Hostname: page-component-586b7cd67f-rdxmf Total loading time: 0 Render date: 2024-11-26T18:01:21.216Z Has data issue: false hasContentIssue false
  • English
  • Français

Synthesis of Ni-based bulk metallic glass matrix composites containing ductile brass phase by warm extrusion of gas atomized powders

Published online by Cambridge University Press:  31 January 2011

M. H. Lee ,
D. H. Bae ,
D. H. Kim  and
D. J. Sordelet
M. H. Lee
Affiliation:
Center for Non-Crystalline Materials, Department of Metallurgical Engineering, Yonsei University, Seoul, 120–749, Korea
D. H. Bae
Affiliation:
Center for Non-Crystalline Materials, Department of Metallurgical Engineering, Yonsei University, Seoul, 120–749, Korea
D. H. Kim*
Affiliation:
Center for Non-Crystalline Materials, Department of Metallurgical Engineering, Yonsei University, Seoul, 120–749, Korea
D. J. Sordelet
Affiliation:
Ames Laboratory, Iowa State University, Ames, Iowa 50014
*
a) Address all correspondence to this author. e-mail: [email protected]
Get access

Abstract

To prevent catastrophic failure by propagating highly localized shear bands and to overcome the limited dimension of metallic glass, centimeter-scale Ni59Zr20Ti16Si2Sn3 bulk metallic glass matrix composites were fabricated by warm extrusion of a mixture of gas-atomized fully amorphous powders and ductile brass powders. After consolidation, the composite retained the fully amorphous matrix found in the gas-atomized powder combined with the brass second phase. The glass-transition and crystallization temperatures of the extruded material were the same as those of the starting powders. The confined ductile brass phase enabled the bulk metallic glass matrix composites to deform plastically under uniaxial compression at room temperature. The combination of strength and ductility in the inherently brittle Ni-based monolithic materials could be obtained by introducing a ductile phase in the bulk metallic glass matrix. However, control of the volume fraction and distribution of the ductile brass phase was important for the proper combination of the strength and plasticity.

Type
Articles
Information
Journal of Materials Research , Volume 18 , Issue 9 , September 2003 , pp. 2101 - 2108
Copyright
Copyright © Materials Research Society 2003

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1.He, G., Eckert, J., and Löser, W., Acta Mater. 51, 1630 (2003).Google Scholar
2.He, G., Eckert, J., Löser, W., and Schultz, L., Nature Mater. 2, 33 (2003).CrossRefGoogle Scholar
3.Choi-Yim, H., Busch, R., Koster, U., and Johnson, W.L., Acta Mater. 47, 2455 (1999).CrossRefGoogle Scholar
4.Kim, C.P., Busch, R., Masuhr, A., Choi-Yim, H., and Johnson, W.L., Appl. Phys. Lett. 79, 1456 (2001).CrossRefGoogle Scholar
5.Fan, C., Ott, R.T., and Hufnagel, T.C., Appl. Phys. Lett. 81, 1020 (2002).CrossRefGoogle Scholar
6.He, G., Löser, W., and Eckert, J., Scripta Mater. 48, 1531 (2003).CrossRefGoogle Scholar
7.Hays, C.C., Kim, C.P., and Johnson, W.L., Phys. Rev. Lett. 84, 2901 (2000).CrossRefGoogle Scholar
8.Szuecs, F., Kim, C.P., and Johnson, W.L., Acta Mater. 49, 1507 (2001).CrossRefGoogle Scholar
9.He, G., Löser, W., Eckert, J., and Schultz, L., J. Mater. Res. 17, 3015 (2002).CrossRefGoogle Scholar
10.Kawamura, Y., Kato, H., Inoue, A., and Masumoto, T., Int. J. Powder Metall. 30, 50 (1997).Google Scholar
11.Zhang, T. and Inoue, A., Mater. Trans. JIM 40, 301 (1999).CrossRefGoogle Scholar
12.Kim, Y.C., Yi, S., Kim, W.T., and Him, D.H., Mater. Sci. Forum 360–362, 67 (2001).CrossRefGoogle Scholar
13.Lin, X.H. and Johnson, W.L., J. Appl. Phys. 78, 6514 (1995).CrossRefGoogle Scholar
14.Wang, X., Yoshii, I., Inoue, A., Kim, Y.H., and Kim, I.B., Mater. Trans. JIM 40, 1130 (1999).CrossRefGoogle Scholar
15.Yi, S., Park, T.G., and Kim, D.H., J. Mater. Res. 15, 2429 (2000).Google Scholar
16.Sordelet, D.J., Rozhkova, E., Huang, P., Wheelock, P.B., Besser, M.F., Kramer, M.J., Calvo-Dahlborg, M., and Dahlborg, U., J. Mater. Res. 17, 186 (2002).CrossRefGoogle Scholar
17.Lee, M.H., Bae, D.H., Kim, W.T., Kim, D.H., and Sordelet, D.J., J. Non-Cryst. Solids 315, 89 (2003).CrossRefGoogle Scholar
18.Lee, J.K., Yi, S., Kim, W.T., and Kim, D.H., (unpublished, 2003).Google Scholar
19.Leng, Y. and Courtney, T.H., J. Mater. Sci. 24, 2006Google Scholar