Article contents
A three-dimensional printed myringotomy, tympanostomy and ventilation tube placement simulator
Published online by Cambridge University Press: 06 May 2021
Abstract
Tympanostomy is one of the most commonly performed surgical procedures in otolaryngology, and its complexity is challenging for trainee surgeons. Investing in medical education is a cornerstone of good patient safety practices. For trainees, use of simulators before operating on actual patients helps mitigate risks. This study aimed to develop a three-dimensional printed model simulator for myringotomy, tympanostomy and ventilation tube placement.
An articulated model with a detachable portion, base and plastic bag to simulate the external auditory canal, middle ear and tympanic membrane, respectively, was modelled and printed.
The final simulator was made from acrylonitrile butadiene styrene polymer and measured 4 × 4 × 12 cm. It was designed to mimic the angulation of patient anatomy in the myringotomy position and simulate the texture and colour of the tissues of interest. The cost was low, and testing with an operating microscope and endoscope yielded satisfactory results. The advent of three-dimensional printing technology has made surgical simulation more accessible and less expensive, providing several advantages for medical education.
The proposed model fulfilled expectations as a safe, inexpensive, reproducible, user-friendly and accessible surgical education tool that can be improved and reassessed for further research.
Keywords
- Type
- Main Articles
- Information
- Copyright
- Copyright © The Author(s), 2021. Published by Cambridge University Press
Footnotes
Mr L Ferreira e Silva takes responsibility for the integrity of the content of the paper
References
- 3
- Cited by