Hostname: page-component-586b7cd67f-dsjbd Total loading time: 0 Render date: 2024-11-23T09:24:45.135Z Has data issue: false hasContentIssue false
  • English
  • Français

Degradation of AlN Powder in Aqueous Environments

Published online by Cambridge University Press:  03 March 2011

Kristoffer Krnel ,
Goran Dražič  and
Tomaž Kosmač
Kristoffer Krnel*
Affiliation:
Jožef Stefan Institute, SI-1000 Ljubljana, Slovenia
Goran Dražič
Affiliation:
Jožef Stefan Institute, SI-1000 Ljubljana, Slovenia
Tomaž Kosmač
Affiliation:
Jožef Stefan Institute, SI-1000 Ljubljana, Slovenia
*
a)Address all correspondence to this author. e-mail: [email protected]
Get access

Abstract

The reactivity of AlN powder in an aqueous environment was studied by measuring the pH and the temperature during the hydrolysis of the powder at room and elevated temperatures. The influences of the powder concentration and the starting pH of the slurry were also investigated. The results of the measurements at room temperature show that there is an incubation time before the start of the AlN hydrolysis reactions. Once this incubation time is over, the pH and the temperature of the slurry start to increase, indicating the onset of the reactions. A higher starting temperature not only speeds up the reaction of the AlN powder with water, but it also shortens the incubation time. In addition, the starting temperature influences the morphology of the reaction product: at temperatures below 60 °C, the final product of the hydrolysis is crystalline Al(OH)3, whereas at higher temperatures (above 60 °C), crystalline AlOOH is formed. At very low pH values (pH = 1), the reaction of AlN powder with water is prevented (i.e., the incubation time is very long), whereas in an alkaline environment, the incubation time is approximately the same as in distilled water, but the reaction is accelerated.

Keywords

CeramicChemical reactivityKinetics
Type
Articles
Information
Journal of Materials Research , Volume 19 , Issue 4 , April 2004 , pp. 1157 - 1163
Copyright
Copyright © Materials Research Society 2004

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1Wiberg, E.: Anorganska Kemija (Školska Knjiga, Zagreb, 1967)Google Scholar
2Wefers, K. and Misra, C.: Oxides and Hydroxides of Aluminum, Technical Paper No. 19 (revised 1987) available from Alcoa, Pittsburg, PA.Google Scholar
3Alwitt, R.S.: Oxides and Oxide Films , (Marcel Dekker: New York and Basel, Switzerland, 4, 1976),Google Scholar
4Svedberg, L.M., Arndt, K.C. and Cima, M.J.: J. Am. Ceram. Soc. 83, 41 (2000).CrossRefGoogle Scholar
5Bowen, P., Highfield, J.G., Mocellin, A. and Ring, T.A.: J. Am. Ceram. Soc. 73, 724 (1990).CrossRefGoogle Scholar
6Graziani, T. and Belosi, A.: Mater. Chem. Phys. 35, 53 (1993).CrossRefGoogle Scholar
7Bye, G.C. and Robinson, J.G.: Kolloid Z. 198, 53 (1964).CrossRefGoogle Scholar
8Mobley, W.M.: Colloidal Properties, Processing and Characterization of Aluminum Nitride Suspensions, Ph.D. Thesis, Alfred University, Alfred, New York (1996), p. 110Google Scholar
9Reetz, T., Monch, B. and Saupe, M.: Ber. DKG. 68, 464 (1992).Google Scholar
10Görter, H., Gerretsen, J. and Terpstra, R.A. in 3rd Euroceramics , edited by Duran, P. and Fernandez, J.F. (Faenza Editrice Iberica, S.C., Faenza, 1993), 1, p. 615Google Scholar
11Barba, F., Ortega, P., Bermundo, J., Osendi, M.I. and Moya, J.S.: J. Eur. Ceram. Soc. 13, 335 (1994).CrossRefGoogle Scholar
12Egashira, M., Shimizu, Y. and Takasuki, S.: J. Mater. Sci. Lett. 10, 94 (1991).CrossRefGoogle Scholar
13Fukumoto, S., Hookabe, T. and Tsubakino, H.: J. Mater. Sci. 35, 2743 (2000).CrossRefGoogle Scholar
14Li, Y.Q.: Mater. Res. Bull. 32, 1173 (1997).CrossRefGoogle Scholar
15Levenspiel, O.: Chemical Reaction Engineering , 2nd ed. (John Wiley & Sons, New York, 1972)Google Scholar
16Bell, N.S., Wang, L., Sigmund, W.M. and Aldinger, F.: Z. Metallkd. 90, 6 (1999).Google Scholar
17Shan, H.B., Zhu, Y. and Zhang, Z.T.: Br. Ceram. Trans. 98, 146 (1999).CrossRefGoogle Scholar
18Yoldas, B.E.: J. Appl. Chem. Biotechnol. 23, 803 (1973).CrossRefGoogle Scholar
19Stadelmann, P.A.: Ultramicroscopy. 12, 131 (1987).CrossRefGoogle Scholar
20Krnel, K. and Kosmač, T.: J. Am. Ceram. Soc. 83, 1375 (2000).CrossRefGoogle Scholar