Hostname: page-component-586b7cd67f-dlnhk Total loading time: 0 Render date: 2024-11-20T08:50:04.951Z Has data issue: false hasContentIssue false
  • English
  • Français

A study of turbulence at a wall using an electrochemical wall shear-stress meter

Published online by Cambridge University Press:  28 March 2006

James E. Mitchell  and
Thomas J. Hanratty
James E. Mitchell
Affiliation:
Department of Chemistry and Chemical Engineering, University of Illinois, Urbana, Illinois
Thomas J. Hanratty
Affiliation:
Department of Chemistry and Chemical Engineering, University of Illinois, Urbana, Illinois
Get access Rights & Permissions [Opens in a new window]

Abstract

A technique has been developed to measure the instantaneous shear stress at the boundary over which a liquid is flowing. It is being used to study turbulence in the immediate vicinity of a pipe wall. A reaction is conducted on an electrode mounted flush with a solid wall at high enough voltages to reduce the concentration of the reacting species to zero at the surface. Under these conditions, the rate of reaction is controlled by the rate of mass transfer. The electrode is analogous to a constant-temperature hot-wire anemometer in that the surface concentration is kept constant and the current flowing in the circuit is related to the surface shear stress. For fully developed turbulence the limiting velocity intensity, based on the local average velocity, is 0·32. Some of the velocity fluctuations are as large as the local average velocity and their distribution is nearly symmetric about the average. The ratio of the longitudinal to circumferential scale is about 30 : 1, because the circumferential scale is very small. There is some indication that close to a wall the velocity fluctuations in the circumferential direction are much smaller than the longitudinal fluctuations.

Type
Research Article
Information
Journal of Fluid Mechanics , Volume 26 , Issue 1 , September 1966 , pp. 199 - 221
Copyright
© 1966 Cambridge University Press

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

Abramowitz, M. 1951 J. Math. Phys. 20, 16.
Eisenberg, M., Tobias, C. W. & Wilke, C. R. 1954 J. Electrochem. Soc. 103, 41.
Gordon, S. L. & Tobias, C. W. 1963 M.Sc. thesis, Univ. of California at Berkeley.
Grant, H. L. 1958 J. Fluid Mech. 4, 14.
Harrison, M. 1958 David Taylor Model Basin, Hydromech. Lab. Res. & Development Rept no. 1260.
Hinze, J. O. 1959 Turbulence. New York: McGraw-Hill.
Klebanoff, P. S. 1954 NACA TN no. 3187.
Laufer, J. 1951 NACA TR no. 1053.
Laufer, J. 1954 NACA TR no. 1174.
Ling, S. C. 1962 J. Heat Trans. C 85, 230.
Mitchell, J. E. 1965 Investigation of wall turbulence using a diffusion controlled electrode. Ph.D. thesis in Chemical Engineering, Univ. of Illinois, Urbana.
Reiss, L. P. 1962 Investigation of turbulence near a pipe wall using a diffusion controlled electrolytic reaction on a circular electrode. Ph.D. thesis in Chemical Engineering, University of Illinois, Urbana.
Reiss, L. P. & Hanratty, T. J. 1962 A.I.Ch.E. J. 8, 24.
Reiss, L. P. & Hanratty, T. J. 1963 A.I.Ch.E. J. 9, 15.
Runstadler, P. W., Kline, S. J. & Reynolds, W. C. 1963 An experimental investigation of the flow structure of the turbulent boundary layer. Rept MD-8, Dept. of Mech. Engng, Stanford Univ.
Sandborn, V. A. 1955 NACA TN no. 3266.
Sternberg, J. 1961 A Theory for the Laminar Sublayer in Turbulent Flow, Rept no. 1127, Ballistic Res. Lab., Aberdeen Proving Ground, Maryland.Google Scholar
Willmarth, W. W. & Wooldridge, C. E. 1962 Repts 02920–1-T and 02920–2-T Dept of Aero. & Astro. Engng, Univ. of Michigan, Ann Arbor.