Hostname: page-component-78c5997874-8bhkd Total loading time: 0 Render date: 2024-11-06T00:57:23.778Z Has data issue: false hasContentIssue false

The containment of an oil slick by a boom placed across a uniform stream

Published online by Cambridge University Press:  19 April 2006

N. D. Di Pietro
Affiliation:
McGill University, Department of Civil Engineering and Applied Mechanics, 817 Sherbrooke St West, Montreal PQ H3A 2K6. Present address: SNC/Foster Wheeler Ltd., 1 Complex Desjardins, Montreal, Quebec.
R. G. Cox
Affiliation:
McGill University, Department of Civil Engineering and Applied Mechanics, 817 Sherbrooke St West, Montreal PQ H3A 2K6.

Abstract

A small region (called the surface tension region) where pressure differences across the oil–water and oil–air interfaces are important is shown to exist between the gravity viscous and monolayer regions in a spreading oil slick (Di Pietro, Huh & Cox 1978). The importance of this new region is that (i) it is necessary in order to connect the gravity–viscous and monolayer regions and (ii) it is a region where slopes of interfaces are large. This idea is used to find the thickness profile of an oil layer contained upstream of a barrier (an oil boom) placed across a channel in which water is flowing at a constant velocity. The assumption is also made that the velocity difference across the oil layer is small compared with the water velocity. The general conditions for the validity of the results are then discussed together with the modifications to the theory which are necessary if the boundary layer in the water below the oil should be turbulent rather than laminar. Good agreement is found to exist between experimental results for unsteady spreading on quiescent water in a channel and the results of the theory applied to this situation assuming quasi-steady spreading.

Type
Research Article
Copyright
© 1980 Cambridge University Press

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

Adamson, A. W. 1967 Physical Chemistry of Surfaces. Interscience.
Ahmad, J. & Hansen, R. S. 1972 J. Colloid Interface Sci. 38, 601.
Banks, W. H. 1957 Proc. 2nd Int. Congr. Surface Activity, vol. 1, p. 16.
Buckmaster, J. 1973 J. Fluid Mech. 59, 481.
Burgers, W. G., Greup, D. H. & Korvezee, A. E. 1950 Recueil 69, 921.
Di Pietro, N. D. 1975 M.Sc. dissertation, McGill University, Montreal.
Di Pietro, N. D., Hur, C. & Cox, R. G. 1978 J. Fluid Mech. 84, 529.
Fay, J. A. 1969 The spread of oil slicks on a calm sea. In Oil on the Sea (ed. D. P. Hoult). Plenum Press.
Garrett, W. D. & Barger, W. R. 1970 Envir. Sci. Tech. 4, 123.
Guttenberg, W. von 1941 Z. Phys. 118, 22.
Harkins, W. D. 1952 The Physical Chemistry of Surface Films. New York: Reinhold.
Hoult, D. P. 1972 Ann. Rev. Fluid Mech. 4, 341.
Huh, C., Inoue, M. & Mason, S. G. 1975 Can. J. Chem. Engng 53, 367.
Landt, E. & Volmer, M. 1926 Z. Phys. Chem. 122, 398.
Langmuir, I. 1936 Science 84, 379.
Lugton, F. D. & Vines, R. G. 1960 Australian J. Appl. Sci. 11, 497.
Mar, A. & Mason, S. G. 1968 Kolloid Z. Z. Polymer 225, 55.
Marwedel, G. & Jebsen-Marwedel, H. 1961 Farbe u. Lack 67, 276.
Mercer, E. H. 1939 Proc. Phys. Soc. 51, 561.
Pujado, P. R. & Scriven, L. E. 1972 J. Colloid Interface Sci. 40, 82.
Schlichting, H. 1968 Boundary Layer Theory. McGraw Hill.
Suchon, W. 1970 An experimental investigation of oil spreading over water, M.S. thesis (Mech. Eng.), MIT.
Van Dyke, M. D. 1964 Perturbation Methods in Fluid Mechanics. Academic.
Wicks, M. 1969 Proc. Joint Conf. Prevention and Control of Oil Spills. API and FWPCA, New York.
Zisman, W. A. 1941 J. Chem. Phys. 9, 534.