Hostname: page-component-586b7cd67f-dlnhk Total loading time: 0 Render date: 2024-11-26T06:42:29.105Z Has data issue: false hasContentIssue false

Crystalline Morphologies of Polychloroprene Thin Films as Revealed by Transmission Electron Microscopy Observation

Published online by Cambridge University Press:  31 January 2011

Toshiki Shimizu
Affiliation:
Laboratory of Polymer Condensed States, Division of States and Structures III, Institute for Chemical Research, Kyoto University, Uji, Kyoto-fu 611–0011, Japan
Masaki Tsuji*
Affiliation:
Laboratory of Polymer Condensed States, Division of States and Structures III, Institute for Chemical Research, Kyoto University, Uji, Kyoto-fu 611–0011, Japan
Shinzo Kohjiya
Affiliation:
Laboratory of Polymer Condensed States, Division of States and Structures III, Institute for Chemical Research, Kyoto University, Uji, Kyoto-fu 611–0011, Japan
*
a)Address all correspondence to this author. e-mail: [email protected]
Get access

Abstract

Thin films of polychloroprene (CR; Neoprene-W) were made by casting its solution (2.0 wt%) in benzene onto the water surface, and some of them were stretched by a desired amount of strain (ε) in their “molten” state. The specimens thus prepared were then crystallized and examined by transmission electron microscopy. Morphological observations in bright- and dark-field imaging modes and selected-area electron diffraction analysis revealed directly that filamentous entities observed in the bright-field image are the edge-on lamellar crystals. It was, therefore, confirmed that the morphological results obtained from the thin specimens of CR without any electron staining are basically in accord with those reported so far for the OsO4-stained thin films of CR.

Type
Articles
Copyright
Copyright © Materials Research Society 1999

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1.Nakagawa, T., Gomu-monogatari (Otsukishoten, Tokyo, Japan, 1993).Google Scholar
2.Hamed, G. R., in Engineering with Rubber, edited by Gent, A.N. (Oxford Univ. Press, New York, 1992), Chap. 2, pp. 1415.Google Scholar
3.Gomukogyobinran (Nihon-gomu-kyokai, Tokyo, Japan, 1994).Google Scholar
4.Kohjiya, S., Gomu-zairyokagaku-joron (Nippon Valqua Industries, Ltd., Tokyo, Japan, 1994), pp. 6871.Google Scholar
5.Tanaka, M. and Shimizu, H., J. Soc. Rubber Ind., Jpn. 58, 167 (1985).Google Scholar
6.Maynard, J. T. and Mochel, W. E., J. Polym. Sci. 18, 227 (1955).CrossRefGoogle Scholar
7.Maynard, J. T. and Mochel, W. E., J. Polym. Sci. 13, 235 (1954).CrossRefGoogle Scholar
8.Leitner, M., Trans. Faraday Soc. 51, 1015 (1955).CrossRefGoogle Scholar
9.Coleman, M.M., Rubber Chem. Technol. 51, 668 (1978).CrossRefGoogle Scholar
10.Lucas, V.E., Johnson, P. H., Wakefield, L. B., and Johnson, B. L., Ind. Eng. Chem. 41, 1629 (1949).CrossRefGoogle Scholar
11.Grmela, V. and Megarskaya, L., Polym. Sci. USSR 10, 1196 (1968).CrossRefGoogle Scholar
12.Gent, A.N., J. Polym. Sci.: Part A 3, 3787 (1965).Google Scholar
13.Kargin, V.A., Sogolova, T.I., and Shaposhnikova, T. K., Polym. Sci. USSR 6, 1124 (1964).CrossRefGoogle Scholar
14.Gorbunov, P.M., Polym. Sci. USSR 11, 436 (1969).CrossRefGoogle Scholar
15.Yoshimoto, H., Sagae, S., Matsuo, M., Uemura, S., and Ishida, Y., Kolloid-Z. Z. Polym. 236, 116 (1970).CrossRefGoogle Scholar
16.Andrews, E.H. and Reeve, B., J. Mater. Sci. 6, 547 (1971).CrossRefGoogle Scholar
17.Andrews, E.H., Proc. Roy. Soc. A 277, 562 (1964).Google Scholar
18.Andrews, E.H., Pure Appl. Chem. 31, 91 (1972).CrossRefGoogle Scholar
19.Bunn, C.W., Proc. Roy. Soc. A 180, 40 (1942).Google Scholar
20.Petermann, J. and Gleiter, H., Philos. Mag. 31, 929 (1975).CrossRefGoogle Scholar
21.Shimizu, T., Tsuji, M., and Kohjiya, S., Mater. Sci. Res. Int. 4, 117 (1998).Google Scholar
22.Hosemann, R. and Bagchi, S. N., Direct Analysis of Diffraction by Matter (North-Holland, Amsterdam, The Netherlands, 1962).Google Scholar
23.Andrews, E.H., J. Polym. Sci. 4, 668 (1966).Google Scholar