Article contents
Vortex suppression and drag reduction in the wake of counter-rotating cylinders
Published online by Cambridge University Press: 12 May 2011
Abstract
The flow over a pair of counter-rotating cylinders is investigated numerically and experimentally. It is demonstrated that it is possible to suppress unsteady vortex shedding for gap sizes from one to five cylinder diameters, at Reynolds numbers from 100 to 200, expanding on the more limited work by Chan & Jameson (Intl J. Numer. Meth. Fluids, vol. 63, 2010, p. 22). The degree of unsteady wake suppression is proportional to the speed and the direction of rotation, and there is a critical rotation rate where a complete suppression of flow unsteadiness can be achieved. In the doublet-like configuration at higher rotational speeds, a virtual elliptic body that resembles a potential doublet is formed, and the drag is reduced to zero. The shape of the elliptic body primarily depends on the gap between the two cylinders and the speed of rotation. Prior to the formation of the elliptic body, a second instability region is observed, similar to that seen in studies of single rotating cylinders. It is also shown that the unsteady wake suppression can be achieved by rotating each cylinder in the opposite direction, that is, in a reverse doublet-like configuration. This tends to minimize the wake interaction of the cylinder pair and the second instability does not make an appearance over the range of speeds investigated here.
- Type
- Papers
- Information
- Copyright
- Copyright © Cambridge University Press 2011. The online version of this article is published within an Open Access environment subject to the conditions of the Creative Commons Attribution-NonCommercial-ShareAlike licence <http://creativecommons.org/licenses/by-nc-sa/2.5/>. The written permission of Cambridge University Press must be obtained for commercial re-use.
Footnotes
Present address: Hitachi Global Storage Technologies, San Jose, CA 95119, USA.
Present address: Department of Mechanical and Aerospace Engineering, George Washington University, Washington, DC 20052, USA.
References
REFERENCES
- 79
- Cited by