Hostname: page-component-78c5997874-ndw9j Total loading time: 0 Render date: 2024-11-18T01:22:03.032Z Has data issue: false hasContentIssue false
  • English
  • Français

High temperature extrusion behavior of fine-grain ZrO2

Published online by Cambridge University Press:  31 January 2011

B. J. Kellett
B. J. Kellett
Affiliation:
Laboratoire de Céramique, Département des Matériaux, Ecole Polytechnique Fédérale de Lausanne
Get access

Abstract

High temperature forming of a fine-grain ceramic is demonstrated by a series of extrusion experiments with fine-grain ZrO2, 3 mole% Y2O3. Piston velocities, ranging up to 5 mm/min (for a die with an initial diameter of 30 mm and a final diameter of 10 mm), can be achieved at 1500 °C with piston stresses of 70 MPa and graphite paper lubrication. These piston velocities are consistent with a calculation based on the creep behavior of this ceramic. The calculation is based on a model of material flow through the die, consistent with experiments involving internal markers of graphite foil.

Type
Articles
Information
Journal of Materials Research , Volume 5 , Issue 10 , October 1990 , pp. 2165 - 2171
Copyright
Copyright © Materials Research Society 1990

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1Wakai, F., Sakaguchi, S., and Matsumo, Y., Adv. Ceram,. Mater. 1, 259 (1986).CrossRefGoogle Scholar
2Kellett, B. J. and Lange, F. F., J. Am. Ceram. Soc. 69, C–172 (1986).Google Scholar
3Kellett, B. J. and Lange, F. F., J. Am. Ceram. Soc. 71, 7 (1988).Google Scholar
4Kellett, B. J., Carry, P., and Mocellin, A., J. Am. Ceram. Soc. 73, 1922 (1940).Google Scholar
5Kellett, B., Carry, P., and Mocellin, A., Proc. Int. Conf. on Superplasticity and Superplastic Forming, Blaine, WA (1988).Google Scholar
6Nauer, M. and Carry, C., Proc. Euro. Ceram. 3, 3323 (1989).Google Scholar
7Avitzur, B., Trans. ASME J. of Eng. for Industry 86, 305 (1964).CrossRefGoogle Scholar
8Avitzur, B., Trans. ASME J. of Eng. for Industry 89, 556 (1967).CrossRefGoogle Scholar
9Ragab, A. R. and Baudelet, B., Revue de Physique Appliquée 12, 15 (1977).Google Scholar
10Alto, A. and Giorleo, G., Trans. ASME J. of Eng. for Industry 97, 1131 (1975)CrossRefGoogle Scholar