Hostname: page-component-586b7cd67f-g8jcs Total loading time: 0 Render date: 2024-11-26T03:53:48.907Z Has data issue: false hasContentIssue false
  • English
  • Français

Mesoscale friction anisotropy revealed by slidingless tests

Published online by Cambridge University Press:  12 September 2011

James Annett ,
Yanfei Gao ,
Graham L.W. Cross ,
Erik G. Herbert  and
Barry N. Lucas
James Annett
Affiliation:
School of Physics and Center for Research on Adaptive Nanostructures and Nanodevices (CRANN), Trinity College, Dublin 2, Ireland
Yanfei Gao*
Affiliation:
Department of Materials Science and Engineering, University of Tennessee, Knoxville, Tennessee 37996; Computer Science and Mathematics Division, Oak Ridge National Laboratory, Oak Ridge, Tennessee 37831
Graham L.W. Cross*
Affiliation:
School of Physics and Center for Research on Adaptive Nanostructures and Nanodevices (CRANN), Trinity College, Dublin 2, Ireland
Erik G. Herbert
Affiliation:
Department of Materials Science and Engineering, University of Tennessee, Knoxville, Tennessee 37996
Barry N. Lucas
Affiliation:
Fast Forward Devices, LLC, Knoxville, Tennessee 37931
*
a)Address all correspondence to these authors. e-mail: [email protected]
b)e-mail: [email protected]
Get access

Abstract

Using a recently developed multidimensional nanocontact system designed for a quantitative measurement of lateral contact stiffness in the 10–106 N/m stiffness range (or 10–1000 nm contact size), we found a crystallographic-orientation-dependent lateral-stiffness reduction relative to the elastic prediction at contact sizes around 50 nm for polished Ni single crystal surface in air. The slidingless measurement is enabled by a frequency-specific, continuous stiffness measurement technique. Based on an interface microslip model and an anisotropic elastic contact analysis, the resulting friction stress is found to increase monotonically when the tested lateral direction rotates away from the closely packed direction.

Keywords

Nanoindentation
Type
Materials Communications
Information
Journal of Materials Research , Volume 26 , Issue 18 , 28 September 2011 , pp. 2373 - 2378
Copyright
Copyright © Materials Research Society 2011

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1.Carpick, R.W., Ogletree, D.F., and Salmeron, M.: Lateral stiffness: A new nanomechanical measurement for the determination of shear strengths with friction force microscopy. Appl. Phys. Lett. 70, 1548 (1997).CrossRefGoogle Scholar
2.Carpick, R.W. and Salmeron, M.: Scratching the surface: Fundamental investigations of tribology with atomic force microscopy. Chem. Rev. 97, 1163 (1997).CrossRefGoogle ScholarPubMed
3.Gnecco, E. and Meyer, E.: Fundamentals of Friction and Wear (Springer, Berlin, 2007).CrossRefGoogle Scholar
4.Hölscher, H., Schirmeisen, A., and Schwarz, U.D.: Principles of atomic friction: From sticking atoms to superlubric sliding. Philos. Trans. R. Soc. London, Ser. A 366, 1383 (2008).Google ScholarPubMed
5.Lucas, B.N., Hay, J.C., and Oliver, W.C.: Using multidimensional contact mechanics experiments to measure Poisson’s ratio. J. Mater. Res. 19, 58 (2004).CrossRefGoogle Scholar
6.Gao, Y.F., Lucas, B.N., Hay, J.C., Oliver, W.C., and Pharr, G.M.: Nanoscale incipient asperity sliding and interface micro-slip assessed by the measurement of tangential contact stiffness. Scr. Mater. 55, 653 (2006).CrossRefGoogle Scholar
7.Gao, Y.F., Xu, H.T., Oliver, W.C., and Pharr, G.M.: A comparison of Coulomb friction and friction stress models based on multidimensional nanocontact experiments. J. Appl. Mech. 75, 034504 (2008).CrossRefGoogle Scholar
8.Homola, A.M., Israelachvili, J.N., McGuiggan, P.M., and Gee, M.L.: Fundamental experimental studies in tribology: The transition from “interfacial” friction of undamaged molecularly smooth surfaces to “normal” friction with wear. Wear 136, 65 (1990).CrossRefGoogle Scholar
9.McGuiggan, P.M. and Israelachvili, J.N.: Adhesion and short-range forces between surfaces. Part II: Effects of surface lattice mismatch. J. Mater. Res. 5, 2232 (1990).CrossRefGoogle Scholar
10.Hirano, M. and Shinjo, K.: Atomistic locking and friction. Phys. Rev. B 41, 11837 (1990).CrossRefGoogle ScholarPubMed
11.Dienwiebel, M., Verhoeven, G.S., Pradeep, N., Frenken, J.W.M., Heimberg, J.A., and Zandbergen, H.W.: Superlubricity of graphite. Phys. Rev. Lett. 92, 126101 (2004).CrossRefGoogle ScholarPubMed
12.Qi, Y., Cheng, Y-T., Cagin, T., and Goddard, W.A. III: Friction anisotropy at Ni(100)/(100) interfaces: Molecular dynamics studies. Phys. Rev. B 66, 085420 (2002).CrossRefGoogle Scholar
13.Gao, Y.F.: A Peierls perspective on mechanisms of atomic friction. J. Mech. Phys. Solids 58, 2023 (2010).CrossRefGoogle Scholar
14.Ko, J.S. and Gellman, A.J.: Friction anisotropy at Ni(100)/Ni(100) interfaces. Langmuir 16, 8343 (2000).CrossRefGoogle Scholar
15.Johnson, K.L.: Contact Mechanics (Cambridge University Press, Cambridge, 1985).CrossRefGoogle Scholar
16.Gao, Y.F., Xu, H.T., Oliver, W.C., and Pharr, G.M.: Effective elastic modulus of film-on-substrate systems under normal and tangential contact. J. Mech. Phys. Solids 56, 402 (2008).CrossRefGoogle Scholar
17.Willis, J.R.: Hertzian contact of anisotropic bodies. J. Mech. Phys. Solids 14, 163 (1966).CrossRefGoogle Scholar
18.Vlassak, J.J. and Nix, W.D.: Indentation modulus of elastically anisotropic half spaces. Philos. Mag. A 67, 1045 (1993).CrossRefGoogle Scholar
19.Gao, Y.F. and Pharr, G.M.: Multidimensional contact moduli of elastically anisotropic solids. Scr. Mater. 57, 13 (2007).CrossRefGoogle Scholar
20.Gao, Y.F.: Passing stiffness anisotropy in multilayers and its effects on nanoscale surface self-organization. Int. J. Solids Struct. 40, 6429 (2003).CrossRefGoogle Scholar
21.Reinstädtler, M., Kasai, T., Rabe, U., Bhushan, B., and Arnold, W.: Imaging and measurement of elasticity and friction using the TR mode. J. Phys. D: Appl. Phys. 38, R269 (2005).CrossRefGoogle Scholar
22.Hurley, D.C. and Turner, J.A.: Measurement of Poisson’s ratio with contact-resonance atomic force microscopy. J. Appl. Phys. 102, 033509 (2007).CrossRefGoogle Scholar
23.Oliver, W.C. and Pharr, G.M.: Measurement of hardness and elastic modulus by instrumented indentation: Advances in understanding and refinement to methodology. J. Mater. Res. 19, 3 (2004).CrossRefGoogle Scholar
24.Tada, H., Paris, P.C., and Irwin, G.R.: The Stress Analysis of Cracks Handbook, 3rd ed. (ASME, New York, 2000).CrossRefGoogle Scholar
25.Johnson, K.L.: Adhesion and friction between a smooth elastic spherical asperity and a plane surface. Proc. R. Soc. London, Ser. A 453, 163 (1997).CrossRefGoogle Scholar
26.Reina, S., Paynter, R.J.H., Hills, D.A., and Dini, D.: Determining the coefficient of friction between solids without sliding. Wear 269, 339 (2010).CrossRefGoogle Scholar
27.Hurtado, J.A. and Kim, K.S.: Scale effects in friction of single-asperity contacts. I. From concurrent slip to single-dislocation-assisted slip. Proc. R. Soc. London, Ser. A 455, 3363 (1999).CrossRefGoogle Scholar
28.Hurtado, J.A. and Kim, K.S.: Scale effects in friction of single-asperity contacts. II. Multiple-dislocation-cooperated slip. Proc. R. Soc. London, Ser. A 455, 3385 (1999).CrossRefGoogle Scholar