Hostname: page-component-cd9895bd7-8ctnn Total loading time: 0 Render date: 2024-12-27T14:18:27.916Z Has data issue: false hasContentIssue false
  • English
  • Français

Stability of a circular cylinder oscillating in uniform flow or in a wake

Published online by Cambridge University Press:  29 March 2006

Y. Tanida ,
A. Okajima  and
Y. Watanabe
Y. Tanida
Affiliation:
Institute of Space and Aeronautical Science, University of Tokyo
A. Okajima
Affiliation:
Institute of Space and Aeronautical Science, University of Tokyo Present address: Research Institute of Applied Mechanics, Kyushu University, Fukuoka, Japan.
Y. Watanabe
Affiliation:
Institute of Space and Aeronautical Science, University of Tokyo Present address: Ishikawajima-Harima Heavy Industries, Tanashi, Tokyo, Japan.
Get access Rights & Permissions [Opens in a new window]

Abstract

The lift and drag forces were measured on both a single circular cylinder and tandem circular cylinders in uniform flow at Reynolds numbers from 40 to 104, to investigate the stability of an oscillating cylinder. A cylinder (the downstream one in the tandem case) was made to oscillate in either the transverse or longitudinal direction (perpendicular or parallel to the stream). In the case of a single cylinder, its oscillation causes the so-called synchronization in a frequency range around the Strouhal frequency (transverse mode) or double the Strouhal frequency (longitudinal mode). The aerodynamic damping for transverse oscillation becomes negative in the synchronization range. In the case of tandem cylinders, at low Reynolds numbers in the pure Kármán range synchronization was observed to occur only when the downstream cylinder oscillated inside the vortex-formation region of the upstream one, and at high (low subcritical) Reynolds numbers synchronization occurred irrespective of the cylinder spacing in either oscillating mode. In the tandem case, too, the transverse oscillation of the downstream cylinder becomes unstable in the range of synchronization.

Type
Research Article
Information
Journal of Fluid Mechanics , Volume 61 , Issue 4 , 18 December 1973 , pp. 769 - 784
Copyright
© 1973 Cambridge University Press

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

Biermann, D. & Herrnstein, W. H. 1933 N.A.C.A. Tech. Rep. no. 468.
Bishop, R. E. D. & Hassan, A. Y. 1964 Proc. Roy. Soc. A 277, 51.
Bloor, M. S. & Gerrard, J. H. 1966 Proc. Roy. Soc. A 294, 319.
Calvert, J. R. 1969 Central Electricity Generating Board Rep. RD/M/N377.
Delany, N. K. & Sorensen, N. E. 1953 N.A.C.A. Tech. Note, no. 3038.
Funakawa, M. 1968 J. Japan Soc. Mech. Engrs, 71, 1477 (in Japanese).
Gerrard, J. H. 1961 J. Fluid Mech. 11, 244.
Jones, G. W. 1968 A.S.M.E. Paper, 68-FE-36.
Okajima, A., Takata, H. & Asanuma, T. 1971 Trans. Japan Soc. Mech. Engrs, 37, 2309 (in Japanese).
Okajima, A., Takata, H. & Asanuma, T. 1972 Trans. Japan Soc. Mech. Engrs, 38, 2044 (in Japanese).
Relf, E. F. & Simmons, L. F. G. 1924 Aero. Res. Counc. R. & M. no. 917.
Roshko, A. 1953 N.A.C.A. Tech. Note, no. 2913.
Schaefer, J. W. & Eskinazi, S. 1959 J. Fluid Mech. 6, 241.
Tanaka, H. & Takahara, S. 1970 Mitsubishi Heavy Ind. Tech. Rev. 7, 123 (in Japanese).
Tatsuno, M. 1972 Bull. Res. Inst. Appl. Mech., Kyushu University, 36, 25 (in Japanese).
Thomas, D. G. & Kraus, K. A. 1964 J. Appl. Phys. 35, 3458.
Tritton, D. J. 1959 J. Fluid Mech. 6, 547.