Hostname: page-component-586b7cd67f-t8hqh Total loading time: 0 Render date: 2024-11-27T01:21:14.707Z Has data issue: false hasContentIssue false
  • English
  • Français

Deformation of amorphous silicon nanostructures subjected to monotonic and cyclic loading

Published online by Cambridge University Press:  31 January 2011

C. Gaire ,
D-X. Ye ,
T-M. Lu ,
G-C. Wang  and
R.C. Picu
C. Gaire
Affiliation:
Department of Physics, Applied Physics and Astronomy, Rensselaer Polytechnic Institute, Troy, New York 12180-3590
D-X. Ye
Affiliation:
Department of Physics, Applied Physics and Astronomy, Rensselaer Polytechnic Institute, Troy, New York 12180-3590
T-M. Lu
Affiliation:
Department of Physics, Applied Physics and Astronomy, Rensselaer Polytechnic Institute, Troy, New York 12180-3590
G-C. Wang
Affiliation:
Department of Physics, Applied Physics and Astronomy, Rensselaer Polytechnic Institute, Troy, New York 12180-3590
R.C. Picu*
Affiliation:
Department of Mechanical, Aerospace and Nuclear Engineering, Rensselaer Polytechnic Institute, Troy, New York 12180-3590
*
a) Address all correspondence to this author. e -mail: [email protected]
Get access

Abstract

An atomic force microscope (AFM) was used to characterize the deformation behavior of amorphous Si (a-Si) nanostructures subjected to monotonic and cyclic loading. The sample geometry was specially designed (in the form of elbow) using finite element modeling for the purpose of these tests, and the samples were grown by glancing angle deposition. When deformed monotonically at room temperature, the a-Si specimens exhibited a nonlinear force–displacement response at forces larger than a critical force, a phenomenon not observed in bulk silicon. A fatigue testing methodology based on the use of the AFM was established. The fatigue life of the a-Si specimens was observed to increase by five orders of magnitude with a 50% reduction in the applied force amplitude. It was verified that this delayed failure is caused by progressive damage accumulation during cyclic loading. These results are compared with literature data obtained from micron-size specimens.

Keywords

NanostructurePhysical vapor deposition (PVD)Fatigue
Type
Articles
Information
Journal of Materials Research , Volume 23 , Issue 2 , February 2008 , pp. 328 - 335
Copyright
Copyright © Materials Research Society 2007

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1Muhlstein, C.L., Howe, R.T.Howe, R.O.: Fatigue of polycrystalline silicon for microelectromechanical systems applications: Crack growth and stability under resonant loading conditions. Mech. Mater. 36, 13 2004CrossRefGoogle Scholar
2Namazu, T., Isono, Y.Tanaka, T.: Evaluation of size effect on mechanical properties of single-crystal silicon by nanoscale bending test using AFM. J. Microelectromech. Sys. 9, 450 2000CrossRefGoogle Scholar
3Sundararajan, S.Bhushan, B.: Development of AFM-based techniques to measure mechanical properties of nanoscale structures. Sens. Actuators, A 101, 338 2002CrossRefGoogle Scholar
4Virwani, K.R., Malshe, A.P., Schmidt, W.F.Sood, D.K.: Young’s modulus measurements of silicon nanostructures using a scanning probe system: A nondestructive evaluation approach. Smart Mater. Struct. 12, 1028 2003CrossRefGoogle Scholar
5Gaire, C., Ye, D-X., Tang, F., Picu, R.C., Wang, G-C.Lu, T-M.: Mechanical testing of isolated amorphous silicon slanted nanorods. J. Nanosci. Nanotechnol. 5, 1893 2005CrossRefGoogle ScholarPubMed
6Kahn, H., Ballarini, R., Mullen, R.L.Heuer, A.H.: Electrostatically actuated failure of microfabricated polysilicon fracture mechanics specimens. Proc. R. Soc. (London) 455, 3807 1999CrossRefGoogle Scholar
7Connally, J.A.Brown, S.B.: Micromechanical fatigue testing. Exp. Mech. 33, 81 1993CrossRefGoogle Scholar
8Komai, K., Minoshima, K.Inoue, S.: Fracture fatigue behavior of single crystal silicon microelements and nanoscopic AFM damage evaluation. Microsyst. Technol. 5, 30 1998CrossRefGoogle Scholar
9Muhlstein, C.L., Brown, S.B.Ritchie, R.O.: High-cycle fatigue and durability of polycrystalline silicon thin films in ambient air. Sens. Actuators, A 94, 177 2001CrossRefGoogle Scholar
10Ando, T., Shikida, M.Sato, K.: Tensile-mode fatigue testing of silicon films as structural materials for MEMS. Sens. Actuators, A 93, 70 2001CrossRefGoogle Scholar
11Alsem, D.H., Pierron, O.N., Stach, E.A., Muhlstein, C.L.Ritchie, R.O.: Mechanisms for fatigue of micron-scale silicon structural films. Adv. Eng. Mater. 9, 15 2007CrossRefGoogle Scholar
12Namazu, T.Isono, Y.: High cycle fatigue damage evaluation for micro-nanoscale single crystal silicon under bending and tensile stressing in Micro-Electro-Mechanical Systems 17th IEEE Int. Conf. Proc. New York 2004 149Google Scholar
13Uchic, M.D., Dimiduk, D.M., Florando, J.N.Nix, W.D.: Sample dimensions influence strength and crystal plasticity. Science 305, 986 2004CrossRefGoogle ScholarPubMed
14Wu, B., Heidelberg, A.Boland, J.J.: Mechanical properties of ultrahigh strength gold nanowires. Nat. Mater. 4, 525 2005CrossRefGoogle ScholarPubMed
15Greer, J.R., Oliver, W.C.Nix, W.D.: Size dependence of mechanical properties of gold at the micron scale in the absence of strain gradients. Acta Mater. 53, 1821 2005CrossRefGoogle Scholar
16Demkowicz, M.J.Argon, A.S.: High-density liquidlike component facilitates plastic flow in a model amorphous silicon system. Phys. Rev. Lett. 93, 025505 2004CrossRefGoogle Scholar
17Ye, D-X., Zhao, Y-P., Yang, G-R., Zhao, Y-G., Wang, G-C.Lu, T-M.: Manipulating the column tilt angles of nanocolumnar films by glancing angle deposition. Nanotechnology 13, 615 2002CrossRefGoogle Scholar
18Zhao, Y-P., Ye, D-X., Wang, G-C.Lu, T-M.: Novel nano-column and nano-flower arrays by glancing angle deposition. Nano Lett. 2, 351 2002CrossRefGoogle Scholar
19Ye, D-X., Karabacak, T., Picu, R.C., Wang, G-C.Lu, T-M.: Uniform Si nanostructures grown by oblique angle deposition with substrate swing rotation. Nanotechnology 16, 1717 2005CrossRefGoogle Scholar
20Sader, J.E., Chon, J.W.M.Mulvanev, P.: Calibration of rectangular atomic force microscope cantilevers. Rev. Sci. Instrum. 70, 3967 1999CrossRefGoogle Scholar
21Freund, L.B.Suresh, S.: Thin Film Materials 1st ed.Cambridge University Press Cambridge, UK 2003 96Google Scholar
22Sharpe, W.N. Jr.Bagdahn, J.: Fatigue testing of polysilicon—A review. Mech. Mater. 36, 3 2004CrossRefGoogle Scholar
23Sharpe, W.N. Jr., Jackson, K., Coles, G.LaVan, D.A.: Mechanical properties of different polysilicons in Micro-Electro-Mechanical Systems ASME Int. Mechanical Engineering Congress Expo. 5–10 Orlando, FL 2000 255Google Scholar
24Pierron, O.N., Abnet, C.C.Muhlstein, C.L.: Methodology for low-and high-cycle fatigue characterization with kHz-frequency resonators. Sens. Actuators, A 128, 140 2006CrossRefGoogle Scholar
25Sumino, K.: Deformation behavior of silicon. Metall. Mater. Trans. A 30, 1465 1999CrossRefGoogle Scholar
26Kahn, H., Tayebi, N., Ballarini, R., Mullen, R.L.Heuer, A.H.: Fracture toughness of polysilicon MEMS devices. Sens. Actuators, A 82, 274 2000CrossRefGoogle Scholar
27Chen, T.J.Knapp, W.J.: The fracture of single crystal silicon under several liquid environments. J. Am. Ceram. Soc. 63, 225 1980CrossRefGoogle Scholar
28Gilbert, C.J.Ritchie, R.O.: Mechanisms of cyclic fatigue-crack propagation in a fine-grained alumina ceramic: Role of crack closure. Fatigue Fract. Eng. Mater. Struct. 20, 1453 1997CrossRefGoogle Scholar
29van Arsdell, W.W.Brown, S.B.: Subcritical crack growth in silicon MEMS. J. Microelectromech. Sys. 8, 319 1999CrossRefGoogle Scholar
30Hayes, T.A.Kassner, M.E.: Elastic constants of a-Si and a-Si:H in Properties of Amorphous Si and Its Alloys, edited by Tim Searle INSPEC Publication The Inst. Electrical Engineers, London, UK 1998 359Google Scholar