Hostname: page-component-78c5997874-xbtfd Total loading time: 0 Render date: 2024-11-16T16:09:45.715Z Has data issue: false hasContentIssue false
  • English
  • Français

Fabrication of c-axis oriented higher manganese silicide by a high-magnetic-field and its thermoelectric properties

Published online by Cambridge University Press:  31 January 2011

Hisashi Kaga ,
Yoshiaki Kinemuchi ,
Koji Watari ,
Satoshi Tanaka ,
Atsushi Makiya ,
Zenji Kato  and
Keizo Uematsu
Hisashi Kaga*
Affiliation:
National Institute of Advanced Industrial Science and Technology (AIST), Nagoya 463-8560, Japan
Yoshiaki Kinemuchi
Affiliation:
National Institute of Advanced Industrial Science and Technology (AIST), Nagoya 463-8560, Japan
Koji Watari
Affiliation:
National Institute of Advanced Industrial Science and Technology (AIST), Nagoya 463-8560, Japan
Satoshi Tanaka
Affiliation:
Department of Materials Science and Technology, Nagaoka University of Technology, Nagaoka 940-2188, Japan
Atsushi Makiya
Affiliation:
Department of Materials Science and Technology, Nagaoka University of Technology, Nagaoka 940-2188, Japan
Zenji Kato
Affiliation:
Department of Materials Science and Technology, Nagaoka University of Technology, Nagaoka 940-2188, Japan
Keizo Uematsu
Affiliation:
Department of Materials Science and Technology, Nagaoka University of Technology, Nagaoka 940-2188, Japan
*
a)Address all correspondence to this author. e-mail: [email protected]
Get access

Abstract

We report the preparation and thermoelectric properties of oriented higher manganese silicide (HMS) with a composition of MnSi1.73 bulk. The grain alignment and densification were achieved by rotating high magnetic field and spark plasma sintering (SPS) techniques, respectively. The easy magnetization axis of MnSi1.73 was found to be c-axis, and the applied magnetic field of 2 T was strong enough to rotate the powder with a mean grain size of 1 μm. The c-axis of grains was oriented when applying the magnetic field, and the degree of orientation was further increased after heat treatment. However, a secondary phase that was mono manganese silicide (MnSi) was observed as a result of oxidation on the surface of synthesized powder. The electrical conductivity of the c-axis oriented specimen along the ab-plane was about 40% larger than that for sample processed only by SPS, while the Seebeck coefficient of oriented and nonoriented specimens showed similar values regardless of existence of the second phase. Consequently, the power factor of the c-axis oriented specimen along the ab-plane was enhanced by about 35% compared to the nonoriented one. The proposed approach is found to be very effective not only in obtaining the oriented materials with nonductility but also in enhancing the thermoelectricity.

Keywords

Electrical propertiesThermoelectricityTexture
Type
Articles
Information
Journal of Materials Research , Volume 22 , Issue 10 , October 2007 , pp. 2917 - 2923
Copyright
Copyright © Materials Research Society 2007

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1Nikitin, E.N., Tarasov, V.I., Andreev, A.A.Shumilova, L.N.: Electrical properties of higher manganese silicide. Fiz. Tverd. Tela. 11, 3389 1969Google Scholar
2Nishida, I.: Semiconducting properties of nonstoichiometric manganese silicides. J. Mater. Sci. 7, 435 1972CrossRefGoogle Scholar
3Searcy, A.W.: Predicting the thermodynamic stabilities and oxidation resistances of silicide cermets. J. Am. Ceram. Soc. 40, 431 1957CrossRefGoogle Scholar
4Groß, E., Riffel, M.Stöhrer, U.: Thermoelectric generators made of FeSi2 and HMS: Fabrication and measurement. J. Mater. Res. 10, 34 1995Google Scholar
5Okada, S., Shishido, T., Ogawa, M., Matsukawa, F., Ishizawa, Y., Nakajima, K., Fukuda, T.Sundstrand, T.: MnSi and MnSi2−x single crystals growth by Ga flux method and properties. J. Cryst. Growth 229, 532 2001CrossRefGoogle Scholar
6Umemoto, M., Liu, Z.G., Omatsuzawa, R.Tsuchiya, K.: Production and characterization of Mn–Si thermoelectric material. Mater. Sci. Forum 343, 918 2000CrossRefGoogle Scholar
7Zaitsev, V.K., Ordin, S.V., Tarasov, V.I.Fedorov, M.I.: Optical properties of higher manganese silicide. Sov. Phys. Solid State 21, 1454 1979Google Scholar
8Zaitsev, V.K.: In CRC Handbook of Thermoelectrics edited by D.M. Rowe CRC Press Boca Raton, FL 1995 Chap. 25, p. 304Google Scholar
9Engstrom, I.Lonnberg, B.: Thermal expansion studies of the group IV–VII transition-metal disilicides. J. Appl. Phys. 63, 4476 1988CrossRefGoogle Scholar
10Voroniv, B.K., Dudkin, L.D.Trusova, N.N.: Anisotropy of thermoelectric properties in chromium disilicide and higher manganese silicide single crystal. Kristallografiya 12, 1527 1964Google Scholar
11Levinson, L.M.: Investigation of the defect manganese silicide MnnSi2n2m. J. Solid State Chem. 6, 126 1973CrossRefGoogle Scholar
12Ivanova, L.D., Abrikosova, N.Kh., Elangina, E.I.Khvostikova, V.D.: Preparation and study of properties of higher manganese silicide single crystals. Izv. Akad. Nauk SSSR Neorg. Mater. 5, 1933 1969Google Scholar
13Aoyama, I., Fedorov, M.I., Zaitsev, V.K., Solomkin, F.Y., Eremin, I.S., Samunin, A.Y., Mukoujima, M., Sano, S.Tsuji, T.: Effects of Ge doping on micromorphology of MnSi in MnSi1.7 and on their thermoelectric transport properties. Jpn. J. Appl. Phys. 12, 8562 2005CrossRefGoogle Scholar
14Miura, S., Sato, Y., Fukuda, K., Nishimura, K.Ikeda, K.: Texture and thermoelectric properties of hot-extruded Bi2Te3 compound. Mater. Sci. Eng., A 227, 244 2000CrossRefGoogle Scholar
15Pierrat, P., Dauscher, A., Lenoir, B., Lopez, R.M.Scherrer, H.: Preparation of the Bi8Sb32Te60 solid solution by mechanical alloying. J. Mater. Sci. 32, 3653 1997CrossRefGoogle Scholar
16Seo, J., Park, K., Lee, D.Lee, C.: Thermoelectric properties of hot-pressed n-type Bi2Te2.85Se0.15 compounds doped with SbI3. Mater. Sci. Eng., B 49, 247 1997CrossRefGoogle Scholar
17Sakka, Y.Suzuki, T.S.: Textured development of feeble magnetic ceramics by colloidal processing under high magnetic field. J. Ceram. Soc. Jpn. 113, 26 2005CrossRefGoogle Scholar
18Kaga, H., Kinemuchi, Y., Tanaka, S., Makiya, A., Kato, Z., Uematsu, K.Watari, K.: Fabrication of c-axis oriented Zn0.98Al0.02O by a high-magnetic-field via gelcasting and its thermoelectric properties. J. Ceram. Soc. Jpn. 114, 1085 2006CrossRefGoogle Scholar
19Tanaka, S., Makiya, A., Kato, Z., Uchida, N., Kimura, T.Uematsu, K.: Fabrication of c-axis oriented polycrystalline ZnO by using a rotating magnetic field and following sintering. J. Mater. Res. 21, 703 2006CrossRefGoogle Scholar
20Kaga, H., Kinemuchi, Y., Tanaka, S., Makiya, A., Kato, Z., Uematsu, K.Watari, K.: Preparation and thermoelectric properties of highly oriented Al doped ZnO ceramics by a high magnetic field. Jpn. J. Appl. Phys. 45, L1212 2006CrossRefGoogle Scholar
21Nakajima, T.Schelten, J.: Peculiarities of the band magnetism in the higher manganese silicide. J. Magn. Magn. Mater. 21, 157 1980CrossRefGoogle Scholar
22Gottlieb, U., Sulpoce, A., Lambert-Andron, B.Laborde, O.: Magnetic properties of single crystalline Mn4Si7. J. Alloys Compd. 361, 13 2003CrossRefGoogle Scholar