Hostname: page-component-cd9895bd7-8ctnn Total loading time: 0 Render date: 2024-12-23T11:43:18.540Z Has data issue: false hasContentIssue false
  • English
  • Français

Fracture strength measurement of filament assisted CVD polycrystalline diamond films

Published online by Cambridge University Press:  31 January 2011

G.F. Cardinale  and
C.J. Robinson
G.F. Cardinale*
Affiliation:
Raytheon Company, Research Division, Lexington, Massachusetts 02173
C.J. Robinson
Affiliation:
Raytheon Company, Research Division, Lexington, Massachusetts 02173
*
a)Present address: Department of Mechanical Engineering, University of California, Davis, California 95616.
Get access

Abstract

The fracture strength of polycrystalline diamond films deposited by filament assisted chemical vapor deposition in the thickness range of 3.5 to 160 μm is investigated. Using a burst pressure technique, the fracture strengths of circular diamond film specimens are calculated. An average fracture strength of 730 MPa for nine samples was computed. This value is in good agreement with published strengths of microwave plasma deposited diamond films, comparable to other high strength materials, and within an order of magnitude of the fracture strength of bulk natural diamond. The average fracture strength of the fine-grained substrate interface appears consistently higher than that of the coarse-grained diamond growth surface.

Type
Articles
Information
Journal of Materials Research , Volume 7 , Issue 6 , June 1992 , pp. 1432 - 1437
Copyright
Copyright © Materials Research Society 1992

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1.Physical Properties of Diamond, edited by Berman, R. (Clarendon Press, Oxford, 1965).Google Scholar
2.The Properties of Diamond, edited by Field, J. E. (Associated Press, London, 1979).Google Scholar
3.Cardinale, G. F. and Tustison, R. W., SPIE Proceedings, 1325 (1990).Google Scholar
4.Windischmann, H., Epps, G. F., and Ceasar, G. P., in New Diamond Science and Technology, edited by Messier, R., Glass, J. T., Butler, J. E., and Roy, R. (Mater. Res. Soc. Symp. Proc. NDST-2, Pittsburgh, PA, 1991).Google Scholar
5.Moore, M., Industrial Diamond Review, 67–71, Feb. (1985).Google Scholar
6.Cardinale, G. F. and Tustison, R. W., J. Vac. Sci. TechnoL, July/August (1990).Google Scholar
7.Klein, C. A., Hartnett, T. M., Miller, R. P., and Robinson, C. J., Proc. 2nd Int. Conf. Diamond Materials, ECS, Pennington, NJ (1991, in press).Google Scholar
8.Morelli, D. T., Hartnett, T. M., and Robinson, C. J., Appl. Phys. Lett. (1991, in press).Google Scholar
9.Pickhardt, V. Y. and Smith, D. L., J. Vac. Sci. Technol. 14 (3), 823 (1977).CrossRefGoogle Scholar
10.Grimsditch, M. H. and Ramdas, A. K., Phys. Rev. B 11, 3139 (1975).CrossRefGoogle Scholar
11.Klein, C. A., Raytheon Co., Lexington, MA (private communication).Google Scholar
12.Hashin, Z. and Shtrikman, S., J. Mech. & Phys. Solids 10, 335 (1962).CrossRefGoogle Scholar
13.Griffith, A. A., Philos. Trans. R. Soc. London A221, 163–198 (1920).Google Scholar
14.Howes, V. R., Proc. Phys. Soc. London 74, 48 (1959).CrossRefGoogle Scholar
15.Physical Properties of Diamond, edited by Berman, R. (Clarendon Press, Oxford, 1965), pp. 180–181.Google Scholar
16.Howes, V. R., Proc. Phys. Soc. London 80, 78 (1962).CrossRefGoogle Scholar
17.Kingery, W. D., Bowen, H. K., and Uhlmann, D. R., in Introduction to Ceramics, 2nd ed. (J. Wiley & Sons, New York, 1976).Google Scholar
18.Ibid., p. 794 (1976).Google Scholar
19.Carniglia, S. C., J. Am. Ceram. Soc. 55, 243 (1972).CrossRefGoogle Scholar
20.Pickrell, D. J., Zhu, W., Badzian, A. R., Newnham, R. E., and Messier, R., J. Mater. Res. 6, 1264–1277 (1991).CrossRefGoogle Scholar
21.Zhu, W., Ph.D. Thesis, Penn State University, August (1990).Google Scholar
22. Raytheon Data Sheet, Raytheon Co., Research Division, Lexington, MA 02173.Google Scholar
23.Cardinale, G. F. and Tustison, R. W., Thin Solid Films 207, 126–130 (1992).CrossRefGoogle Scholar
24.Klocek, P., Stone, L. E., Boucher, M. W., and DeMilo, C., SPIE Proceedings, Infrared Optical Materials VI, 65–77 (1988).CrossRefGoogle Scholar