Hostname: page-component-586b7cd67f-rdxmf Total loading time: 0 Render date: 2024-11-26T13:19:47.188Z Has data issue: false hasContentIssue false
  • English
  • Français

Compressive behavior and deformation-mode map of an open cell aluminaa)

Published online by Cambridge University Press:  31 January 2011

Chuong Q. Dam ,
Rasto Brezny  and
David J. Green
Chuong Q. Dam
Affiliation:
Department of Materials Science and Engineering, The Pennsylvania State University, University Park, Pennsylvania 16802
Rasto Brezny
Affiliation:
Department of Materials Science and Engineering, The Pennsylvania State University, University Park, Pennsylvania 16802
David J. Green
Affiliation:
Department of Materials Science and Engineering, The Pennsylvania State University, University Park, Pennsylvania 16802
Get access

Abstract

Compressive behavior of an open cell, porous ceramic has been examined and compared to a prior theoretical model. The study involved (i) microstructural characterization, (ii) crushing strength and Young's modulus measurements, and (iii) construction of a deformation-mode map. Initially, the crushing behavior was found to be different than predicted theoretically. Weaker struts throughout the material fractured during the loading and this damage was accumulated until a macroscopic crack or cracks propagated through the material at the crushing stress. Further work showed the discrepancy was related to the uniformity of loading in these porous materials. The use of compliant faces on the loading rams improved the loading uniformity, leading to a substantial reduction in the experimental scatter and increasing the likelihood of unstable crack propagation events rather than damage accumulation. Both crushing strength and Young's modulus were found to be dependent on cell size, but this was considered to be a result of strut cracking at the smallest cell size. A deformation-mode map was constructed using the average stress/strain values at critical points such as the onset of crushing, the minimum crushing stress, and the densification stress. Although some of the details of the deformation map were different from that expected theoretically, the map did appear to be a useful guide to the compressive behavior.

Type
Articles
Information
Journal of Materials Research , Volume 5 , Issue 1 , January 1990 , pp. 163 - 171
Copyright
Copyright © Materials Research Society 1990

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Footnotes

a)

Presented at the 90th Annual Meeting of the American Ceramic Society, Cincinnati, OH, May 1988 (Basic Science Division, Paper No. 34-BP-88).

References

REFERENCES

1 Green, D. J., Industrial Materials Science and Engineering, edited by Murr, L. E. (Marcel Dekker, New York, 1984), pp. 123–143.Google Scholar
2 Green, D. J., Fracture Mechanics of Ceramics, edited by Bradt, R. C., Evans, A. G., Hasselman, D. P. H., and Lange, F. F. (Plenum, New York, 1986), Vol. 8, pp. 39–59.CrossRefGoogle Scholar
3 Ashby, M. F., Metall. Trans. A 14A, 1755–1769 (1983).CrossRefGoogle Scholar
4 Gibson, L. J. and Ashby, M. F., Cellular Solids: Structure and Properties (Pergamon Press, Oxford, U.K., 1988).Google Scholar
5 Gibson, L. J. and Ashby, M. F., Proc. R. Soc. London, Ser. A 382 (1782), 43–59 (1982).Google Scholar
6 Hagiwara, H., M. S. Thesis, The Pennsylvania State University (1986).Google Scholar
7 Hagiwara, H. and Green, D. J., J. Am. Ceram. Soc. 70 (11), 811–815 (1987).CrossRefGoogle Scholar
8 Brezny, R. and Green, D. J., J. Am. Ceram. Soc. 72 (7), 1145–1152 (1989).CrossRefGoogle Scholar
9 Maiti, S. K., Gibson, L. J., and Ashby, M. F., Acta Metall. 32, 2963–2975 (1984).CrossRefGoogle Scholar
10 Maiti, S. K., Ashby, M. F., and Gibson, L. J., Scripta Metall. 18, 213–17 (1984).CrossRefGoogle Scholar
11 Annual Book of ASTM Standards, Vol. 08.03, section 8, pp. 156–157, D3576 (1977).Google Scholar
12 Underwood, E. E., Quantitative Stereology (Addison-Wesley Publishing Company, Reading, MA, 1970), pp. 154–155.Google Scholar
13 Brezny, R., Green, D. J., and Dam, C. Q., J. Am. Ceram. Soc. 72 (6), 885–889 (1989).CrossRefGoogle Scholar
14 Schreiber, E., Anderson, O. L., and Soga, N., Elastic Constants and Their Measurements (McGraw-Hill, New York, 1973), pp. 82–125.Google Scholar
15 Brezny, R. (unpublished results).Google Scholar