Hostname: page-component-586b7cd67f-2brh9 Total loading time: 0 Render date: 2024-11-23T07:24:25.876Z Has data issue: false hasContentIssue false

Production of granulated-copper oxide nanoparticles for catalytic application

Published online by Cambridge University Press:  31 January 2011

M. Hosseinpour
Affiliation:
School of Energy Engineering, Sharif University of Technology, Tehran, Iran
S.J. Ahmadi
Affiliation:
Jaber Ebne Hayyan Research Laboratory, NSTRI, Tehran, Iran
T. Mousavand
Affiliation:
Department of Mechanical Engineering, McGill University, Montréal, Québec H3A 2K6, Canada
M. Outokesh*
Affiliation:
School of Energy Engineering, Sharif University of Technology, Tehran, Iran
*
a)Address all correspondence to this author. e-mail: [email protected];[email protected]
Get access

Abstract

Ultra fine CuO nanoparticles in the range of 2 ± 0.2 nm were synthesized by the supercritical hydrothermal method in a batch reactor. It was demonstrated that elevating the pH of the Cu2+ precursor solution to around 6 (neutral condition) not only does not lead to excessive agglomeration of the particles, but also reduces particle size and in general promotes their nanoscale characteristics. Prepared nanoparticles were immobilized in the biopolymeric matrix of barium alginate and calcined at different temperatures resulting in microspherical granules of high porosity and elevated mechanical strength. The fabricated samples were characterized using x-ray diffractometry (XRD), transmission and scanning electron microscopy (TEM and SEM), nitrogen adsorption analysis (BET), mechanical testing, and temperature programmed reduction (TPR). It was found that topochemical models based on a nucleation growth mechanism fail in proper fitting of the TPR data. Instead, a generalized Sestak model in which different physicochemical mechanisms such as the mass action law are taken into account gives a satisfactory regression of the kinetics behavior.

Type
Articles
Copyright
Copyright © Materials Research Society 2010

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1.Warren, C.W., Nie, S.Quantum dot bioconjugates for ultrasensitive nonisotopic detection. Science 281, 2016 (1998)Google Scholar
2.Chowdhuri, A., Gupta, V., Sreenivas, K.Response speed of SnO2-based H2S gas sensors with CuO nanoparticles. Appl. Phys. Lett. 84, 1180 (2004)CrossRefGoogle Scholar
3.Zhou, R.X., Yu, T.M., Jiang, X.Y., Chen, F., Zheng, X.M.Temperature-programmed reduction and temperature programmed desorption studies of CuO/ZrO2 catalysts. Appl. Surf. Sci. 148, 263 (1999)CrossRefGoogle Scholar
4.She, Y., Zheng, Q., Li, L., Zhan, Y., Chen, Ch., Zheng, Y., Lin, X.Rare earth oxide modified CuO/CeO2 catalysts for the water-gas shift reaction. Int. J. Hydrogen Energy 34, 8929 (2009)CrossRefGoogle Scholar
5.Udani, P.P.C., Gunawardana, P.V.D.S., Lee, H.C., Kim, D.H.Steam reforming and oxidative steam reforming of methanol over CuO-CeO2 catalysts. Int. J. Hydrogen Energy 34, 7648 (2009)CrossRefGoogle Scholar
6.Cao, J.L., Shao, G.S., Wang, Y., Liu, Y., Yuan, Z.Y.CuO catalysts supported on attapulgite clay for low-temperature CO oxidation. Catal. Commun. 9, 2555 (2008)CrossRefGoogle Scholar
7.Lia, C.C., Chang, M.H.Colloidal stability of CuO nanoparticles in alkanes via oleate modifications. Mater. Lett. 58, 3903 (2004)CrossRefGoogle Scholar
8.Malandrino, G., Finocchiaro, S.T., Nigro, R.L.Free-standing copper(II) oxide nanotube arrays through an MOCVD template. Chem. Mater. 16, 5559 (2004)CrossRefGoogle Scholar
9.Gao, X.P., Bao, J.L., Pan, G.L.Preparation and electrochemical performance of polycrystalline and single crystalline CuO nanorods as anode materials for Li ions battery. J. Phys. Chem. B 108, 5547 (2004)CrossRefGoogle Scholar
10.Vijaya, K.R., Elgamiel, R., Diamant, Y.Sonochemical preparation and characterization of nanocrystalline copper oxide embedded in poly (vinyl alcohol) and its effect on crystal growth of copper oxide. Langmuir 17, 1406 (2001)CrossRefGoogle Scholar
11.Carnes, C.L., Stipp, J., Klabunde, K.J.Synthesis, characterization, and adsorption studies of nanocrystalline copper oxide and nickel oxide. Langmuir 18, 1352 (2002)CrossRefGoogle Scholar
12.Wang, W.Z., Zhan, Y.J., Wang, G.H.One-step, solid-state reaction to the synthesis of copper oxide nanorods in the presence of a suitable surfactant. Chem. Commun. 13, 727 (2001)CrossRefGoogle Scholar
13.Neil, A.O., Watkins, J.J.Fabrication of device nanoparticles using supercritical fluids. MRS Bull. 30, 967 (2005)CrossRefGoogle Scholar
14.Adschiri, T., Hakuta, Y., Arai, K.Hydrothermal synthesis of metal oxide fine particles at supercritical conditions. Ind. Eng. Chem. Res. 39, 4901 (2000)CrossRefGoogle Scholar
15.Mousavand, T., Ohara, S., Umetsu, M., Zhang, J., Takami, S., Naka, T., Adschiri, T.Hydrothermal synthesis and in situ surface modification of boehmite nanoparticles in supercritical water. J. Super Crit. Flu. 40, 397 (2007)CrossRefGoogle Scholar
16.Adschiri, T., Kanazawa, K., Arai, K.Rapid and continuous hydrothermal crystallization of metal oxide particles in supercritical water. J. Am. Ceram. Soc. 75, 1019 (1992)CrossRefGoogle Scholar
17.Adschiri, T., Hakuta, Y., Sue, K., Arai, K.Hydrothermal synthesis of metal oxide nanoparticles at supercritical conditions. J. Nanopart. Res. 3, 227 (2001)CrossRefGoogle Scholar
18.Hakuta, Y., Onai, S., Terayama, S., Adschiri, T., Arai, K.Production of ultra-fine ceria particles by hydrothermal synthesis under supercritical conditions. J. Mater. Sci. Lett. 17, 1211 (1998)CrossRefGoogle Scholar
19.Hakuta, Y., Seino, K., Ura, H., Adschiri, T., Takizawa, H., Arai, K.Production of phosphor (YAG:Tb) fine particles by hydrothermal synthesis in supercritical water. J. Mater. Chem. 9, 2671 (1999)CrossRefGoogle Scholar
20.Hakuta, Y., Haganuma, T., Sue, K., Adschiri, T., Arai, K.Continuous production of phosphor YAG:Tb nanoparticles by hydrothermal synthesis in supercritical water. Mater. Res. Bull. 38, 1257 (2003)CrossRefGoogle Scholar
21.Hakuta, Y., Hayashi, H., Arai, K.Hydrothermal synthesis of photocatalyst potassium hexatitanate nanowires under supercritical conditions. J. Mater. Sci. 39, 4977 (2004)CrossRefGoogle Scholar
22.Torre, M.L., Faustini, M., Norberti, R., Maggi, L., Maffeo, G., Conte, U., Vigo, D.Barium alginate cell delivery systems: Correlation between technological parameters. Int. J. Pharm. 242, 389 (2002)CrossRefGoogle ScholarPubMed
23.Jafari Nejad, Sh., Abolghasemi, H., Moosavian, M.A., Golzary, A., Maragheh, M.G.Fractional factorial design for the optimization of hydrothermal synthesis of lanthanum oxide nanoparticles under supercritical water condition. J. Supercrit. Fluids 52, 292 (2010)Google Scholar
24.Skoog, D.A., West, D.M.Principles of Instrumental Analysis 3rd ed. (Holt-Saunders, Tokyo 1987) 391426Google Scholar
25.Outokesh, M., Mimura, H., Niibori, Y., Tanaka, K.Preparation of stable alginate microcapsules coated with chitosan or poly-ethyleneimine for extraction of heavy metal ions. J. Microencapsul. 23, 291 (2006)CrossRefGoogle ScholarPubMed
26.Tayyebi, A., Khanchi, A.R., Ghofrani, M.B., Outokesh, M.Synthesis and characterization of a bentonite-alginate microspherical adsorbent for removal of uranium from aqueous solutions. Sep. Sci. Technol. 45, 1 (2010)CrossRefGoogle Scholar
27.Kim, J.Y., Hanson, J.C., Frenkel, A.I., Lee, P.L., Rodriguez, J.A.Reaction of CuO with hydrogen studied by using synchrotron-based x-ray diffraction. J. Phys. Condens. Matter 16, 3479 (2004)CrossRefGoogle Scholar
28.Brown, M.E., Dollimore, D., Galwey, A.K.Reactions in the solid stateComprehensive Chemical Kinetics Vol. 22 edited by C.H. Bamford and C.F.H. Tipper (Elsevier, Amsterdam 1980)340Google Scholar
29.Galwey, A.K., Brown, M.E.Application of the Arrhenius equation to solid state kinetics: Can this be justified? Thermochim. Acta 386, 91 (2002)CrossRefGoogle Scholar
30.Kissinger, H.E.Reaction kinetics in differential thermal analysis. Anal. Chem. 29, 1702 (1957)CrossRefGoogle Scholar
31.Bhatia, V., Beltramini, I.Temperature-programmed analysis and its applications in catalytic systems. Catal. Today 7, 309 (1990)CrossRefGoogle Scholar
32.Sestak, J., Satava, V., Wendlandt, W.W.The study of heterogeneous processes by thermal analysis. Thermochim. Acta 7, 333 (1973)CrossRefGoogle Scholar
33.Munteanu, G.Kinetics of temperature programmed reduction of Fe3O4 promoted with copper: Application of iso-conversional methods. J. Mater. Sci. 38, 1995 (2003)CrossRefGoogle Scholar
34.Charkhi, A., Kazemeini, M., Ahmadi, S.J., Kazemian, H.Application of NaY nanozeolite for the Sr2+ uptake from an industrial effluent (19th Cong. of Chem. Eng., Prague, Czech Republic 2010)Google Scholar
35.Otsu, J., Oshima, Y.New approaches to the preparation of metal or metal oxide particles on the surface of porous materials using supercritical water: Development of supercritical water impregnation method. J. Supercrit. Fluids 33, 61 (2005)Google Scholar