Hostname: page-component-586b7cd67f-tf8b9 Total loading time: 0 Render date: 2024-11-23T09:08:46.090Z Has data issue: false hasContentIssue false

Failure Modes and Models for Integrated GPS/INS Systems

Published online by Cambridge University Press:  20 April 2007

Umar Iqbal Bhatti
Affiliation:
(Imperial College London)
Washington Yotto Ochieng*
Affiliation:
(Imperial College London)
*

Abstract

GPS is the most widely used global navigation satellite system. By design, there is no provision for real time integrity information within the Standard Positioning Service (SPS). However, in safety critical sectors like aviation, stringent integrity performance requirements must be met. This can be achieved externally or at the receiver level through receiver autonomous integrity monitoring (RAIM). The latter is a cost effective method that relies on data consistency, and therefore requires redundant measurements. An external aid to provide this redundancy can be in the form of an Inertial Navigation System (INS). This should enable continued performance even during RAIM holes (when no redundant satellite measurements are available). However, due to the inclusion of an additional system and the coupling mechanism, integrity issues become more challenging. To develop an effective integrity monitoring capability, a good understanding of the potential failure modes of the integrated system is vital. In this paper potential failure modes of integrated GPS/INS systems are identified. This is followed by the specification of corresponding models that would be required to investigate the capability of existing integrity algorithms and to develop enhancements or new algorithms.

Type
Research Article
Copyright
Copyright © The Royal Institute of Navigation 2007

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

Babu, RW. (2004). Improving the Quality of IMU-Derived Doppler Estimates for Ultra-Tight GPS/INS Integration. In: Proceedings of the ENC, Rotterdam, Netherlands, paper 144, pp 18.Google Scholar
BAE Systems (2006). Inertial products data sheets. http://www.baesystems-ps.com/Google Scholar
Baker, BC., Huser, SJ (1998). Protect Yourself! Navigation Payload Anomalies and the Importance of Adhering to ICD-GPS-200. In: Proceedings of the Technical Meeting of the Satellite Division of the Institute of Navigation, Tennessee, USA.Google Scholar
Brown, SB., Jansen, E (1996). Reliability and Long Term Stability of MEMS. In: Advanced Applications of Lasers in Materials Processing, IEEE, Colorado, USA.Google Scholar
Bruner, CP (2000). LN-200G first SAASM based tactical grade INS/GPS Navigator. In: Proceedings of the Technical meeting of the Satellite Division of the Institute of, Salt Lake city, Utah, USA.Google Scholar
Chiang, K-W (2003). The utilization of single point positioning and a multi-layers feed-forward network for INS/GPS Integration. In: Proceedings of the Technical meeting of the Satellite Division of the Institute of Navigation, Portland, Oregon, USA.Google Scholar
Cellere, G (2006). Personal Comm. Dept of Information Engineering, University of Padova, Italy.Google Scholar
Cox, DB (1998). Integration of GPS with Inertial Navigation Systems. Global Positioning Systems and its Augmentations, I:pages 144153.Google Scholar
Eck, C., Kottmann, M., Geering, HP (2003). Analysis of GPS measurement delays in low-cost INS/GPS navigation systems. In: ION GPS/GNSS 2003, Portland, Oregon, USA.Google Scholar
Farrell, JL (1976). Integrated Aircraft Navigation. Academic Press Inc., San Diego, California.Google Scholar
Farrell, JL., Barth, M (1998). The GPS and Inertial Navigation. Mc-Graw-Hill, New York.Google Scholar
Faucheux, M., Fayoux, D., Roland, JJ (1988). The Ring Laser Gyro, J. Otpics, 19(3):pages 101115.Google Scholar
Gautier, J (2003) GPS/INS generalized evaluation tool for the design and testing of integrated navigation systems. PhD Thesis, Stanford University, USA.Google Scholar
Ghaffarian, RJ., Sutton, DG., Chafee, P., Marquez, N., Sharma, A., Teverovsky, A (2002). Thermal and Mechanical Reliability of Five LOTS MEMS Accelerometers. White paper. NASA Electronics Parts and Packaging Program, USA.Google Scholar
Gibbons, G (2002). Is the Sky Falling? GPS World.Google Scholar
Gold, KL., Brown, AK (2004). A Hybrid Integrity solution for Precision Landing and Guidance. In: Proceedings of IEEE PLANS, IEEE, California, USA, pp 165174.CrossRefGoogle Scholar
Groves, PD., Wilson, GG., Mather, CJ (2002). Robust rapid transfer alignment with an INS/GPS reference. In: Proceedings of the National Technical Meeting, ION, San Diego, pp 301311.Google Scholar
Gustafson, D., Dowdle, J (2003). Deeply integrated code tracking: comparative performance analysis. In: Proceedings of ION GPS/GNSS 2003, Portland, Oregon, pp 25532561.Google Scholar
He, XF., Vk, B (1999). Use of extended interval Kalman filter on integtrated GPS/INS system. In: Proceedings of the Technical meeting of the Satellite Division of the Institute of Navigation, Nashville.Google Scholar
Hong, S., Zhang, YS., Ha, S-K., Lee, M-H (2002). Estimation of Alignment errors in GPS/INS integration. In: Proceedings of the ION GPS 2002, Portland, Oregan, USA.Google Scholar
Hong, S., Lee, MH., Chun, H-H., Kwon, S-H., Speyer, JL (2005). Observability of Error States in GPS/INS Integration. IEEE Transactions on Vehicular Technology, 54(2), 731743.CrossRefGoogle Scholar
ICAO (2004). Annex 10: International Standards and Recommended Practices. Aeronautical Telecommunications, Volume 1.Google Scholar
Hwang, D-H., Kim, YS., Oh, SH., Lee, SJ (2000). Performance Improvement of the Attitude GPS Aided SDINS Alignment. In: Proceedings of the 13th International Technical meeting of the Satellite Division of the Institute of Navigation, Salt Lake City, Utah, USA.Google Scholar
Hwang, PY., Brown, RG (2005). NIORAIM Integrity Monitoring Performance In Simultaneous Two-Fault Satellite Scenarios. In: ION GNSS 2005, Institute of Navigation, San Diego, California, USA.Google Scholar
Jwo, D-J., Tuckness, DG (1996). On the Stability Investigation of Integrated GPS/INS navigation systems. In: Proceedings of the 9th International Technical meeting of the Satellite Division of the Institute of Navigation, Kansas City, Missouri, USA.Google Scholar
Kim, H-S., Bu, S-C., Jee, G-I., Gook, C., Park, (2003). An ultra-tightly coupled GPS/INS integration using federated Kalman filter. In: Proceedings of ION GPS/GNSS 2003, Portland, Oregon, USA.Google Scholar
Klotz, HA., Reynolds, AHI (2000). Evaluating Anti-Jam GPS/INS System Performance. In: Proceedings of the National Technical Meeting, Institute of Navigation, Anaheim, California, USA.Google Scholar
Knudson, AR., Buchner, S., McDonald, P., Stapor, WJ., Campbell, AB., Rabowski, KS., Knies, DL (1996). The Effects of Radiation on MEMS Accelerometers. IEEE Transactions on Nuclear Science, 43(6):pages 31223126.CrossRefGoogle Scholar
Lee, YC., Ericson, SD (2004). Analysis of Coast Times Upon Loss of GPS Signals for Integrated GPS/Inertial Systems. Air Traffic Control Quarterly, 12(1), 2751.CrossRefGoogle Scholar
Lee, S-K., Lee, C-W (1997). Errors of the dynamically tuned strapdown gyroscope to constant and harmonic rate inputs. In: Proceedings of Institute of Mechanical Engineers, 21(C):pages 627637.Google Scholar
Ledroz, AG., Pecht, E., Cramer, D., Mintchev, MP (2005). FOG-Based Navigation in Downhold Environment During Horizontal Drilling Utilizing a Complete Inertial Measurement Unit: Directional Measurement-While-Drilling Surveying. IEEE Transactions on Instrumentation and Measurement, 54(5):pages 19972006.CrossRefGoogle Scholar
Lopes, RVF., Milani, PG (2000). Consistent On-board Multipath calibration for GPS based spacecraft Attitude Determination. In: Proceedings of the 13th International Technical meeting, Institute of Navigation, Salt Lake city, Utah, USA.Google Scholar
Madni, AM., Costlow, LE (2001). A third generation, Highly Monitored, Micromachined Quartz Rate Sensor for Safety-Critical vehicle stability control. In: IEEE Proceedings, Montana, USA.Google Scholar
Moler, C., Loan, CV (2003). Nineteen Dubious Ways to Compute the Exponential of a Matrix, Twenty Five Years Later. SIAM REVIEW, 45(1):pages 349.CrossRefGoogle Scholar
Moore, T., Rudolph, K., Ziolkowski, F., Luckau, A (1995). Use of the GPS Aided Inertial Navigation System in the Navy Standard Missile for the BMDO/Navy LEAP Technology Demonstration Program. In: Proceedings of the 8th International Technical Meeting, Institute of Navigation, Palm Springs, USA.Google Scholar
Pierce, D., Brusius, P (1997). Electromigration: A review. Microelectronics Reliability, 37(7):10531072.CrossRefGoogle Scholar
Ochieng, WY., Sauer, K., Walsh, D., Brodin, G., Griffin, S., Denney, M (2003). GPS integrity and potential impact on aviation safety. Journal of Navigation, 56(1), 5165.CrossRefGoogle Scholar
Rogers, RM (2001). Large Azimuth INS Error Models for In-Motion Alignment. In: Proceedings of the National Technical Meeting, Institute of Navigation, Long Beach, California, USA.Google Scholar
Royal Institute of Navigation (2005). GPS news archives. www.rin.org.uk.Google Scholar
Savage, PG (1999). Strapdown Inertial Navigation Integration Algorithm Design Part 1: Attitude Algorithms. Journal of Guidance, control and dynamics, 21(1).Google Scholar
Sharma, AK., Teverovsky, A (2000). Evaluation of Thermo-Mechanical Stability of COTS Dual-Axis MEMS Accelerometers for Space Applications. In: Proceedings of COTS MEMS conference, Knowledge Foundation, Berkley, California, USA.Google Scholar
Shooman, ML (1994). A study of occurrence rate of Electromagnetic Interference (EMI) to Aircraft without a focus on HIRF (External) High Intensity Radiation Fields. NASA CR 194895Google Scholar
Sparks, D., Chia, M., Zarabadi, S (2001). Reliability of Resonant Micromachined Sensors and Actuators. In: SAE World congress, Society of Automotive Engineers, International, Detroit, USA.Google Scholar
Spengen, WMV (2003). MEMS reliability from a failure mechanisms perspective. Microelectronics Reliability, 43(7):pages 10491060.CrossRefGoogle Scholar
Titterton, DH., Weston, JL (1997). Strapdown Inertial navigation technology. Peter Peregrinus Press.Google Scholar
US DoD (2001). GPS Standard Positioning Service Performance Standard.Google Scholar
Van Dyke, K, Kovach, K, Lavrakas, J, Carroll, B (2004) Status Update on GPS Integrity Failure Modes and Effect Analysis. In: Proceedings of ION 2004 National Technical Meeting, San Diego, USA.Google Scholar
Volpe Report (2001). Vulnerability Assessment of the Transportation Infrastructure relying on the Global Positioning System. John A. Volpe National Transportation Policy, August 29.Google Scholar
Wagner, JG., Kasties, G (2002). Improving the GPS/INS integrated system performance by increasing the distance between GPS antennas and inertial sensors. In: Proceedings of the National Technical Meeting “ Integrating Technology”, San Diego, California, USA.Google Scholar
Wagner, JF (2005). GNSS/INS integration: still an attractive candidate for automatic landing systems? GPS solutions, 9(3):pages 179193.CrossRefGoogle Scholar
White, E., Rios, JA (2002). FAA certification of a MEMS attitude and Heading Reference system. In: Proceedings of the National Technical Meeting, ION, San Diego.Google Scholar
Wu, A (1999). Investigation of the GPS Block IIR Time Keeping System (TKS) anomalies caused by the voltage-controlled crystal oscillator. In: 31st Annual PTTI Meeting, California, USA.Google Scholar
Wagner, JF., Wieneke, T (2003). Integrating satellite and inertial navigation – conventional and new fusion approaches. Control Engineering Practice, 11, 543550.CrossRefGoogle Scholar