Hostname: page-component-cd9895bd7-hc48f Total loading time: 0 Render date: 2024-12-25T15:47:59.641Z Has data issue: false hasContentIssue false
  • English
  • Français

Fourier transform infrared analysis of hydroxyl content of hydrothermally processed heteroepitaxial barium titanate films

Published online by Cambridge University Press:  01 December 2005

Sandeep K. Patil ,
Nipun Shah ,
Frank D. Blum  and
Mohamed N. Rahaman
Sandeep K. Patil
Affiliation:
Department of Materials Science and Engineering, University of Missouri-Rolla, Rolla, Missouri 65409
Nipun Shah
Affiliation:
Materials Research Center, University of Missouri-Rolla, Rolla, Missouri 65409
Frank D. Blum
Affiliation:
Materials Research Center and Department of Chemistry, University of Missouri-Rolla, Rolla, Missouri 65409
Mohamed N. Rahaman*
Affiliation:
Department of Materials Science and Engineering, University of Missouri-Rolla, Rolla, Missouri 65409
*
a) Address all correspondence to this author. e-mail: [email protected]
Get access

Abstract

The concentration of hydroxyl (–OH) groups in epitaxial barium titanate (BaTiO3) films (thickness ∼ 200 nm), deposited on single-crystal strontium titanate (SrTiO3) at 150 °C by a hydrothermal technique, was investigated using x-ray photoelectron spectroscopy and Fourier transform infrared (FTIR) spectroscopy. After hydrothermal treatment, a broad FTIR resonance for the hydroxyl groups indicated a significant concentration of surface –OH groups in the films. The as-deposited films were subsequently treated hydrothermally with D2O, and the kinetics of the exchange reaction between –OH incorporated into the film and –OD from the D2O were studied using FTIR. For reactions carried out intermittently, the kinetics of the exchange reaction between –OH by –OD depended not only on the total reaction time, but also on the duration of each treatment. The broad FTIR hydroxyl resonance in the as-deposited hydrothermal film was significantly reduced only after heating for 1 h at 600–800 °C.

Keywords

FilmHydrothermalInfrared (IR) spectroscopy
Type
Articles
Information
Journal of Materials Research , Volume 20 , Issue 12 , December 2005 , pp. 3312 - 3319
Copyright
Copyright © Materials Research Society 2005

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1.Newnham, R.E.: Electroceramics. Rep. Prog. Phys. 52, 123 (1989).CrossRefGoogle Scholar
2.Yoshimura, M., Yoo, S.E., Hayashi, M. and Ishizawa, N.: Preparation of BaTiO3 thin film by hydrothermal electrochemical method. Jpn. J. Appl. Phys. 29, 2007 (1989).CrossRefGoogle Scholar
3.Ishizawa, N., Banno, H., Hayashi, M., Yoo, S.E. and Yoshimura, M.: Preparation of barium titanate (BaTiO3) and strontium titanate (SrTiO3) polycrystalline thin films on flexible polymer film substrate by hydrothermal method. Jpn. J. Appl. Phys. 29, 2467 (1990).CrossRefGoogle Scholar
4.Hayashi, M., Ishizawa, N., Yoo, S-E. and Yoshimura, M.: Preparation of barium titanate thin film on titanium deposited glass substrate by hydrothermal-electrochemical method. J. Ceram. Soc. Jpn. 98, 930 (1990).CrossRefGoogle Scholar
5.Kajiyoshi, K., Ishizawa, N. and Yoshimura, M.: Preparation of tetragonal barium titanate thin film on titanium metal substrate by hydrothermal method. J. Am. Ceram. Soc. 74, 369 (1991).CrossRefGoogle Scholar
6.Kajiyoshi, K., Ishizawa, N. and Yoshimura, M.: Heteroepitaxial growth of BaTiO3 thin films on SrTiO3 substrates under hydrothermal conditions. Jpn. J. Appl. Phys. 1B, L120 (1991).CrossRefGoogle Scholar
7.Basca, R.R., Ravindranathan, P. and Dougherty, J.P.: Electrochemical, hydrothermal, and electrochemical-hydrothermal synthesis of barium titanate thin films on titanium substrates. J. Mater. Res. 7, 423 (1992).Google Scholar
8.Shi, E., Cho, C.R., Jang, M.S., Jeong, S.Y. and Kim, H.J.: Formation mechanism of thin film under hydrothermal conditions. J. Mater. Res. 9, 2914 (1994).CrossRefGoogle Scholar
9.Basca, R.R. and Dougherty, J.P.: Hydrothermal synthesis of barium titanate thin film on titanium metal powder. J. Mater. Sci. Lett. 14, 600 (1995).CrossRefGoogle Scholar
10.Chien, A.T., Speck, J.S., Lange, F.F., Daykin, A.C. and Levi, C.G.: Low temperature/low pressure hydrothermal synthesis of barium titanate: Powder and heteroepitaxial thin films. J. Mater. Res. 10, 1784 (1995).CrossRefGoogle Scholar
11.Slamovich, E.B. and Aksay, I.A.: Structure evolution in hydrothermally processed (<100 °C) BaTiO3 films. J. Am. Ceram. Soc. 79, 239 (1996).CrossRefGoogle Scholar
12.Dogan, F. and Sarikaya, M.: Mechanisms of hydrothermal barium titanate thin film formation, in Polycrystalline Thin Films: Structure, Texture, Properties and Applications II, edited by Frost, H.J., Parker, M.A., Ross, C.A., and Holm, E.A. (Mater. Res. Soc. Symp. Proc. 403, Pittsburgh, PA, 1996), p. 95.Google Scholar
13.Chien, A.T., Zhao, L., Colic, M., Speck, J.S. and Lange, F.F.: Microstructural development of BaTiO3 heteroepitaxial thin films by hydrothermal synthesis. J. Mater. Res. 13, 649 (1998).CrossRefGoogle Scholar
14.Zeng, J., Lin, C., Li, J. and Li, K.: Low temperature preparation of barium titanate thin films by a novel sol-gel-hydrothermal method. Mater. Lett. 38, 112 (1999).CrossRefGoogle Scholar
15.Wu, Z. and Yoshimura, M.: Investigations on procedures of the fabrication of barium titanate ceramic films under hydrothermal-electrochemical conditions. Solid State Ionics 122, 161 (1999).CrossRefGoogle Scholar
16.Kao, C-F. and Yang, C-L.: Preparation and electrical properties of barium titanate film by hydrothermal method. J. Eur. Ceram. Soc. 19, 1365 (1999).CrossRefGoogle Scholar
17.Kajiyoshi, K. and Sakabe, Y.: Preparation of barium titanate thin film on a porous titanium body by the hydrothermal electrochemical method. J. Am. Ceram. Soc. 82, 2985 (1999).CrossRefGoogle Scholar
18.Escobar, I.S., Silva, C.I., Vargas, T. and Fuenzalida, V.M.: Nucleation and inhibition control during the hydrothermal-electrochemical growth of barium titanate films. J. Am. Ceram. Soc. 83, 2673 (2000).CrossRefGoogle Scholar
19.Ciftci, E., Rahaman, M.N. and Blum, F.D.: Hydrothermal deposition and characterization of heteroepitaxial BaTiO3 films on SrTiO3 and LaAlO3 single crystals. J. Mater. Sci. 37, 3361 (2002).CrossRefGoogle Scholar
20.Byrappa, K. and Yoshimura, M.: Handbook of Hydrothermal Technology (Noyes Publications, Park Ridge, NJ, 2001).Google Scholar
21.Vivekanandan, R., Philip, S. and Kutty, T.: Hydrothermal preparation of barium titanate fine powders. Mater. Res. Bull. 22, 99 (1987).CrossRefGoogle Scholar
22.Hennings, D. and Shreinmacher, S.: Characterization of hydrothermal BaTiO3. J. Eur. Ceram. Soc. 9, 41 (1992).CrossRefGoogle Scholar
23.Noma, T., Wada, S., Yano, M. and Suzuki, T.: Analysis of lattice vibration in fine particles of barium titanate single crystals including lattice hydroxyl group. J. Appl. Phys. 80, 5223 (1996).CrossRefGoogle Scholar
24.Hennings, D.F.K., Metzmacher, C. and Schreinemacher, B.S.: Defect chemistry and microstructure of hydrothermal barium titanate. J. Am. Ceram. Soc. 84, 179 (2001).CrossRefGoogle Scholar
25.Chien, A.T., Zhao, L., Colic, M., Speck, J.S. and Lange, F.F.: Electrical characterization of BaTiO3 heteroepitaxial films by hydrothermal synthesis. J. Mater. Res. 14, 3330 (1999).CrossRefGoogle Scholar
26.McCormick, M.A. and Slamovich, E.B.: Microstructure development and dielectric properties of hydrothermal BaTiO3 thin films. J. Eur. Ceram. Soc. 23, 2143 (2003).CrossRefGoogle Scholar
27.Lisoni, J.G., Piera, F.J., Sánchez, M., Soto, C.F. and Fuenzalida, V.M.: Water incorporation in BaTiO3 films grown under hydrothermal conditions. Appl. Surf. Sci. 134, 225 (1998).CrossRefGoogle Scholar
28.Fuenzalida, V.M., Pilleux, M.E. and Eisele, I.: Adsorbed water on hydrothermal BaTiO3 films: Work function measurements. Vacuum 55, 81 (1999).CrossRefGoogle Scholar
29.Wada, S., Suzuki, T. and Noma, T.: Preparation of barium titanate fine particles by hydrothermal method and their characterization. J. Ceram. Soc. Jpn. 103, 1220 (1995).CrossRefGoogle Scholar
30.Hung, C.C. and Riman, R.E.: X-ray photoelectron spectroscopy investigation of hydrothermal and commercial barium titanate powders, in Chemical Processing of Advanced Materials, edited by Hench, L.L. and West, J.K. (Wiley, New York, 1992), p. 603.Google Scholar
31.Christie, A.B.: X-ray photoelectron spectroscopy, in Methods of Surface Analysis, edited by Walls, J.M. (Cambridge University Press, New York, 1989), p. 127.Google Scholar
32.Woodruff, D.P. and Delchar, T.A.: Modern Techniques of Surface Science, 2nd ed. (Cambridge University Press, New York, 1994).CrossRefGoogle Scholar
33.Moulder, J.F., Stickle, W.F., Sobol, P.E. and Bomben, K.D.: Handbook of X-ray Photoelectron Spectroscopy (Perkin Elmer, Eden Prairie, MN, 1992).Google Scholar
34.Nagarkar, P.V., Searson, P.C. and Gealy, F.D.: Effect of surface treatment on SrTiO3: An x-ray photoelectron spectroscopic study. J. Appl. Phys. 69, 459 (1991).CrossRefGoogle Scholar
35.Chornik, B., Fuenzalida, V.A., Grahmann, C.R. and Labbé, R.: Water adsorption properties of amorphous BaTiO3 thin films. Vacuum 48, 161 (1997).CrossRefGoogle Scholar
36.Mukhopadhyay, S.M. and Chen, T.C.S.: Surface chemical states of barium titanate: Influence of sample processing. J. Mater. Res. 10, 1502 (1995).CrossRefGoogle Scholar
37.Lu, C.J., Kuang, A.X. and Huang, G.Y.: X-ray photoelectron spectroscopy study on composition and structure of sol-gel derived PbTiO3 thin films. J. Appl. Phys. 80, 202 (1996).CrossRefGoogle Scholar
38.Miot, C., Husson, E., Proust, C., Erre, R. and Coutures, J.P.: X-ray photoelectron spectroscopy characterization of barium titanate ceramics prepared by the citric route. Residual carbon study. J. Mater. Res. 12, 2388 (1997).CrossRefGoogle Scholar
39.Smith, B.C.: Fundamentals of Fourier Transform Infrared Spectroscopy (CRC Press, Boca Raton, FL, 1996).Google Scholar
40.Christy, A.A., Ozaki, Y. and Gregoriou, V.G.: Modern Fourier Transform Infrared Spectroscopy (Elsevier, New York, 2001).Google Scholar
41.Kapphan, S. and Weber, G.: IR-absorption study of H and D impurities in BaTiO3 crystals. Ferroelectrics 37, 673 (1981).CrossRefGoogle Scholar
42.Chien, A.T., Sachleben, J., Kim, J.H., Speck, J.S. and Lange, F.F.: Synthesis and characterization of PbTiO3 powders and heteroepitaxial thin films by hydrothermal synthesis. J. Mater. Res. 14, 3303 (1999).CrossRefGoogle Scholar
43.Waser, R.: Solubility of hydrogen defects in doped and undoped BaTiO3. J. Am. Ceram. Soc. 71, 58 (1988).CrossRefGoogle Scholar