Hostname: page-component-586b7cd67f-l7hp2 Total loading time: 0 Render date: 2024-11-26T05:19:43.488Z Has data issue: false hasContentIssue false
  • English
  • Français

Influence of heat treatment on cyclic deformation and low-cycle fatigue behavior of sand-cast Mg–10Gd–3Y–0.5Zr magnesium alloy

Published online by Cambridge University Press:  30 May 2017

Quan Wang ,
Wencai Liu ,
Guohua Wu ,
Xiangjun Chen  and
Haohao Zhang
Quan Wang
Affiliation:
National Engineering Research Center of Light Alloy Net Forming and State Key Laboratory of Metal Matrix Composite, School of Materials Science and Engineering, Shanghai Jiao Tong University, Shanghai 200240, China
Wencai Liu*
Affiliation:
National Engineering Research Center of Light Alloy Net Forming and State Key Laboratory of Metal Matrix Composite, School of Materials Science and Engineering, Shanghai Jiao Tong University, Shanghai 200240, China
Guohua Wu
Affiliation:
National Engineering Research Center of Light Alloy Net Forming and State Key Laboratory of Metal Matrix Composite, School of Materials Science and Engineering, Shanghai Jiao Tong University, Shanghai 200240, China
Xiangjun Chen
Affiliation:
National Engineering Research Center of Light Alloy Net Forming and State Key Laboratory of Metal Matrix Composite, School of Materials Science and Engineering, Shanghai Jiao Tong University, Shanghai 200240, China
Haohao Zhang
Affiliation:
National Engineering Research Center of Light Alloy Net Forming and State Key Laboratory of Metal Matrix Composite, School of Materials Science and Engineering, Shanghai Jiao Tong University, Shanghai 200240, China
*
a) Address all correspondence to this author. e-mail: [email protected]
Get access

Abstract

Cyclic deformation and low-cycle fatigue behavior of Mg–10Gd–3Y–0.5Zr alloy in sand-cast and aging treatment conditions (sand-cast-T6) were investigated by carrying out full reversed strain-controlled tension-compression tests at the strain amplitude ranging from 0.25 to 0.7%. The results show that stress–strain hysteresis loops of the studied alloys display near tension-compression symmetry, which is dominated by microstructure and strain amplitude. Both sand-cast and sand-cast-T6 alloys exhibit cyclic hardening and softening phenomenon with increasing loading cycles. Meanwhile, the fatigue life of the aged alloy is higher than that of the sand-cast alloy at all applied strain amplitudes. The theoretical strain fatigue limits (ε0) of sand-cast and sand-cast-T6 alloys are 2.1% and 2.3%, respectively. In addition, the low-cycle fatigue behavior of the studied alloy at different strain amplitudes was also investigated.

Keywords

low-cycle fatiguecyclic deformationheat treatmentsand-castMg–10Gd–3Y–0.5Zr
Type
Articles
Information
Journal of Materials Research , Volume 32 , Issue 11 , 14 June 2017 , pp. 2179 - 2187
Check for updates
Copyright
Copyright © Materials Research Society 2017 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Footnotes

Contributing Editor: Jürgen Eckert

References

REFERENCES

Horstemeyer, M.F., Yang, N., Gall, K., Mcdowell, D.L., Fan, J., and Gullett, P.M.: High cycle fatigue of a die cast AZ91E-T4 magnesium alloy. Acta Mater. 52, 1327–1336 (2004).Google Scholar
Mordike, B.L. and Ebert, T.: Magnesium properties-applications-potential. Mater. Sci. Eng., A 302, 37–45 (2001).Google Scholar
Anthony, A.I., Kamado, S., and Kojima, Y.: Aging characteristics and high temperature tensile properties of Mg–Gd–Y–Zr alloys. Mater. Trans. 42, 1206–1211 (2001).Google Scholar
Anthony, A.I., Kamado, S., and Kojima, Y.: Creep properties of Mg–Gd–Y–Zr alloys. Mater. Trans. 42, 1212–1218 (2001).Google Scholar
He, S.M., Zeng, X.Q., Peng, L.M., Gao, X., Nie, J.F., and Ding, W.J.: Microstructure and strengthening mechanism of high strength Mg–10Gd–2Y–0.5Zr alloy. J. Alloys Compd. 427, 316–323 (2007).CrossRefGoogle Scholar
He, S.M., Zeng, X.Q., Peng, L.M., Gao, X., Nie, J.F., and Ding, W.J.: Precipitation in a Mg–10Gd–3Y–0.4Zr (wt%) alloy during isothermal ageing at 250 °C. J. Alloys Compd. 421, 309–313 (2006).Google Scholar
Nodooshan, H.R.J., Liu, W.C., Wu, G.H., Rao, Y., Zhou, C.X., He, S.P., Ding, W.J., and Mahmudi, R.: Effect of Gd content on microstructure and mechanical properties of Mg–Gd–Y–Zr alloys under peak-aged condition. Mater. Sci. Eng., A 615, 79–86 (2014).Google Scholar
Dong, J., Liu, W.C., Song, X., Zhang, P., Ding, W.J., and Korsunsky, A.M.: Influence of heat treatment on fatigue behaviour of high-strength Mg–10Gd–3Y alloy. Mater. Sci. Eng., A 527, 6053–6063 (2010).Google Scholar
Mirza, F.A., Chen, D.L., Li, D.J., and Zeng, X.Q.: Cyclic deformation behavior of a rare-earth containing extruded magnesium alloy: Effect of heat treatment. Metall. Mater. Trans. A 46, 1168–1187 (2015).CrossRefGoogle Scholar
Wang, F.H., Dong, J., Jiang, Y.Y., and Ding, W.J.: Cyclic deformation and fatigue of extruded Mg–Gd–Y magnesium alloy. Mater. Sci. Eng., A 561, 403–410 (2013).Google Scholar
Yin, S.M. and Li, S.X.: Low-cycle fatigue behaviors of an as-extruded Mg–12% Gd–3% Y–0.5% Zr alloy. J. Mater. Sci. Technol. 29, 775–780 (2013).Google Scholar
Cao, L., Liu, W.C., Li, Z.Q., Wu, G.H., Xiao, L., Wang, S.H., and Ding, W.J.: Effect of heat treatment on microstructures and mechanical properties of sand-cast Mg–10Gd–3Y–0.5Zr magnesium alloy. Trans. Nonferrous Met. Soc. China 24, 611–618 (2014).Google Scholar
Zheng, J.X., Li, Z., Tan, L.D., Xu, X.S., Luo, R.C., and Chen, B.: Precipitation in Mg–Gd–Y–Zr alloy: Atomic-scale insights into structures and transformations. Mater. Charact. 117, 76–83 (2016).Google Scholar
Chen, X., Liu, W., Wu, G., Li, Y., Li, Z., Zhang, S., and Ding, W.: High-temperature tensile and compressive behavior of peak-aged sand-cast Mg–10Gd–3Y–0.5Zr alloy. Adv. Eng. Mater. 18, 671–677 (2016).CrossRefGoogle Scholar
Mirza, F.A., Wang, K., Bhole, S.D., Friedman, J., Chen, D.L., Ni, D.R., Xiao, B.L., and Ma, Z.Y.: Strain-controlled low cycle fatigue properties of a rare-earth containing ME20 magnesium alloy. Mater. Sci. Eng., A 661, 115–125 (2016).CrossRefGoogle Scholar
Begum, S., Chen, D.L., Xu, S., and Luo, A.A.: Low cycle fatigue properties of an extruded AZ31 magnesium alloy. Int. J. Fatigue 31, 726–735 (2009).Google Scholar
Chen, L., Wang, C., Wu, W., Liu, Z., Stoica, G.M., Wu, L., and Liaw, P.K.: Low-cycle fatigue behavior of an as-extruded AM50 magnesium alloy. Metall. Mater. Trans. A 38, 2235–2241 (2007).Google Scholar
Li, Z.M., Wang, Q.G., Luo, A.A., Peng, L.M., and Zhang, P.: Fatigue behavior and life prediction of cast magnesium alloys. Mater. Sci. Eng., A 647, 113–126 (2015).CrossRefGoogle Scholar
Mirza, F.A. and Chen, D.L.: Fatigue of rare-earth containing magnesium alloys: A review. Fatigue Fract. Eng. Mater. Struct. 37, 831–853 (2014).Google Scholar
Mirza, F.A., Chen, D.L., Li, D.J., and Zeng, X.Q.: Low cycle fatigue of a rare-earth containing extruded magnesium alloy. Mater. Sci. Eng., A 575, 65–73 (2013).Google Scholar
Zeng, R., Han, E., Ke, W., Dietzel, W., Kainer, K.U., and Atrens, A.: Influence of microstructure on tensile properties and fatigue crack growth in extruded magnesium alloy AM60. Int. J. Fatigue 32, 411–419 (2010).Google Scholar
Begum, S., Chen, D.L., Xu, S., and Luo, A.A.: Strain-controlled low-cycle fatigue properties of a newly developed extruded magnesium alloy. Metall. Mater. Trans. A 39, 3014–3026 (2008).CrossRefGoogle Scholar
Yu, Q., Zhang, J., Jiang, Y., and Li, Q.: An experimental study on cyclic deformation and fatigue of extruded ZK60 magnesium alloy. Int. J. Fatigue 36, 47–58 (2012).Google Scholar
Lou, X., Li, M., Boger, R., Agnew, S., and Wagoner, R.: Hardening evolution of AZ31B Mg sheet. Int. J. Plast. 23, 44–86 (2007).Google Scholar
Brown, D.W., Agnew, S.R., Bourke, M.A.M., Holden, T.M., Vogel, S.C., and Tomé, C.N.: Internal strain and texture evolution during deformation twinning in magnesium. Mater. Sci. Eng., A 399, 1–12 (2005).Google Scholar