Hostname: page-component-cd9895bd7-jn8rn Total loading time: 0 Render date: 2024-12-27T13:55:07.405Z Has data issue: false hasContentIssue false
  • English
  • Français

A note on static and dynamic calibration of constant-temperature hot-wire probes

Published online by Cambridge University Press:  11 April 2006

H. H. Bruun
H. H. Bruun
Affiliation:
Engineering Department, University of Cambridge
Get access Rights & Permissions [Opens in a new window]

Abstract

This note describes a comparative investigation of static and dynamic calibration procedures for standard hot-wire probes. It is demonstrated that nearly the same sensitivity dE/dV can be obtained by both procedures. The discrepancy reported by Perry & Morrison (1971) is shown to be due mainly to a poor approximation of static calibration data over a large velocity range by a constant-exponent power-law function.

Type
Research Article
Information
Journal of Fluid Mechanics , Volume 76 , Issue 1 , 14 July 1976 , pp. 145 - 156
Copyright
© 1976 Cambridge University Press

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

Bellhouse, B. J. & Schultz, D. L. 1967 The determination of fluctuating velocity in air with heated thin film gauges. J. Fluid Mech. 29, 289–295.Google Scholar
Bradshaw, P. 1971 An Introduction to Turbulence and its Measurement, 171—172. Pergamon.
Bradshaw, P. 1972 Two more wind tunnels driven by aerofoil-type centrifugal blowers. Imperial College Aero. Rep. 72—10.
Bruun, H. H. 1971a Interpretation of a hot wire signal using a universal calibration law. J. Sci. Instrum. 4, 225–231.Google Scholar
Bruun, H. H. 1971b Linearization and hot wire anemometry. J. Sci. Instrum. 4, 815–820.Google Scholar
Collis, D. E. & Williams, M. J. 1959 Two-dimensional convection from heated wires at low Reynolds numbers. J. Fluid Mech. 6, 357–384.Google Scholar
Davies, P. O. A. L., Davis, M. R. & Wold, I. 1967 Operation of the constant resistance hot-wire anemometer. ISVR, Univ. Southampton Rep. 189.
Davies, T. W. & Patrick, M. A. 1972 A simple method of improving the accuracy of hot-wire anemometry. Conf. Fluid Dyn. Measurements in Indust. Med. Environment, Univ. Leicester, paper 2.4.3.
Morrison, G. L., Perry, A. E. & Samuel, A. E. 1972 Dynamic calibration of inclined and crossed hot wires. J. Fluid Mech. 52, 465–474.Google Scholar
Perry, A. E. & Morrison, G. L. 1971 Static and dynamic calibration of constant-temperature hot-wire systems. J. Fluid Mech. 47, 765–777.Google Scholar
Smits, A. J. & Perry, A. E. 1975 An analysis of dynamic prong effect on hot-wire systems. Dept. Mech. Engng, Univ. Melbourne Rep. FM5.