An effort is made to understand turbulence in fluid systems like the oceans and atmosphere in which the Richardson number is generally large. Toward this end, a theory is developed for turbulent flow over a flat plate which is moved and cooled in such a way as to produce constant vertical fluxes of momentum and heat. The theory indicates that in a co-ordinate system fixed in the plate the mean velocity increases linearly with height z above a turbulent boundary layer and the mean density decreases as z3, so that the Richardson number is large far from the plate. Near the plate, the results reduce to those of Monin & Obukhov.

The curvature of the density profile is essential in the formulation of the theory. When the curvature is negative, a volume of fluid, thoroughly mixed by turbulence, will tend to flatten out at a new level well above the original centre of mass, thereby transporting heat downward. When the curvature is positive a mixed volume of fluid will tend to fall a similar distance, again transporting heat downward. A well-mixed volume of fluid will also tend to rise when the density profile is linear, but this rise is negligible on the basis of the Boussinesq approximation. The interchange of fluid of different, mean horizontal speeds in the formation of the turbulent patch transfers momentum. As the mixing in the patch destroys the mean velocity shear locally, kinetic energy is transferred from mean motion to disturbed motion. The turbulence can arise in spite of the high Richardson number because the precise variations of mean density and mean velocity mentioned above permit wave energy to propagate from the turbulent boundary layer to the whole region above the plate. At the levels of reflexion, where the amplitudes become large, wave-breaking and turbulence will tend to develop.

The relationship between the curvature of the density profile and the transfer of heat suggests that the density gradient near the level of a point of inflexion of the density curve (in general cases of stratified, shearing flow) will increase locally as time goes on. There will also be a tendency to increase the shear through the action of local wave stresses. If this results in a progressive reduction in Richardson number, an ultimate outbreak of Kelvin–Helmholtz instability will occur. The resulting sporadic turbulence will transfer heat (and momentum) through the level of the inflexion point. This mechanism for the appearance of regions of low Richardson number is offered as a possible explanation for the formation of the surfaces of strong density and velocity differences observed in the oceans and atmosphere, and for the turbulence that appears on these surfaces.