Hostname: page-component-78c5997874-fbnjt Total loading time: 0 Render date: 2024-11-09T08:48:39.210Z Has data issue: false hasContentIssue false

Transient and steady shapes of droplets attached to a surface in a strong electric field

Published online by Cambridge University Press:  24 September 2004

S. N. REZNIK
Affiliation:
Faculty of Mechanical Engineering, Technion – Israel Institute of Technology, Haifa 32000, Israel
A. L. YARIN
Affiliation:
Faculty of Mechanical Engineering, Technion – Israel Institute of Technology, Haifa 32000, Israel
A. THERON
Affiliation:
Faculty of Mechanical Engineering, Technion – Israel Institute of Technology, Haifa 32000, Israel
E. ZUSSMAN
Affiliation:
Faculty of Mechanical Engineering, Technion – Israel Institute of Technology, Haifa 32000, Israel

Abstract

The shape evolution of small droplets attached to a conducting surface and subjected to relatively strong electric fields is studied both experimentally and numerically. The problem is motivated by the phenomena characteristic of the electrospinning of nanofibres. Three different scenarios of droplet shape evolution are distinguished, based on numerical solution of the Stokes equations for perfectly conducting droplets. (i) In sufficiently weak (subcritical) electric fields the droplets are stretched by the electric Maxwell stresses and acquire steady-state shapes where equilibrium is achieved by means of the surface tension. (ii) In stronger (supercritical) electric fields the Maxwell stresses overcome the surface tension, and jetting is initiated from the droplet tip if the static (initial) contact angle of the droplet with the conducting electrode is $\alpha_{s}\,{<}\,0.8\pi $; in this case the jet base acquires a quasi-steady, nearly conical shape with vertical semi-angle $\beta \,{\leq}\, 30^{\circ}$, which is significantly smaller than that of the Taylor cone ($\beta_{T}\,{=}\,49.3^{\circ}$). (iii) In supercritical electric fields acting on droplets with contact angle in the range $0.8\pi \,{<}\,\alpha_{s}\,{<}\,\pi $ there is no jetting and almost the whole droplet jumps off, similar to the gravity or drop-on-demand dripping. The droplet–jet transitional region and the jet region proper are studied in detail for the second case, using the quasi-one-dimensional equations with inertial effects and such additional features as the dielectric properties of the liquid (leaky dielectrics) taken into account. The flow in the transitional and jet region is matched to that in the droplet. By this means, the current–voltage characteristic $I\,{=}\,I(U)$ and the volumetric flow rate $Q$ in electrospun viscous jets are predicted, given the potential difference applied. The predicted dependence $I\,{=}\,I(U)$ is nonlinear due to the convective mechanism of charge redistribution superimposed on the conductive (ohmic) one. For $U\,{=}\,O(10kV)$ and fluid conductivity $\sigma \,{=}\,10^{-4}$ S m$^{-1}$, realistic current values $I\,{=}\,O(10^{2}nA)$ were predicted.

Type
Papers
Copyright
© 2004 Cambridge University Press

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)