Hostname: page-component-586b7cd67f-vdxz6 Total loading time: 0 Render date: 2024-11-23T02:35:41.408Z Has data issue: false hasContentIssue false

Interfaces in as-extruded XD Al/TiC and Al/TiB2 metal matrix composites

Published online by Cambridge University Press:  03 March 2011

R. Mitra
Affiliation:
Department of Materials Science and Engineering, Northwestern University, Evanston, Illinois 60208-3108
W.A. Chiou
Affiliation:
Department of Materials Science and Engineering, Northwestern University, Evanston, Illinois 60208-3108
M.E. Fine
Affiliation:
Department of Materials Science and Engineering, Northwestern University, Evanston, Illinois 60208-3108
J.R. Weertman
Affiliation:
Department of Materials Science and Engineering, Northwestern University, Evanston, Illinois 60208-3108

Abstract

Core share and HTML view are not available for this content. However, as you have access to this content, a full PDF is available via the ‘Save PDF’ action button.

A detailed study was conducted of the microstructure and particle-matrix interfaces in Al/TiCp metal matrix composites prepared by the XD process and subsequent extrusion. A study of the morphology of the TiC particles showed that the surfaces are low index (111) and (200) planes, the former being more common. Direct contact on an atomic scale is established between Al and TiC, allowing chemical bonds to form. Young's modulus is in the range expected for a composite of Al and TiC with good interfacial bonding and load transfer to the particles. No third element has been detected at the interfaces, showing that they are clean. Both incoherent and semicoherent interfaces are seen. The interface character depends on the size of the particles and their orientation with respect to the neighboring Al grains. “Special” interfaces with evidence for nearly periodic dislocations were observed in both XD Al/TiC and Al/TiB2 composites, indicating the general tendency of in situ composites to lower their interfacial energy by forming such boundaries.

Type
Articles
Copyright
Copyright © Materials Research Society 1993

References

REFERENCES

1Oh, S. Y., Cornie, J. A., and Russell, K. C., Metall. Trans. 20A, 533 (1989).CrossRefGoogle Scholar
2Lucas, J. P., Yang, N. Y. C, and Stephens, J. J., in Structure and Properties of Interfaces in Materials, edited by Clark, W. A. T., Dahmen, U., and Briant, C. L. (Mater. Res. Soc. Symp. Proc. 238, Pittsburgh, PA, 1992), p. 877.Google Scholar
3Jones, C., Kiely, C. J., and Wang, S. S., J. Mater. Res. 4, 327 (1989).CrossRefGoogle Scholar
4Mader, W. and Ruhle, M., Acta Metall. 37, 853 (1989).CrossRefGoogle Scholar
5Mader, W., Z. Metallic. 80, 139 (1989).Google Scholar
6Ernst, F., Pirouz, P., and Heuer, A. H., Philos. Mag. A 63, 259 (1991).CrossRefGoogle Scholar
7Westwood, A. R. C., Metall. Trans. 19A, 749 (1988).CrossRefGoogle Scholar
8Wang, L. and Arsenault, R. J., Metall. Trans. 22A, 3013 (1991).CrossRefGoogle Scholar
9Bramfitt, B. L., Metall. Trans. 1, 1987 (1970).CrossRefGoogle Scholar
10Banerji, A. and Reif, W., Metall. Trans. 17A, 2127 (1986).CrossRefGoogle Scholar
11Cisse, J., Boiling, G. F., and Keer, H. W., J. Cryst. Growth 13/14, 777 (1972).CrossRefGoogle Scholar
12Rhee, S. K., J. Am. Ceram. Soc. 53, 386 (1970).CrossRefGoogle Scholar
13Ramqvist, L., J. Phys. Chem. Solids 30, 1835 (1969).CrossRefGoogle Scholar
14Mitra, R., Weertman, J. R., and Fine, M. E., J. Mater. Res. 8, 2370 (1993).CrossRefGoogle Scholar
15Nogi, K., Tsujimoto, M., Ogino, K., and Iwamoto, N., Acta Metall. Mater. 40, 1045 (1992).CrossRefGoogle Scholar
16Bradshaw, A. M., Van der Veen, J.F., Himpsel, F. J., and Eastman, D. E., Solid State Commun. 37, 37 (1980).CrossRefGoogle Scholar
17Fujimori, A., Minami, F., and Tsuda, N., Surf. Sci. 121, 199 (1982).CrossRefGoogle Scholar
18Ivanovsky, A. L. and Gubanov, V. A., in Atomic Scale Calculations of Structure in Materials, edited by Daw, M. S. and Schluter, M. A. (Mater. Res. Soc. Symp. Proc. 193, Pittsburgh, PA, 1990), p. 161.Google Scholar
19Aikin, R. M. Jr., Martin Marietta Laboratory, Baltimore, MD, private communications.Google Scholar
20Fine, M. E., in ASM STP 129, 1 (1952).Google Scholar
21Katz, A. P., Lipsitt, H. A., Mah, T., and Mendiratta, M. G., J. Mater. Sci. 18, 1983 (1983).CrossRefGoogle Scholar
22Dravid, V. P., Lyman, C. E., Notis, M. R., and Revcolevschi, A., Ultramicrosc. 29, 60 (1989).CrossRefGoogle Scholar
23Merkle, K. L., in Proc. Xllth Int. Cong. Elec. Micro. (EMSA, San Francisco, CA, 1990), p. 332.Google Scholar
24Tasker, P. W., J. Phys. C 12, 4977 (1979).CrossRefGoogle Scholar
25Wolf, D., in Ceramic Microstructures '86: Role of Interfaces, edited by Pask, J. A. and Evans, A. G. (Materials Science Research, Plenum Press, New York, 1986), Vol. 21, p. 177.Google Scholar
26Gao, Y. and Merkle, K. L., in Structure and Properties of Interfaces in Materials, edited by Clark, W. A. T., Dahmen, U., and Briant, C. L. (Mater. Res. Soc. Symp. Proc. 238, Pittsburgh, PA, 1992), p. 775.Google Scholar
27Self, P. G., Glaisher, R. W., and Spargo, A. E. C., Ultramicrosc. 18, 49 (1985).CrossRefGoogle Scholar
28Stoneham, A. M. and Tasker, P. W., J. Phys. C 18, L543 (1985).CrossRefGoogle Scholar
29Stoneham, A. M. and Tasker, P. W., in Ceramic Microstructures '86: Role of Interfaces, edited by Pask, J. A. and Evans, A. G. (Materials Science Research, Plenum Press, New York, 1986), Vol. 21, p. 155.Google Scholar
30Mitra, R., Chiou, W. A., Weertman, J. R., Fine, M. E., and Chiou, W. A., in Structure and Properties of Interfaces in Materials, edited by Clark, W. A. T., Dahmen, U., and Briant, C. L. (Mater. Res. Soc. Symp. Proc. 238, Pittsburgh, PA, 1992), p. 871.Google Scholar
31Nutt, S. R., in Interfaces in Metal Matrix Composites, edited by Dhingra, A. K. and Fishman, S. G. (TMS, Warrendale, PA, 1986), p. 157.Google Scholar
32Hashin, Z. and Shtrikman, S., J. Mech. Phys. Solids 11, 127 (1963).CrossRefGoogle Scholar
33Aikin, R. M. Jr., Martin Marietta Laboratories, Report MML TR 63c, p. 118, 103, 108 (1990).Google Scholar
34McCafferty, K., Soper, A., Shirokoff, J., and Erb, U., in Structure and Properties of Interfaces in Materials, edited by Clark, W. A. T., Dahmen, U., and Briant, C. L. (Mater. Res. Soc. Symp. Proc. 238, Pittsburgh, PA, 1992), p. 47.Google Scholar