Hostname: page-component-78c5997874-94fs2 Total loading time: 0 Render date: 2024-11-17T18:04:24.022Z Has data issue: false hasContentIssue false
  • English
  • Français

An investigation on photoluminescence and AC powder electroluminescence of ZnS:Cu,Cl,Mn,Te phosphor

Published online by Cambridge University Press:  12 September 2011

Bong Je Park ,
Hong Seok Seo ,
Joon Tae Ahn ,
Jung Ho Song ,
Woon Jin Chung  and
Duk Young Jeon
Bong Je Park
Affiliation:
Basic Research Laboratory, Electronics and Telecommunications Research Institute, Daejeon 305-600, Republic of Korea; and Department of Materials Science and Engineering, Korea Advanced Institute of Science and Technology, Daejeon 305-701, Republic of Korea
Hong Seok Seo
Affiliation:
Basic Research Laboratory, Electronics and Telecommunications Research Institute, Daejeon 305-600, Republic of Korea
Joon Tae Ahn
Affiliation:
Basic Research Laboratory, Electronics and Telecommunications Research Institute, Daejeon 305-600, Republic of Korea
Jung Ho Song
Affiliation:
Basic Research Laboratory, Electronics and Telecommunications Research Institute, Daejeon 305-600, Republic of Korea
Woon Jin Chung
Affiliation:
Division of Advanced Materials Engineering, Kongju National University, Cheonan 22-717, Republic of Korea
Duk Young Jeon*
Affiliation:
Department of Materials Science and Engineering, Korea Advanced Institute of Science and Technology, Daejeon 305-701, Republic of Korea
*
a)Address all correspondence to this author. e-mail: [email protected]
Get access

Abstract

ZnS:Cu,Cl,Mn,Te, which shows red AC powder electroluminescence (ACPEL) emission, was synthesized using a conventional wet synthesis and a sealed vessel method. The photoluminescence (PL) and ACPEL were characterized. After the second firing, 0.5 wt% tellurium (Te)-doped ZnS:Cu,Cl,Mn,Te phosphor shows almost red PL emission from the 4T1–6A1 transition of Mn2+ ions, which are affected by the Te. Extended x-ray absorption fine structure analysis on the Mn K edge proved that the substitution of sulfur (S) with Te changes the local crystal field of the Mn2+ ions and shifts an orange emission (∼588 nm) to a red emission (∼650 nm). A red ACPEL emission is first shown in 0.5 wt%Te-doped ZnS:Cu,Cl,Mn,Te after the third firing phosphor even though its luminance is not very high. The origin of the ACPEL emission is assumed to be not a CuxS–ZnS p–n junction but a CuxTe–ZnS p–n junction. Raman spectra were characterized to support that the red ACPEL emission is probably attributed to a CuxTe–ZnS p–n junction.

Keywords

LuminescencePowderRaman spectroscopy
Type
Articles
Information
Journal of Materials Research , Volume 26 , Issue 18 , 28 September 2011 , pp. 2394 - 2399
Copyright
Copyright © Materials Research Society 2011

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1.Neyts, K.: Numerical simulation of charge transfer and light emission in SrS:Ce thin-film electroluminescent devices. IEEE Trans. Electron. Dev. 43, 1343 (1996).CrossRefGoogle Scholar
2.Fisher, A.G.: Electroluminescent lines in ZnS powder particles. J. Electrochem. Soc. 110, 733 (1963).Google Scholar
3.Park, J.H., Lee, S.H., Kim, J.S., Kwon, A.K., Park, H.L., and Han, S.D.: White-electroluminescent device with ZnS:Mn, Cu, Cl phosphor. J. Lumin. 126, 566 (2007).CrossRefGoogle Scholar
4.Park, I.W., Kim, J.H., Yoo, J.S., Shin, H.H., Kim, C.K., and Choi, C.K.: Longevity improvement of CaS:Eu phosphor using polymer binder coating for white LED application. J. Electrochem. Soc. 155, J132 (2008).Google Scholar
5.Lo, C.L., Duh, J.G., and Chiou, B.S.: Low-voltage cathodoluminescence properties of the Y2O2S:Eu red light emitting phosphor screen in field-emission environments. J. Electrochem. Soc. 149, H129 (2002).CrossRefGoogle Scholar
6.Krasnoperov, V.A. and Pron, G.F.: The effect of tellurium on the photoluminescence quantum yield of ZnS-Mn luminophors. J. Appl. Spectrosc. 9, 1277 (1972).Google Scholar
7.Xianqing, P., Takashi, H., Hiromasa, H., and Ken-Ichi, M.: Photoluminescence properties of Ca2Si5N8:Eu+ nitride phosphor prepared by carbothermal reduction and nitridation method. Chem. Lett. 35, 334 (2006).Google Scholar
8.Benalloul, P., Benoit, J., Geoffroy, A., Yebdri, D., Bilewicz, R., Busse, W., Gumlich, H-E., and Rebentisch, R.: Thin film electroluminescence of Zn1−xMnxS1−yTey. J. Cryst. Growth 101, 976 (1990).Google Scholar
9.Park, B.J., Im, W.B., Chung, W.J., Seo, H.S., Ahn, J.T., and Jeon, D.Y.: Internal pressure effect on cathodoluminescence enhancement of ZnS:Mn2+ synthesized by a sealed vessel. J. Mater. Res. 22, 2838 (2007).CrossRefGoogle Scholar
10.Parrot, R., Naud, C., and Gendron, F.: Structure of a 4T 2 level of Mn++ in tetrahedral symmetry, dynamical Jahn-Teller effect and selective intensity transfer. Phys. Rev. B 13, 3748 (1976).CrossRefGoogle Scholar
11.Zhang, X., Zeng, H., and Su, Q.: Mn2+-doped Ba2ZnS3 phosphor as a potential luminescent material for white LEDs. J. Alloy. Comp. 441, 259 (2007).CrossRefGoogle Scholar
12.Soo, Y.L., Ming, Z.H., Huang, S.W., and Kao, Y.H.: Local structures around Mn luminescent centers in Mn-doped nanocrystals of ZnS. Phys. Rev. B 50, 7602 (1994).Google Scholar
13.Happo, N., Sato, H., Mihara, T., Mimura, K., Hosokawa, S., Ueda, Y., and Taniguchi, M.: Mn and Te K-edge EXAFS studies of Zn1-xMnxTe. Physica B 208–209, 291 (1995).CrossRefGoogle Scholar
14.Li, F. and Wang, Y.H.: Concentration effect of Mn2+ on the luminescence properties of Ba0.75Al11O17.25: Mn2+. Electrochem. Solid St. 9, J24 (2006).Google Scholar
15.Sohn, K.S., Park, E.S., Kim, C.H., and Park, H.D.: Photoluminescence behavior of BaAl12O19:Mn phosphor prepared by pseudocombinatorial chemistry method. J. Electrochem. Soc. 147, 4368 (2000).CrossRefGoogle Scholar
16.Smirnova, R.I. and Pron, G.F.: Effect of tellurium on luminescence properties of zinc sulfide luminors. Opt. Spectrosc. 23, 67 (1967).Google Scholar
17.Schreder, B. and Kiefer, W.: Handbook of Raman Spectroscopy (Dekker, New York, 2001).Google Scholar
18.Schneider, J. and Kirby, R.D.: Raman scattering from ZnS polytypes. Phys. Rev. B 6, 1290 (1972).CrossRefGoogle Scholar
19.Brafman, O. and Mitra, S.S.: Raman effect in wurtzite- and zinc-blende-type ZnS single crystals. Phys. Rev. 171, 931 (1968).CrossRefGoogle Scholar
20.Nien, Y.T. and Chen, I.G.: Raman scattering and electroluminescence of ZnS:Cu,Cl phosphor powder. Appl. Phys. Lett. 89, 261906 (2006).CrossRefGoogle Scholar
21.Amirtharaj, P.M. and Pollak, F.H.: Raman scattering study of the properties and removal of excess Te on CdTe surfaces. Appl. Phys. Lett. 45, 789 (1984).CrossRefGoogle Scholar
22.Minceva-Sukarovaa, B., Najdoskia, M., Grozdanova, I., and Chunnilall, C.J.: Raman spectra of thin films of some metal sulfides. J. Mol. Struct. 410–411, 267 (1997).CrossRefGoogle Scholar