHI LIU ,
WENHUA HUANG ,
HAO SHAO ,
SHI QIU ,
HONGJUN WANG ,
JINGYUE LIU ,
FENG WANG ,
ZHANFENG YANG  and
YONGZHI QIAO
GUOZHI LIU
Affiliation:
([email protected])
WENHUA HUANG
Affiliation:
([email protected])
HAO SHAO
Affiliation:
([email protected])
SHI QIU
Affiliation:
([email protected])
HONGJUN WANG
Affiliation:
([email protected])
JINGYUE LIU
Affiliation:
([email protected])
FENG WANG
Affiliation:
([email protected])
ZHANFENG YANG
Affiliation:
([email protected])
YONGZHI QIAO
Affiliation:
([email protected])
Get access Rights & Permissions [Opens in a new window]

Abstract

An experiment of a virtual cathode oscillator (vircator) built on the low impedance intense electron beam accelerator Flash II is reported. A novel spectrum diagnosis method—a circulating dispersion line—is proposed. A thin oil layer coated graphite cathode is introduced in the experiment to decrease the delay time of the explosive emission process and obtain a homogeneous electron beam emission for improving the high-power microwave (HPM) generation efficiency. The effect of diode current on HPM generation in the vircator system is discussed. The HPM pulse width has a strong connection with the diode current waveform. For most shots, corresponding to the time that microwave emission starts, there is an inflection point in the diode current pulse. Compared with the case that no microwave is generated, the diode current increases more slowly following the inflection point. HPM generation terminates when the beam current reaches the self-pinching critical current of the diode.

Type
Papers
Information
Journal of Plasma Physics , Volume 75 , Issue 6 , December 2009 , pp. 787 - 798
Copyright
Copyright © Cambridge University Press 2009

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

[1]Guozhi, L. et al. 2006. Recent researches on coaxial vircator in NINT. In: Proc. 1st Euro–Asia Pulse Power Conf., Chengdu, pp. 538–544.Google Scholar
[2]Jiang, W., Woolverton, K., Diclens, J. and Kristiansen, M. 2001. Effect of electron-beam pulse length on microwave efficiency of coaxial vircator. In: IEEE Proc. Pulsed Power & Plasma Science 2001 (PPPS 2001). Dig. Tech. Papers, Vol. 2 (6), pp. 1646–1648.Google Scholar
[3]Kitsanov, S. A. et al. 2002. A vircator with electron beam premodulation based on high-current repetitively pulsed accelerator. IEEE Trans. Plasma Sci. 30 (1), 274–285.CrossRefGoogle Scholar
[4]Jeon, W. et al. 2005. A diode design study of the virtual cathode oscillator with a ring-type reflector. IEEE Trans. Plasma Sci. 33 (6), 2011–2016.CrossRefGoogle Scholar
[5]Liu, G. Z., Huang, W. H. and Wang, H. J. 1999. A ring of waveguide dispersive line for single short pulse microwave frequency analysis. High Power Laser Part. Beams 11 (2), 234–238 (in Chinese).Google Scholar
[6]Liu, G. Z. 2004. Physics of field-induced explosive emitting cathode. Test Res. 27 (3), 1–4.Google Scholar
[7]Liu, G. Z., Sun, J., Shao, H. and Yang, Z. F. 2005. Experimental study on effective emitting area of explosive emitting cathode. High Power Laser Part. Beams 17 (2), 249–252 (in Chinese).Google Scholar
[8]Changhua, C., Guozhi, L. and Wenhua, H. 2008. Advances in relativistic BWO operating repetitively. In: Proc. BEAMS'2008, Xi'an, China, July 2008.Google Scholar
[9]Woo, W.-Y. 1987. Two-dimensional features of virtual cathode and microwave emission. Phys. Fluids 30 (1), 239–244.CrossRefGoogle Scholar
[10]Chen, X., Lindsay, P. A. and Zhang, J. 2000. Chaos and oscillations in a loaded plasma-filled diode. IEEE Trans. Plasma Sci. 28 (3), 462–471.Google Scholar