Hostname: page-component-cd9895bd7-lnqnp Total loading time: 0 Render date: 2024-12-26T22:04:10.259Z Has data issue: false hasContentIssue false

Vibration of hot-wire anemometer filaments

Published online by Cambridge University Press:  29 March 2006

A. E. Perry
Affiliation:
Department of Mechanical Engineering, University of Melbourne, Australia
G. L. Morrison
Affiliation:
Department of Mechanical Engineering, University of Melbourne, Australia

Abstract

Hot-wire filament vibration generated by fluctuating aerodynamic loads is found to occur in turbulent flow fields. The motion of the filament relative to the stream can cause errors in the indicated velocity fluctuations. Analysis and experiment show that these errors are probably serious only when the velocity fluctuations are confined within a narrow bandwidth spectrum such as in a Kármán vortex street. Under such conditions the filament goes into a skipping or ‘whirling’ mode of motion and the errors in the velocity perturbation reading are substantial. Errors in normally encountered boundary-layer turbulence are suspected not to be serious but this is not yet certain. A convenient experimental method for detecting these vibrations is outlined.

A study is made of the effect of filament vibration on the direct frequency-response test for hot-wire systems. These tests include shaking the probe at high frequencies in a steady stream and the Kármán vortex street method.

Type
Research Article
Copyright
© 1971 Cambridge University Press

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

Perry, A. E. 1971 Department of Mechanical Engineering, University of Melbourne, Rep FM. 3.
Perry, A. E. & Morrison, G. L. 1971a J. Fluid Mech. 47, 577.
Perry, A. E. & Morrison, G. L. 1971b J. Fluid Mech. 47, 765.
Tritton, D. J. 1959 J. Fluid Mech. 6, 547.