Hostname: page-component-cd9895bd7-fscjk Total loading time: 0 Render date: 2024-12-23T13:13:33.322Z Has data issue: false hasContentIssue false
  • English
  • Français

Optimization of synthesis of the solid solution, Pb(Zr1–xTix)O3 on a single substrate using a high-throughput modified molecular-beam epitaxy technique

Published online by Cambridge University Press:  31 January 2011

P.S. Anderson ,
S. Guerin ,
B.E. Hayden ,
Y. Han ,
M. Pasha ,
K.R. Whittle  and
I.M. Reaney
P.S. Anderson
Affiliation:
Ilika Technologies Ltd., University of Southampton Science Park, Chilworth, Southampton, SO16 7NS, United Kingdom
S. Guerin
Affiliation:
Ilika Technologies Ltd., University of Southampton Science Park, Chilworth, Southampton, SO16 7NS, United Kingdom
B.E. Hayden
Affiliation:
School of Chemistry, University of Southampton, Southampton, SO17 1BJ, United Kingdom
Y. Han
Affiliation:
Department of Engineering Materials, University of Sheffield, Sheffield, S1 3JD, United Kingdom
M. Pasha
Affiliation:
Department of Engineering Materials, University of Sheffield, Sheffield, S1 3JD, United Kingdom
K.R. Whittle
Affiliation:
Department of Engineering Materials, University of Sheffield, Sheffield, S1 3JD, United Kingdom
I.M. Reaney*
Affiliation:
Department of Engineering Materials, University of Sheffield, Sheffield, S1 3JD, United Kingdom
*
a) Address all correspondence to this author. e-mail: [email protected]
Get access

Abstract

Synthesis of Pb(Zr1–xTix)O3 (PZT) on a single substrate using a high-throughput molecular-beam epitaxy technique was demonstrated. In situ synthesis of crystalline PZT at elevated substrate temperatures could not be achieved, as reevaporation of Pb (PbO) occurred and the partial pressure of O2 was insufficient to prevent formation of a PbPtx phase during deposition. Instead, ex situ postdeposition annealing was performed on PZT deposited at room temperature. Dense single phase PZT was prepared with a compositional range of 0.1 > x > 0.9, for film thicknesses up to 800 nm. Transmission electron microscopy revealed the grain size increased from 50 nm to ∼0.5 μm with increasing Zr-concentration and became more columnar. Raman, x-ray diffraction, and scanning electron microscopy/energy dispersive spectroscopy results revealed a morphotropic phase boundary between rhombohedral and tetragonal phases occurred at x ∼0.4 rather than at x = 0.47 in bulk ceramics. This was attributed to clamping arising from mismatch in thermal expansion between the film and substrate.

Keywords

Combinatorial synthesisMolecular-beam epitaxy (MBE)Piezoelectric
Type
Articles
Information
Journal of Materials Research , Volume 24 , Issue 1 , January 2009 , pp. 164 - 172
Copyright
Copyright © Materials Research Society 2009

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1.Tu, Y.L., Calzada, M.L., Phillips, N.J., Milne, S.J.: Synthesis and electrical characterization of thin films of PT and PZT made from a diol-based sol-gel route. J. Am. Ceram. Soc. 79, 441 1996CrossRefGoogle Scholar
2.Reaney, I.M., Brooks, K., Klissurska, R., Pawlaczyck, C., Setter, N.: Use of transmission electron microscopy for the characterization of rapid thermally annealed, solution-gel, lead zirconate titanate film. J. Am. Ceram. Soc. 77, 1209 1994CrossRefGoogle Scholar
3.Iijima, K., Ueda, I., Kugimiya, K.: Preparation and properties of lead zirconate-titanate thin films. Jpn. J. Appl. Phys. 30, 2149 1991CrossRefGoogle Scholar
4.Bouregba, R., Poullain, G., Vilquin, B., Murray, H.: Orientation control of textured PZT thin films sputtered on silicon substrate with TiOx seeding. Mater. Res. Bull. 35, 1381 2000CrossRefGoogle Scholar
5.Zhu, T.J., Lu, L., Lai, M.O.: Pulsed laser deposition on lead-zirconate-titanate thin films and multilayered heterostructures. Appl. Phys. A 81, 701 2004CrossRefGoogle Scholar
6.Sakashita, Y., Ono, T., Segawa, H., Tominaga, K., Okada, M.: Preparation and electrical properties of MOCVD-deposited PZT thin films. J. Appl. Phys. 69, 8352 1991CrossRefGoogle Scholar
7.Guerin, S., Hayden, B.E., Lee, C.E., Mormiche, C., Russell, A.E.: High-throughput synthesis and screening of ternary metal alloys for electrocatalysis. J. Phys. Chem. B 110, 14355 2006CrossRefGoogle ScholarPubMed
8.Guerin, S., Hayden, B.E.: Physical vapor deposition method for the high-throughput synthesis of solid-state materials libraries. J. Comb. Chem. 8, 66 2006Google Scholar
9.Anderson, P.S., Guerin, S., Hayden, B.E., Khan, M.A., Bell, A.J., Han, Y., Pasha, M., Whittle, K.R., Reaney, I.M.: Synthesis of the ferroelectric solid solution, Pb(Zr1–xTix)O3 on a single substrate using a modified molecular beam epitaxy technique. Appl. Phys. Lett. 90, 202907 2007CrossRefGoogle Scholar
10.Tu, Y.L., Milne, S.J.: Characterization of single layer PZT (53/47) films prepared from an air-stable sol-gel route. J. Mater. Res. 10, 3222 1995CrossRefGoogle Scholar
11.Kaewchinda, D., Chairaungsri, T., Naksata, M., Milne, S.J., Brydson, R.: TEM characterisation of PZT films prepared by a diol route on platinised silicon substrates. J. Eur. Ceram. Soc. 20, 1277 2000Google Scholar
12.Otani, Y., Abe, N., Okamura, S., Shiosaki, T.: Influence of post-annealing on the characteristics of Pb(Zr,Ti)O3 thin films deposited by liquid delivery MOCVD using a cocktail solution. Integr. Ferroelectr. 59, 1475 2003Google Scholar
13.Otani, Y., Okamura, S., Shiosaki, T.: Fabrication of ferroelectric Pb(Zr,Ti)O3 thin films by liquid delivery metalorganic chemical vapor deposition using a novel titanium source Ti(OEt)2 (DPM)2. Jpn. J. Appl. Phys. 45, 1752 2006CrossRefGoogle Scholar
14.Mochizuki, S., Mihara, T., Ishida, T.: Auger analysis of PbTiO3 films prepared by reactive electron beam coevaporation. Ferroelectrics 225, 237 1999CrossRefGoogle Scholar
15.Tani, T., Payne, D.A.: Lead oxide coatings on sol-gel-derived lead lanthanum zirconium titanate thin layers for enhanced crystallization into the perovskite structure. J. Am. Ceram. Soc. 77, 1242 1994CrossRefGoogle Scholar
16.Chen, S.Y., Chen, I.W.: Temperature-time texture transition of Pb(Zr1–xTix)O3 thin films: II. Heat treatment and compositional effects. J. Am. Ceram. Soc. 77, 2337 1994CrossRefGoogle Scholar
17.Atsuki, T., Soyama, N., Sasaki, G., Yonezawa, T., Ogi, K., Sameshima, K., Hoshiba, K., Nakao, Y., Kamisawa, A.: Surface morphology of lead-based thin films and their properties. Jpn. J. Appl. Phys. 33, 5196 1994CrossRefGoogle Scholar
18.Reaney, I.M., Brooks, K.G., Klissurska, R., Pawlaczyk, C., Setter, N.: Use of transmission electron microscopy for the characterization of rapid thermally annealed, solution-gel, lead zirconate titanate films. J. Am. Ceram. Soc. 77, 1209 1994CrossRefGoogle Scholar
19.Brooks, K.G., Reaney, I.M., Klissurska, R., Huang, Y., Bursill, L., Setter, N.: Orientation of rapid thermally annealed lead zirconate titanate thin films on (111) Pt substrates. J. Mater. Res. 9, 2540 1994CrossRefGoogle Scholar
20.Reaney, I.M., Taylor, D.V., Brooks, K.G.: Ferroelectric PZT thin films by sol-gel deposition. J. Sol-Gel. Sci. Technol. (Paris) 13, 813 1998Google Scholar
21.Wu, A., Vilarinho, P.M., Reaney, I.M., Miranda Salvado, I.M.: Early stages of crystallization of sol-gel-derived lead zirconate titanate thin films. Chem. Mater. 15, 1147 2003CrossRefGoogle Scholar
22.Tancret, N., Obbade, S., Bettahar, N., Abraham, F.: Synthesis and ab initio structure determination from powder x-ray diffraction data of a new metallic mixed-valence platinum-lead oxide PbPt2O4. J. Solid State Chem. 124, 309 1996Google Scholar
23.Obbade, S., Tancret, N., Abraham, F., Suard, E.: Synthesis, electrical properties, and powder neutron crystal structure refinement of Pb1–xBixPt2O4 compounds (0 9 x 9 0.3). J. Solid State Chem. 166, 58 2002CrossRefGoogle Scholar
24.Renard, C., Roussel, P., Rubbens, A., Daviero-Minaud, S., Abraham, F.: Sr4PbPt4O11, the first platinum oxide containing Pt26+ ions. J. Solid State Chem. 179, 2101 2006Google Scholar
25.Denton, A.R., Ashcroft, N.W.: Vegard's law. Phys. Rev. A 43, 63161 1991Google Scholar
26.Choi, S., Heo, J., Kim, D., Chung, I.: Ferroelectric properties of nano-size PZT grains determined by surface potential utilizing Kelvin force microscopy. Thin Solid Films 464465 277, 2004Google Scholar
27.Chen, Y.C., Liang, C.S., Wu, J.M., Yeh, T.S., Hu, L.J.: Sol-gel derived Pb(Zr,Ti)O3 heterolayered films by single-annealing. Jpn. J. Appl. Phys. 42, L542 2003CrossRefGoogle Scholar
28.Fujii, T., Arata, M., Miyaji, S., Adachi, M.: Preparation of Zr-rich Pb(Zr,Ti)O3 films by sol-gel technique. Ferroelectrics 270, 1189 2002CrossRefGoogle Scholar