Hostname: page-component-cd9895bd7-jn8rn Total loading time: 0 Render date: 2024-12-23T06:08:47.800Z Has data issue: false hasContentIssue false

Microstructures and tensile properties of off-stoichiometric Ni3Al–Ni3V pseudo-binary alloys

Published online by Cambridge University Press:  16 September 2019

Kazushige Ioroi
Affiliation:
Department of Materials Science, Osaka Prefecture University, Sakai, Osaka 599-8531, Japan
Satoshi Semboshi
Affiliation:
Institute for Materials Research, Tohoku University, Sendai, Miyagi 980-8577, Japan
Yasuyuki Kaneno
Affiliation:
Department of Materials Science, Osaka Prefecture University, Sakai, Osaka 599-8531, Japan
Takayuki Takasugi*
Affiliation:
Department of Materials Science, Osaka Prefecture University, Sakai, Osaka 599-8531, Japan
*
a)Address all correspondence to this author. e-mail: [email protected]
Get access

Abstract

The effect of off-stoichiometry on the microstructures and tensile properties of Ni3Al–Ni3V pseudo-binary alloys was investigated by a scanning electron microscope, a transmission electron microscope, Vickers hardness test, and high-temperature tensile test. As the alloy deviates from a just-stoichiometric composition toward Ni-rich one, the microstructures constituted by two ordered phases, Ni3Al and Ni3V changed to those constituted by two ordered phases, Ni3Al and Ni3V, and one disordered phase, Ni solid solution. Also, the deviation from the stoichiometric composition resulted in a decrease in flow strength as well as Vickers hardness and conversely increase in tensile elongation. Higher tensile elongation in the off-stoichiometric alloys was induced by the transition from intergranular fracturing to transgranular fracturing. The trade-off relation in the yield strength (or hardness) versus tensile elongation curve, which was drawn plotting the data obtained from the alloys with different off-stoichiometric compositions, was most excellent at 600 °C but rapidly became worse at high temperatures beyond 600 °C. It was demonstrated that the deviation to the off-stoichiometric composition in the two-phase Ni3Al–Ni3V pseudo-binary alloy system was a useful alloying parameter to improve the balance of the flow strength and tensile ductility.

Type
Article
Copyright
Copyright © The Authors 2019 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

Harada, H., Yamazaki, M., and Koizumi, Y.: A series of nickel-base superalloys on γ–γ′ tie line of alloy inconel 713C. Tetsu-To-Hagane 65, 1049 (1979).CrossRefGoogle Scholar
Reed, R.C.: The Superalloys: Fundamentals and Applications (Cambridge University Press, Cambridge, U.K., 2008).Google Scholar
Nunomura, Y., Kaneno, Y., Tsuda, H., and Takasugi, T.: Dual multi-phase intermetallic alloys composed of geometrically close-packed Ni3X (X: Al, Ti, and V) type structures—I. Microstructures and their stabilities. Acta Mater. 54, 851 (2006).CrossRefGoogle Scholar
Shibuya, S., Kaneno, Y., Yoshida, M., and Takasugi, T.: Dual multi-phase intermetallic alloys composed of geometrically close-packed Ni3X (X: Al, Ti, and V) type structures—II. Mechanical properties. Acta Mater. 54, 861 (2006).CrossRefGoogle Scholar
Shibuya, S., Kaneno, Y., Tsuda, H., and Takasugi, T.: Microstructural evolution of dual multi-phase intermetallic alloys composed of geometrically close packed Ni3X (X: Al and V) type structures. Intermetallics 15, 338 (2007).CrossRefGoogle Scholar
Kobayashi, S., Sato, K., Hayashi, E., Osaka, T., Konno, T.J., Kaneno, Y., and Takasugi, T.: Alloying effects on the phase equilibria among Ni(A1), Ni3Al(L12), and Ni3V(D022) phases. Intermetallics 23, 68 (2012).CrossRefGoogle Scholar
Moronaga, T., Kaneno, Y., Semboshi, S., and Takasugi, T.: Microstructural stability and hardening behavior of Re-added dual two-phase Ni3Al and Ni3V intermetallic alloys. Philos. Mag. 95, 3859 (2015).CrossRefGoogle Scholar
Moronaga, T., Kaneno, Y., Tsuda, H., and Takasugi, T.: Deformation microstructures of two-phase intermetallic alloy composed of Ni3Al and Ni3V in single crystalline form. Mater. Sci. Forum 706–709, 1077 (2012).CrossRefGoogle Scholar
Varin, R.A. and Winnicka, M.B.: Plasticity of structural intermetallic compounds. Mater. Sci. Eng., A 137, 93 (1991).CrossRefGoogle Scholar
Francois, A., Hug, G., and Veyssière, P.: The fine structure of dislocations in Ni3V. Philos. Mag. A 66, 269 (1992).CrossRefGoogle Scholar
Hagihara, K., Mori, M., Kishimoto, T., and Umakoshi, Y.: Change in microstructure by heat-treatment and corresponding deformation behavior in Ni3V single crystals. Mater. Sci. Forum 638–642, 1318 (2010).CrossRefGoogle Scholar
Singh, J.B., Sundararaman, M., and Mukhopadhyay, P.: Propagation of stacking faults across domain boundaries in Ni–V and Ni–V–Nb alloys with D022 structure. Philos. Mag. A 80, 1983 (2000).CrossRefGoogle Scholar
Takasugi, T. and Kaneno, Y.: MRS Symp. Properties and application for two-phase intermetallic alloys composed of geometrically close packed Ni3X(X: Al and V) structures. Proc. Publ. 1128, 351 (2009).Google Scholar
Kawahara, K., Moronaga, T., Kaneno, Y., Kakitsuji, A., and Takasugi, T.: Effect of Nb and Ti addition on microstructure and hardness of dual two-phase intermetallic alloys based on Ni3Al–Ni3V pseudo-binary alloy system. Mater. Trans. 51, 1395 (2010).CrossRefGoogle Scholar
Shibuya, S., Kaneno, Y., Yoshida, M., Shishido, T., and Takasugi, T.: Mechanical properties of dual multi-phase single-crystal intermetallic alloy composed of geometrically close packed Ni3X (X: Al and V) type structures. Intermetallics 15, 119 (2007).CrossRefGoogle Scholar
Soga, W., Kaneno, Y., and Takasugi, T.: Microstructure and mechanical property in dual two-phase intermetallic alloys composed of geometrically close-packed Ni3X (X: Al and V) containing Nb. Mater. Sci. Eng., A 473, 180 (2008).CrossRefGoogle Scholar
Kawahara, K., Kaneno, Y., and Takasugi, T.: Microstructural factors affecting hardness property of dual two-phase intermetallic alloys based on Ni3Al–Ni3V pseudo-binary alloy system. Intermetallics 17, 938 (2009).CrossRefGoogle Scholar
Moronaga, T., Ishii, S., Kaneno, Y., Tsuda, H., and Takasugi, T.: Aging effect on microstructure and hardness of two-phase Ni3Al–Ni3V intermetallic alloys containing Ta and Re. Mater. Sci. Eng., A 539, 30 (2012).CrossRefGoogle Scholar
Ioroi, K., Kaneno, Y., Semboshi, S., and Takasugi, T.: Effect of transition metal addition on microstructure and hardening behavior of two-phase Ni3Al–Ni3V intermetallic alloys. Materialia 5, 100174 (2019).CrossRefGoogle Scholar
Edatsugi, D., Kaneno, Y., Semboshi, S., and Takasugi, T.: Fine precipitation in the channel region of dual two-phase Ni3Al and Ni3V intermetallic alloys added by Mo and W. Metall. Mater. Trans. A 47, 998 (2016).CrossRefGoogle Scholar
Uekami, A., Semboshi, S., Kaneno, Y., and Takasugi, T.: Effects of tungsten addition and isothermal annealing on microstructural evolution and hardening behavior of two-phase Ni3Al–Ni3V intermetallic alloys. Mater. Trans. 59, 204 (2018).CrossRefGoogle Scholar
Noguchi, O., Oya, Y., and Suzuki, T.: The effect of nonstoichiometry on the positive temperature dependence of strength of Ni3AI and Ni3Ga. Metall. Trans. A 12, 1647 (1981).CrossRefGoogle Scholar
Aoki, K.: Ductilization of L12 intermetallic compound Ni3Al by microalloying with boron. Mater. Trans., JIM 31, 443 (1990).CrossRefGoogle Scholar
Liu, C.T., White, C.L., and Horton, J.A.: Effect of boron on grain-boundaries in Ni3Al. Acta Metall. 33, 213 (1985).CrossRefGoogle Scholar
Takasugi, T., Masahashi, N., and Izumi, O.: Electronic and structural studies of grain boundary strength and fracture in L12 ordered alloys—III. On the effect of stoichiometry. Acta Metall. 35, 381 (1987).CrossRefGoogle Scholar
Johnson, W.C. and Lee, J.K.: Elastic interaction energy of two spherical precipitates in an anisotropic matrix. Metall. Trans. A 10, 1141 (1979).CrossRefGoogle Scholar
Miyazaki, T., Imamura, H., Mori, H., and Kozakai, T.: Theoretical and experimental investigations on elastic interactions between γ′-precipitates in a Ni–Al alloy. J. Mater. Sci. 16, 1197 (1981).CrossRefGoogle Scholar
Zapolsky, H., Pareige, C., Marteau, L., and Blavette, D.: Atom probe analyses and numerical calculation of ternary phase diagram in Ni–Al–V system. Calphad 25, 125 (2001).CrossRefGoogle Scholar
Takeuchi, S. and Kuramoto, E.: Temperature and orientation dependence of the yield stress in Ni3Ga single crystals. Acta Metall. 21, 415 (1973).CrossRefGoogle Scholar
Pope, D.P. and Ezz, S.S.: Mechanical properties of Ni3Al and nickel-base alloys with high volume fraction of γ′. Int. Met. Rev. 29, 136 (1984).CrossRefGoogle Scholar
Mulford, R.A. and Pope, D.P.: The yield stress of Ni3(Al, W). Acta Metall. 21, 1375 (1973).CrossRefGoogle Scholar
Aoki, K. and Izumi, O.: The relation between the defect hardening and substitutional solid solution hardening in an intermetallic compound Ni3Al. Phys. Status Solidi A 88, 587 (1976).CrossRefGoogle Scholar
Imajo, D., Kaneno, Y., and Takasugi, T.: Effect of Ta substitution method on the mechanical properties of Ni3(Si,Ti) intermetallic alloy. Mater. Sci. Eng., A 588, 228 (2013).CrossRefGoogle Scholar
Hayes, F.H., Rogl, P., and Schmid, E.: Ternary Alloys, Petzow, G. and Effenberg, G., ed. (VCH, Weinheim, 1993); p. 8.Google Scholar
Stoloff, N.S. and Davies, R.G.: The mechanical properties of ordered alloys. Prog. Mater. Sci. 13, 1 (1968).CrossRefGoogle Scholar
Stoloff, N.S.: Strengthening Method in Crystals (Elsevier, Amsterdom, 1971); pp. 193259.Google Scholar