Hostname: page-component-cd9895bd7-7cvxr Total loading time: 0 Render date: 2024-12-23T11:45:49.941Z Has data issue: false hasContentIssue false
  • English
  • Français

Evaluation of nanoscale inhomogeneity in as-quenched state of Cu–Hf–Ti alloys

Published online by Cambridge University Press:  31 January 2011

J. Saida ,
T. Osuna ,
A. Inoue  and
M. Onuma
J. Saida*
Affiliation:
Institute for Materials Research, Tohoku University, Sendai 980–8577, Japan
T. Osuna
Affiliation:
Institute for Materials Research, Tohoku University, Sendai 980–8577, Japan
A. Inoue
Affiliation:
Institute for Materials Research, Tohoku University, Sendai 980–8577, Japan
M. Onuma
Affiliation:
National Institute for Materials Science, 1–2–1 Sengen, Tsukuba 305–0047, Japan
*
a) Address all correspondence to this author. Present address: Center for Interdisciplinary Research, Tohoku University, Aramaki Aoba, Sendai 980-8578, Japan e-mail: [email protected]
Get access

Abstract

The microstructure of the melt-spun Cu60Hf30Ti10 and Cu50Hf40Ti10 alloys was investigated. The high-resolution transmission electron microscopy (HRTEM) image in the Cu60Hf30Ti10 alloy reveals the existence of nanoscale inhomogeneity, which appears to originate from nanocrystalline particles. The compositional segregation with a diameter of approximately 5 nm was detected, and its size agrees with the scale of nanocrystalline particle. Small-angle x-ray scattering measurement of the melt-spun Cu60Hf30Ti10 alloy also indicates the development of nanoscale inhomogeneity with the same size as that of nanocrystalline particles. It is found that the Cu element is enriched in and Hf element is rejected from the nanocrystalline particles. Since the melt-spun Cu50Hf40Ti10 alloy, which has a similar alloy composition to that of the glassy region of melt-spun Cu60Hf30Ti10 alloy, has a homogeneous glassy structure without fringe contrast in the HRTEM image, it is suggested that the excess of Cu causes the nanoscale inhomogeneity with crystalline structure in the rapidly quenched Cu–Hf–Ti alloys.

Type
Rapid Communications
Information
Journal of Materials Research , Volume 18 , Issue 9 , September 2003 , pp. 2013 - 2016
Copyright
Copyright © Materials Research Society 2003

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1.Inoue, A., Zhang, W., Zhang, T., and Kurosaka, K., Acta Mater. 49, 2645 (2001).CrossRefGoogle Scholar
2.Inoue, A., Mater. Trans. JIM 36, 866 (1995).Google Scholar
3.Inoue, A., Zhang, W., Zhang, T., and Kurosaka, K., J. Mater. Res. 16, 2836 (2001).Google Scholar
4.Inoue, A., Zhang, W., Zhang, T., and Kurosaka, K., Mater. Trans. 42, 1149 (2001).CrossRefGoogle Scholar
5.Kasai, M., Saida, J., Matsushita, M., Osuna, T., Matsubara, E., and Inoue, A., J. Phys. Condens. Matter 14, 13867 (2002).Google Scholar
6.Chen, Y., Zhang, T., Zhang, W., Ping, D.H., Hono, K., Inoue, A., and Sakurai, T., Mater. Trans. 43, 2647 (2002).CrossRefGoogle Scholar
7.Pennycook, S.J. and Jesson, D.E., Phys. Rev. Lett. 64, 938 (1990).CrossRefGoogle Scholar
8.de, F.R. Bore, Boom, R., Mattens, W.C.M., Miedema, A.R., and Niessen, A.K., Cohesion in Metals (North-Holland, Amsterdam, The Netherlands, 1988), p. 361.Google Scholar
9.Kasai, M., Matsubara, E., Saida, J., Nakayama, M., Uematsu, K., Zhang, T., and Inoue, A., Mater. Sci. Eng. A (submitted).Google Scholar
10.Uematsu, K., Master Thesis, Tohoku University, Japan, 2002.CrossRefGoogle Scholar