Hostname: page-component-78c5997874-8bhkd Total loading time: 0 Render date: 2024-11-05T16:00:46.576Z Has data issue: false hasContentIssue false
  • English
  • Français

Preparation of boron and phosphorus-doped SiC :H films using electron cyclotron resonance chemical vapor deposition: Some effects of microwave power

Published online by Cambridge University Press:  26 July 2012

S. F. Yoon ,
R. Ji  and
J. Ahn
S. F. Yoon
Affiliation:
School of Electrical and Electronic Engineering, Nanyang Technological University, Nanyang Avenue, Singapore 639798, Republic of Singapore
R. Ji
Affiliation:
School of Electrical and Electronic Engineering, Nanyang Technological University, Nanyang Avenue, Singapore 639798, Republic of Singapore
J. Ahn
Affiliation:
School of Electrical and Electronic Engineering, Nanyang Technological University, Nanyang Avenue, Singapore 639798, Republic of Singapore
Get access

Extract

Hydrogenated silicon carbide films (SiC :H) were deposited using the electron cyclotron resonance chemical vapor deposition (ECR-CVD) technique from a mixture of methane, silane, and hydrogen, and using diborane and phosphine as doping gases. The effects of changes in the microwave power on the deposition rate and optical band gap were investigated, and variations in the photo- and dark-conductivities and activation energy were studied in conjunction with film analysis using the Raman scattering technique. In the case of boron-doped samples, the conductivity increased rapidly to a maximum, followed by rapid reduction at high microwave powers. The ratio of the photo- to dark-conductivity (σph/σd) peaked at microwave power of ∼600 W. Under conditions of high microwave power, Raman scattering analysis showed evidence of the formation and increase in the silicon microcrystalline and diamond-like phases in the films, the former of which could account for the rapid increase and the latter the subsequent decrease in the conductivity. In the case of phosphorus-doped SiC :H samples, it was found that increase in the microwave power has the effect of enhancing the formation of the silicon microcrystalline phase in the films which occurred in correspondence to a rapid increase in the conductivity and reduction in the activation energy. The conductivity increase stabilized in samples deposited at microwave powers exceeding 500 W probably as a result of dopant saturation. Results from Raman scattering measurements also showed that phosphorus doping has the effect of enhancing the formation of the silicon microcrystals in the film whereas the presence of boron has the effect of preserving the amorphous structure.

Type
Articles
Information
Journal of Materials Research , Volume 14 , Issue 1 , January 1999 , pp. 29 - 38
Copyright
Copyright © Materials Research Society 1999

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1.Futagi, T., Katsuno, M., Ohtani, N., Ohta, Y., Mimura, H., and Kawamura, K., Appl. Phys. Lett. 58, 2948 (1991).CrossRefGoogle Scholar
2.Carreno, M. N. P., Pereyra, I., Fantini, M. C. A., Takahashi, H., and Landers, R., J. Appl. Phys. 75 (1), 538 (1994).CrossRefGoogle Scholar
3.Han, S.Z., Lee, H.M., and Kwon, H.S., J. Non-Cryst. Solids 170, 199 (1994).CrossRefGoogle Scholar
4.Demichelis, F., Crovini, G., Giorgis, F., Pirri, C. F., and Tresso, E., Diamond Rel. Mater. 4, 473 (1995).CrossRefGoogle Scholar
5.Wang, C., Lucovsky, G., and Nemanich, R. J., in Amorphous Silicon Technology—1991, edited by Madan, A., Hamakawa, Y., Thompson, M., Taylor, P.C., and LeComber, P.G. (Mater. Res. Soc. Symp. Proc. 219, Pittsburgh, PA, 1991), p. 751.Google Scholar
6.Demichelis, F., Pirri, C. F., and Tresso, E., J. Appl. Phys. 72 (4), 1327 (1992).CrossRefGoogle Scholar
7.Kruangam, D., Toyama, T., Hattori, Y., Deguchi, M., Okamoto, H., and Hamakawa, Y., J. Non-Cryst. Solids 97 & 98, 293 (1987).CrossRefGoogle Scholar
8.Hattori, Y., Kruangam, D., Toyama, T., Okamoto, H., and Hamakawa, Y., J. Non-Cryst. Solids 97 & 98, 1079 (1987).CrossRefGoogle Scholar
9.Mimura, H., Futagi, T., Matsumoto, T., Katsuno, M., Ohta, Y., and Kitamura, K., Appl. Surf. Sci. 65 & 66, 473 (1993).Google Scholar
10.Miyajima, T., Sasaki, K., and Furukawa, S., Proc. 4th Int. Conf. on Amorphous and Crystalline Silicon Carbide (1992) p. 281.Google Scholar
11.Essick, J. M., Pool, F. S., Shing, Y. H., and Holboke, M. J., in Amorphous Silicon Technology—1991, edited by Madan, A., Hamakawa, Y., Thompson, M., Taylor, P.C., and LeComber, P.G. (Mater. Res. Soc. Symp. Proc. 219, Pittsburgh, PA, 1991), p. 679.Google Scholar
12.Lucovsky, G. and Wang, C., in Amorphous Silicon Technology—1991, edited by Madan, A., Hamakawa, Y., Thompson, M., Taylor, P.C., and LeComber, P. G. (Mater. Res. Soc. Symp. Proc. 219, Pittsburgh, PA, 1991), p. 377.Google Scholar
13.Hattori, Y., Kruangam, D., Katoh, K., Nitta, Y., Okamoto, H., and Hamakawa, Y., Proc. 19th IEEE Photovoltaic Specialists Conference (The Institution of Electrical and Electronic Engineers, New York, 1987) p. 698.Google Scholar
14.Sah, W.J. and Lee, S. C., Amorphous and Crystalline Silicon Carbide II (Springer-Verlag, Berlin, Germany, 1989), p. 85.Google Scholar
15.Tauc, J., in Amorphous and Liquid Semiconductors (Plenum Press, New York), Chap. 4.Google Scholar
16.Beyer, W. and Overhof, H., Semiconductors and Semimetals, edited by Pankove, J. I. (Academic Press, New York, 1984), Vol. 21C, p. 257.Google Scholar
17.Street, R.A., Philos. Mag. B37, 35 (1978).CrossRefGoogle Scholar
18.Solomon, I., Schmidt, M. P., and Tran-Quoc, H., Phys. Rev. B 38, 9895 (1988).CrossRefGoogle Scholar
19.Saha, S.C. and Ray, S., J. Appl. Phys. 78 (9), 5713 (1995).CrossRefGoogle Scholar
20.Adler, D., Phys. Rev. Lett. 41, 1755 (1978).Google Scholar
21.Adler, D., Physical Properties of Amorphous Materials, edited by Adler, D., Schwartz, B., and Steele, M. (Plenum Press, New York, 1985), p. 5.Google Scholar
22.Adler, D., Semiconductors and Semimetals, edited by Pankove, J. I. (Academic Press, New York, 1984), Vol. 21A.Google Scholar
23.Hamasaki, T., Ueda, M., Osaka, Y., and Hirose, M., J. Non-Cryst. Solids 59–60, 811 (1983).CrossRefGoogle Scholar