Hostname: page-component-586b7cd67f-rdxmf Total loading time: 0 Render date: 2024-11-30T05:54:31.990Z Has data issue: false hasContentIssue false
  • English
  • Français

Minor additions of Sn in a bulk glass-forming Fe-based system

Published online by Cambridge University Press:  03 March 2011

Z.P. Lu ,
C.T. Liu  and
X.Z. Wang
Z.P. Lu*
Affiliation:
Metals and Ceramic Division, Oak Ridge National Laboratory, Oak Ridge, Tennessee 37830-6115
C.T. Liu
Affiliation:
Department of Materials Science and Engineering, University of Tennessee, Knoxville, Tennessee 37996
X.Z. Wang
Affiliation:
Department of Materials Science and Engineering, University of Tennessee, Knoxville, Tennessee 37996
*
a) Address all correspondence to this author. e-mail: [email protected]
Get access

Abstract

Minor additions of Sn in the bulk glass-forming Fe61−xSnxY2Zr8Co5Cr2Mo7B15 (x = 0% to 2%) system were studied in detail. It was found that combinations of Y and Sn can scavenge oxygen out of the undercooled liquids to form innocuous oxides, thus stabilizing the liquids. Besides this beneficial scavenging effect, Sn additions in the present Fe-based alloys also showed complex alloying effects on glass formation, which can be divided into three stages. At stage I (x ≤ 0.5%), the microalloyed compositions associate with the same eutectic as that of the base alloy. The glass-forming ability (GFA) of the resulting alloys is determined primarily by their liquidus temperature and similar to that of the base alloy. At stage II (0.85% ≤ x ≤ 1.15%), glass-matrix composite structures start to form because the alloy compositions are adjusted into a new “deeper” eutectic system. At stage III (x > 1.15%), however, alloy compositions shift to another new eutectic system, and the GFA is dramatically decreased due to the strong formation of primary phase α–Fe. Homogeneous glass-matrix composites with a diameter of 7 mm in the alloy containing 1.0–1.15% Sn were successfully produced.

Keywords

AmorphousPhase transformation
Type
Articles
Information
Journal of Materials Research , Volume 21 , Issue 12 , December 2006 , pp. 3180 - 3186
Copyright
Copyright © Materials Research Society 2006

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1.Liu, C.T., Lu, Z.P.: Effect of minor alloying additions on glass formation in bulk metallic glasses. Intermetallics 13, 415 (2005).CrossRefGoogle Scholar
2.Lu, Z.P., Liu, C.T.: Role of minor alloying additions in formation of bulk metallic glasses: A review. J. Mater. Sci. 39, 3965 (2004).CrossRefGoogle Scholar
3.Wang, W.H., Bian, Z., Wen, P., Zhang, Y., Pan, M.X., Zhao, D.Q.: Role of addition in formation and properties of Zr-based bulk metallic glasses. Intermetallics 10, 1249 (2002).CrossRefGoogle Scholar
4.Choi-Yim, H., Busch, R., Johnson, W.L.: The effect of silicon on the glass forming ability of the Cu47Ti34Zr11Ni8 bulk metallic glass forming alloy during processing of composites. J. Appl. Phys. 83, 7993 (1998).CrossRefGoogle Scholar
5.Liu, C.T., Chisholm, M.F., Miller, M.K.: Oxygen impurity and microalloying effect in a Zr-based bulk metallic glass alloy. Intermetallics 10, 1105 (2002).CrossRefGoogle Scholar
6.Kundig, A.A., Lepori, D., Perry, A.J., Rossmann, S., Blatter, A., Dommann, A., Uggowitzer, P.J.: Influence of low oxygen contents and alloy refinement on the glass forming ability of Zr52.5Cu17.9Ni14.6Al10Ti5. Mater. Trans. 43, 3206 (2002).Google Scholar
7.Lu, Z.P., Liu, C.T., Porter, W.D.: Role of yttrium in glass formation of Fe-based bulk metallic glasses. Appl. Phys. Lett. 83, 2581 (2003).CrossRefGoogle Scholar
8.Lu, Z.P., Liu, C.T.: Bulk glass formation in an Fe-based Fe–Y–Zr–M (M = Cr, Co, Al) –Mo–B system. J. Mater. Res. 19, 921 (2004).CrossRefGoogle Scholar
9.Choi-Yim, H., Xu, D., Johnson, W.L.: Ni-based bulk metallic glass formation in the Ni–Nb–Sn and Ni–Nb–Sn–X (X = B,Fe,Cu) alloy systems. Appl. Phys. Lett. 82, 1030 (2003).CrossRefGoogle Scholar
10.Zhang, Q.S., Zhang, H.F., Deng, Y.F., Ding, B.Z., Hu, Z.Q.: Bulk metallic glass formation of Cu–Zr–Ti–Sn alloys. Scripta Mater. 49, 273 (2003).CrossRefGoogle Scholar
11.Park, E.S., Lim, H.K., Kim, W.T., Kim, D.H.: The effect of Sn addition on the glass-forming ability of Cu–Ti–Zr–Ni–Si metallic glass alloys. J. Non-Cryst. Solids 15, 298 (2002).Google Scholar
12.Yi, S., Park, T.G., Kim, D.H.: Ni-based bulk amorphous alloys in the Ni–Ti–Zr– (Si,Sn) system. J. Mater. Res. 15, 2425 (2000).CrossRefGoogle Scholar
13.Zhang, T., Inoue, A.: Thermal and mechanical properties of Ti–Ni–Cu–Sn amorphous alloys with a wide supercooled liquid region before crystallization. Mater. Trans., JIM 39, 1001 (1998).CrossRefGoogle Scholar
14.Chen, L.C., Spaepen, F.: Calorimetric evidence for the microquasicrystalline structure of amorphous Al-Transition metal-alloys. Nature 336, 366 (1988).CrossRefGoogle Scholar
15.Lu, Z.P., Liu, C.T.: Glass formation criterion for various glass-forming systems. Phys. Rev. Lett. 91, 115505 (2003).CrossRefGoogle ScholarPubMed
16.Ma, D., Tan, H., Wang, D., Li, Y., Ma, E.: Strategy for pinpointing the best glass-forming alloys. Appl. Phys. Lett. 86, 191906 (2005).CrossRefGoogle Scholar
17.Lu, Z.P., Ma, D., Liu, C.T., Chang, Y.A.: Competitive formation of glass and glass-matrix composites. Intermetallics (2007, in press).CrossRefGoogle Scholar