Hostname: page-component-78c5997874-94fs2 Total loading time: 0 Render date: 2024-11-20T04:21:59.321Z Has data issue: false hasContentIssue false
  • English
  • Français

Thermal oxidation mechanism and stress evolution in Ta thin films

Published online by Cambridge University Press:  31 January 2011

Yusung Jin ,
Jae Yong Song ,
Soo-Hwan Jeong ,
Jeong Won Kim ,
Tae Geol Lee ,
Ju Hwang Kim  and
Junhee Hahn
Yusung Jin
Affiliation:
Department of Chemical Engineering, Kyungpook National University, Daegu 702-701, South Korea
Jae Yong Song*
Affiliation:
Division of Industrial Metrology, Korea Research Institute of Standards and Science, Daejeon 305-340, South Korea; and School of Science, University of Science and Technology, Daejeon 305-333, South Korea
Soo-Hwan Jeong*
Affiliation:
Department of Chemical Engineering, Kyungpook National University, Daegu 702-701, South Korea
Jeong Won Kim
Affiliation:
Division of Industrial Metrology, Korea Research Institute of Standards and Science, Daejeon 305-340, South Korea
Tae Geol Lee
Affiliation:
Division of Convergence Technology, Korea Research Institute of Standards and Science, Daejeon 305-340, South Korea
Junhee Hahn
Affiliation:
Division of Industrial Metrology, Korea Research Institute of Standards and Science, Daejeon 305-340, South Korea
*
a)Address all correspondence to this author. e-mail: [email protected]
b)Address all correspondence to this author. e-mail: [email protected]
Get access

Abstract

Oxidation-induced stress evolutions in Ta thin films were investigated using ex situ microstructure analyses and in situ wafer curvature measurements. It was revealed that Ta thin films are oxidized to a crystalline TaO2 layer, which is subsequently oxidized to an amorphous tantalum pentoxide (a-Ta2O5) layer. Initial layered oxidation from Ta to TaO2 phases abruptly induces high compressive stress up to about 3.5 GPa with fast diffusion of oxygen through the Ta layer. Subsequently, it is followed by stress relaxation with the oxidation time, which is related to the slow oxidation from TaO2 to Ta2O5 phases. The initial compressive stress originates from the molar volume expansion during the layered formation of TaO2 from the Ta layer, while the relaxation of the compressive stresses is ascribed to the amorphous character of the a-Ta2O5 layer. According to Kissinger's analysis of the stress evolution during an isochronic heating process, the oxygen diffusion process through the a-Ta2O5 layer is the rate-controlling stage in the layered oxidation process of forming a a-Ta2O5/TaO2/Ta multilayer and has an activation energy of about 190.8 kJ/mol.

Keywords

Thermal stressesTaOxidation
Type
Articles
Information
Journal of Materials Research , Volume 25 , Issue 6 , June 2010 , pp. 1080 - 1086
Copyright
Copyright © Materials Research Society 2010

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1.Holloway, K., Fryer, P.M.Tantalum as a diffusion barrier between copper and silicon. Appl. Phys. Lett. 57, 1736 (1990)CrossRefGoogle Scholar
2.Clevenger, L.A., Bojarczuk, N.A., Holloway, K., Harper, J.M.E., Cabral, C. Jr., Schad, R.G., Cardone, F., Stolt, L.Comparison of high vacuum and ultra-high-vacuum tantalum diffusion barrier performance against copper penetration. J. Appl. Phys. 73, 300 (1993)CrossRefGoogle Scholar
3.Duckworth, R.G.Tantalum thin film resistors. Thin Solid Films 10, 337 (1972)CrossRefGoogle Scholar
4.Schwartz, N., Reed, W.A., Polash, P., Read, M.H.Temperature coefficient of resistance of beta-tantalum films and mixtures with b.c.c.-tantalum. Thin Solid Films 14, 333 (1972)CrossRefGoogle Scholar
5.Gerstenberg, D., Calbick, C.J.Effects of nitrogen, methane, and oxygen on structure and electrical properties of thin tantalum films. J. Appl. Phys. 35, 402 (1964)CrossRefGoogle Scholar
6.Liu, L., Gong, H., Wang, Y., Wang, J., Wee, A.T.S., Liu, R.Annealing effects of tantalum thin films sputtered on [001] silicon substrate. Mater. Sci. Eng., C 16, 85 (2001)CrossRefGoogle Scholar
7.Knepper, R., Stevens, B., Baker, S.P.Effect of oxygen on the thermomechanical behavior of tantalum thin films during the β-α phase transformation. J. Appl. Phys. 100, 123508 (2006)CrossRefGoogle Scholar
8.French, B.L., Bilello, J.C.In situ observations of the real-time stress-evolution and delamination of thin Ta films on Si(100). Thin Solid Films 446, 91 (2004)CrossRefGoogle Scholar
9.Vermilyea, D.A.The oxidation of tantalum at 50–300 °C. Acta Metall. 6, 166 (1958)CrossRefGoogle Scholar
10.Kofstad, P.The oxidation behavior of tantalum at 700–1000 °C. J. Electrochem. Soc. 110, 491 (1963)CrossRefGoogle Scholar
11.Steidel, C.A., Gerstenberg, D.Thermal oxidation of sputtered tantalum thin films between 100 and 525 °C. J. Appl. Phys. 40, 3828 (1969)CrossRefGoogle Scholar
12.Sato, S., Inoue, T., Sasaki, H.Thermal oxidation of β-Ta below 500 °C. Thin Solid Films 86, 21 (1981)CrossRefGoogle Scholar
13.Chandrasekharan, R., Park, I., Masel, R.I., Shannon, M.A.Thermal oxidation of tantalum films at various oxidation states from 300 to 700 °C. J. Appl. Phys. 98, 114908 (2005)CrossRefGoogle Scholar
14.Cheng, M.H., Cheng, T.C., Huang, W.J., Chang, M.N., Chung, M.K.Influence of oxygen diffusion on residual stress for tantalum thin films. J. Vac. Sci. Technol., B 25, 147 (2007)CrossRefGoogle Scholar
15.Cabral, C., Clevenger, L.A. Jr., Schad, R.G.Repeated compressive stress increase with 400 °C thermal cycling in tantalum thin films due to increase in the oxygen content. J. Vac. Sci. Technol., B 12, 2818 (1994)CrossRefGoogle Scholar
16.Wuu, D-S., Chan, C-C., Horng, R-H., Lin, W-C., Chiu, S.L., Wu, Y.Y.Structural and electrical properties of Ta–Al thin films by magnetron sputtering. Appl. Surf. Sci. 144, 315 (1999)CrossRefGoogle Scholar
17.Clevenger, L.A., Mutscheller, A., Harper, J.M.E., Cabral, C. Jr., Barmak, K.The relationship between deposition conditions, the beta to alpha phase transformation, and stress relaxation in tantalum thin films. J. Appl. Phys. 72, 4918 (1992)CrossRefGoogle Scholar
18.Jongste, J.F., Alkemade, P.F.A., Janssen, G.C.A.M., Radelaar, S.Kinetics of the formation of C49 TiSi2 from Ti–Si multilayers as observed by in situ stress measurements. J. Appl. Phys. 74, 3869 (1993)CrossRefGoogle Scholar
19.Buaud, P.P., d'Heurle, F.M., Irene, E.A., Patnaik, B.K., Parikh, N.R.In situ strain measurements during the formation of platinum silicide films. J. Vac. Sci. Technol., B 9, 2536 (1991)CrossRefGoogle Scholar
20.Song, J.Y., Yu, J., Lee, T.Y.Analysis of phase transformation kinetics by intrinsic stress evolutions during the isothermal aging of amorphous Ni(P) and Sn/Ni(P) films. J. Mater. Res. 19, 1257 (2004)CrossRefGoogle Scholar
21.Park, I-M., Yang, T-Y., Jung, S.W., Kim, Y.K., Horii, H., Joo, Y-C.Investigation of crystallization behaviors of nitrogen-doped Ge2Sb2Te5 films by thermomechanical characteristics. Appl. Phys. Lett. 94, 061904 (2009)CrossRefGoogle Scholar
22.Zhang, S-L., d'Heurle, F.M.Stresses from solid state reactions: A simple model, silicides. Thin Solid Films 213, 34 (1992)CrossRefGoogle Scholar
23.Song, J.Y.Layered intermetallic compounds and stress evolution in Sn and Ni(P) films. J. Mater. Res. 22, 2025 (2007)CrossRefGoogle Scholar
24.Stoney, G.G.The tension of metallic films deposited by electrolysis. Proc. R. Soc. London, Ser. A 82, 172 (1909)Google Scholar
25.Weast, R.C.CRC Handbook of Chemistry and Physics: A Ready-Reference Book of Chemical and Physical Data (CRC Press, Boca Raton, FL 1989)D-187Google Scholar
26.Knepper, R., Baker, S.P.Coefficient of thermal expansion and biaxial elastic modulus of β phase tantalum thin films. Appl. Phys. Lett. 90, 181908 (2007)CrossRefGoogle Scholar
27.Witvrouw, A., Spaepen, F.Viscosity and elastic constants of amorphous Si and Ge. J. Appl. Phys. 74, 7154 (1993)CrossRefGoogle Scholar
28.Samsonov, G.V.The Oxide Handbook (IFI/Plenum, New York 1982)138CrossRefGoogle Scholar
29.Ferro, A.Theory of diffusion constants in interstitial solid solutions of b.c.c. metals. J. Appl. Phys. 28, 895 (1957)CrossRefGoogle Scholar
30.Criado, J.M., Ortega, A.Non-isothermal transformation kinetics: Remarks on the Kissinger method. J. Non-Cryst. Solids 87, 302 (1986)CrossRefGoogle Scholar
31.Giber, J., Oechsner, H.Dissolution of anodic Ta2O5 layers into polycrystalline tantalum. Thin Solid Films 131, 279 (1985)CrossRefGoogle Scholar