Hostname: page-component-586b7cd67f-2plfb Total loading time: 0 Render date: 2024-11-27T01:21:56.086Z Has data issue: false hasContentIssue false
  • English
  • Français

Analysis of electrodynamic fluidization

Published online by Cambridge University Press:  06 September 2018

F. J. Higuera Open the ORCID record for F. J. Higuera [Opens in a new window]
F. J. Higuera*
Affiliation:
ETSIAE, Universidad Politécnica de Madrid, Plaza Cardenal Cisneros 3, 28040 Madrid, Spain
*
†Email address for correspondence: [email protected]
Get access Rights & Permissions [Opens in a new window]

Abstract

Electrodynamic fluidization is a technique to generate suspensions of electrically conducting particles using electric forces to overcome their weight. An analysis of electrodynamic fluidization is presented for a monodisperse aerosol of non-coalescing particles of infinite electrical conductivity and negligible inertia suspended in a gas in the gap between two horizontal plate electrodes. A DC voltage is applied between the electrodes that charges the particles initially deposited on the lower electrode and leads to a vertical electric force that lifts the particles and pushes them upwards across the gap. The direction of this force reverses when the particles reach the upper electrode, pushing them downwards until they fall onto the lower electrode and repeat the cycle. Stationary distributions of particles are computed for given values of the applied voltage and the number of suspended particles per unit electrode area. Interparticle collisions play a role when the second of these parameters is of the order of the inverse of the particle cross-section or larger. The electric field induced by the charge of the particles opposes the field due to the applied voltage at the lower electrode and thus sets an upper bound to the number of particles that can be suspended for a given voltage. This bound is attained in the normal operation of a fluidization device, in which there is an excess of particles deposited at the lower electrode, and is computed as a function of the applied voltage. The predictions are compared to experimental results in the literature. A linear stability analysis for dilute aerosols with negligible collision effects shows that the stationary solution becomes unstable when the deposition threshold is approached with a number of suspended particles per unit electrode area larger than a certain critical value. A hydrodynamic instability appears near the lower electrode, where the electric force on a localized accumulation of charged particles leads to an upward gas flow that helps carrying the particles away from the electrode and increases the amplitude of the initial particle accumulation. The instability gives rise to electrohydrodynamic plumes whose dynamics involves collisions, mergers and generation of new plumes.

JFM classification

Drops and Bubbles: Electrohydrodynamic effects Multiphase and Particle-laden Flows: Multiphase and Particle-laden Flows
Type
JFM Papers
Information
Journal of Fluid Mechanics , Volume 854 , 10 November 2018 , pp. 261 - 292
Check for updates
Copyright
© 2018 Cambridge University Press 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

Birdsall, C. K. & Langdon, A. B. 1991 Plasma Physics Via Computer Simulation. Taylor & Francis.Google Scholar
Bologa, M. K. & Berkov, A. B. 1989 Electromotive Heat Exchange of Dispersed Systems (in Russian). Kishinev.Google Scholar
Bologa, M. K., Grosu, F. P. & Kozhukhar, J. A. 1977 Electrical Convection and Heat Transfer (in Russian). Kishinev.Google Scholar
Bologa, M. K., Solomyanchuk, V. L. & Berkov, A. B. 1998 Heat transfer of disperse medium in electrodynamically fluidized beds. Heat Transfer Res. 29, 354–357.Google Scholar
Clemmow, P. C. & Dougherty, J. P. 1990 Electrodynamics of Particles and Plasmas. Westview Press.Google Scholar
Cloupeau, M. 1994 Recipies for use of EHD spraying in cone-jet mode and notes on corona discharge effects. J. Aero. Sci. 25, 1143–1157.Google Scholar
Colver, G. M. 1976 Dynamics and stationary charging of heavy metallic and dielectric particles against a conducting wall in the presence of a DC applied electric field. J. Appl. Phys. 47, 4839–4849.Google Scholar
Colver, G. M. 1980 Electric suspensions above fixed, fluidized and acoustically excited beds. J. Powder Bulk Solid Technol. 4, 21–31.Google Scholar
Colver, G. M. 1983 Dynamics of an electric (particulate) suspension. In Advances in the Mechanics and the Flow of Granular Materials (ed. Shahinpoor, M.), vol. 1, pp. 353–373. Trans Tech Publications.Google Scholar
Colver, G. M. & Ehlinger, L. J. 1988 Particle speed distribution measurement in an electric particulate suspension. IEEE Trans. Ind. Applics. 24, 732–739.Google Scholar
Colver, G. M., Greene, N., Shoemaker, D., Kim, S. & Yu, T. 2004 Quenching of combustible dust mixtures using electric particulate suspensions (EPS): a review of a new testing method for microgravity. AIAA J. 42, 2092–2100.Google Scholar
Colver, G. M., Kim, S. W. & Yu, T.-U. 1996 An electrostatic suspension method for testing spark breakdown, ignition and quenching of powders. J. Electrostat. 37, 151–172.Google Scholar
Estami, G., Esmaelzadeh, E., Garcia-Sanchez, P., Behzadmehr, A. & Baheri, S. 2017 Heat transfer enhancement in a stagnat dielectric liquid by the up and down motion of conductive particles induced by Coulomb forces. J. Appl. Fluid Mech. 10, 169–182.Google Scholar
Higuera, F. J. 2016 Neutralization of a spray of electrically charged droplets by a corona discharge. J. Fluid Mech. 801, 130–149.Google Scholar
Higuera, F. J. & Tejera, J. M. 2017 Vaporization and gas-phase combustion of electrosprayed heptane in a small chamber. Combust. Flame 177, 144–154.Google Scholar
Hockney, R. W. & Eastwood, J. W. 1988 Computer Simulation Using Particles. Taylor & Francis.Google Scholar
Kim, S.-W.1989 Theoretical and experimental studies of flame propagation and quenching of powdered fuels. PhD thesis, Iowa State University, Ames, IA.Google Scholar
Kritsov, S. A. & Morozov, S. S. 1985 Electrophysical Processes in High-voltage Devices (in Russian). Moscow.Google Scholar
Landau, L. D. & Lifshitz, E. M. 1981 Physical Kinetics. Elsevier.Google Scholar
Landau, L. D. & Lifshitz, E. M. 1986 Theory of Elasticity. Elsevier.Google Scholar
Lebedev, N. N. & Skal’skaya, I. P. 1962 Force acting on a conducting sphere in the field of a parallel plate condenser. Sov. Phys. Tech. Phys. 7, 268–272.Google Scholar
Maxwell, J. C. 1881 A Treatise on Electricity and Magnetism. Oxford University Press.Google Scholar
Moore, A. D. 1968 Electrostatics. Exploring, Controlling, and Using Static Electricity. Anchor Books.Google Scholar
Myazdrikov, O. A. 1980 Electrodynamic fluidization in powder metallurgy. Sov. Powder Metallurgy Metal Ceramics 19, 380–385.Google Scholar
Myazdrikov, O. A. 1984 Electrodynamic Fluidization of Disperse Systems (in Russian). Khimiya, Leningrad.Google Scholar
Pohl, R. W. 1960 Elektrizitätslehre. Springer.Google Scholar
Shoshin, Y. L. 2000 Maximum concentration of the electrodynamically fluidized bed. J. Aero. Sci. 31, 869–870.Google Scholar
Shoshin, Y. L. & Dreizin, E. 2002 Production of well-controlled laminar aerosol jets and their application for studying aerosol combustion processes. Aerosol Sci. Technol. 36, 953–962.Google Scholar
Shoshin, Y. L. & Dreizin, E. 2003 Particle combustion rates in premixed flames of polydisperse metal-air aerosols. Combust. Flame 133, 275–287.Google Scholar
Shoshin, Y. L. & Dreizin, E. 2004 Laminar lifted flame speed measurements for aerosols of metals and metallic alloys. AIAA J. 42, 1416–1426.Google Scholar
Shoshin, Y. L. & Dreizin, E. 2006 Particle combustion rates for mechanically alloyed Al–Ti and aluminum powders burning in air. Combust. Flame 145, 714–722.Google Scholar
Williams, F. A. 1985 Combustion Theory, 2nd edn. Benjamin Cummings.Google Scholar
Xu, H.2008 Quenching of particle-gas combustible mixtures using the electric particulate suspension (EPS) method. PhD thesis, Iowa State University, Ames, IA (http://lib.dr.iastate.edu/etd/10635).Google Scholar
Yu, T.-U. & Colver, G. M. 1987 Spark breakdown of particulate clouds: a new testing device. IEEE Trans. Ind. Applics. 23, 127–133.Google Scholar
Zhebelev, S. I. 1991 Electrodynamic fluidization of microparticles with a finite electrical conductivity. J. Engng Phys. 60, 576–580.Google Scholar
Zhebelev, S. I. 1992 Longitudinal nonuniformity with a consideration of gravity in an electrodynamic fluidization system. J. Engng Phys. Thermophys. 62, 310–315.Google Scholar
Zhebelev, S. I. 1993 Electric field dependence of the limiting concentration of an EDF system. J. Engng Phys. Thermophys. 65, 1052–1057.Google Scholar