Hostname: page-component-cd9895bd7-fscjk Total loading time: 0 Render date: 2024-12-27T14:21:43.018Z Has data issue: false hasContentIssue false
  • English
  • Français

Reverse flow in a channel with an obstruction at the entry

Published online by Cambridge University Press:  26 April 2006

B. H. Lakshmana Gowda  and
E. G. Tulapurkara
B. H. Lakshmana Gowda
Affiliation:
Fluid Mechanics Laboratory, Department of Applied Mechanics, Indian Institute of Technology, Madras-600036, India
E. G. Tulapurkara
Affiliation:
Department of Aeronautical Engineering, Indian Institute of Technology, Madras-600036, India
Get access Rights & Permissions [Opens in a new window]

Abstract

In this study the flow through and around a parallel-walled channel with an obstruction (flat plate) placed at the channel inlet is investigated. Depending on the position of the obstruction, the flow inside the channel is in a direction opposite to that outside, stagnant or in the same direction as outside but with reduced magnitude. Flow visualization in water is used to examine the fluid motion, although some wind tunnel measurements have been made and are also reported. The parameters that have been varied are the gap between the obstruction and the entry to the channel, the length of the channel and the Reynolds number. The maximum value of the reverse flow velocity is found to be about 20% of that of the flow outside. The maximum forward velocity inside the channel (when it occurs) is only about 65% of the outside velocity even for very large gaps between the obstruction and the channel entrance. A tentative explanation is offered for the observed features.

Type
Research Article
Information
Journal of Fluid Mechanics , Volume 204 , July 1989 , pp. 229 - 244
Copyright
© 1989 Cambridge University Press

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

Abernathy, F. H. & Kronauer, R. E., 1962 The formation of vortex streets. J. Fluid Mech. 13, 1–20.Google Scholar
Batchelor, G. K.: 1967 An Introduction to Fluid Dynamics. Cambridge University Press.
Chang, P. K.: 1970 Separation of Flow, p. 345. Pergamon.
Davis, C. G. & Sorenson, K. E., (eds) 1969 Handbook of Applied Hydraulics, pp. 37–29 to 37–37. McGraw-Hill.
Eom, K.: 1988 Performance of a butterfly valve as a flow controller. Trans. ASME I: J. Fluids Engng 110, 16–19.Google Scholar
Gerrard, J. H.: 1966 The mechanics of the formation region of vortices behind bluff bodies. J. Fluid Mech. 25, 401–413.Google Scholar
Gerrard, J. H.: 1978 The wakes of cylindrical bluff bodies at low Reynolds numbers. Phil. Trans. R. Soc. Lond. A 288, 351–382.Google Scholar
Hutchison, J. W. (ed.). 1976 ISA Handbook of Control Valves.
Kiya, M. & Matsumara, M., 1988 Incoherent turbulence structure in the near wake of a normal plate. J. Fluid Mech. 190, 343–356.Google Scholar
Perry, A. E. & Steiner, T. R., 1987 Large-scale vortex structure in turbulent wakes behind bluff bodies. J. Fluid Mech. 174, 233–270.Google Scholar
Pierce, D.: 1961 Photographic evidence of the formation and growth of vorticity behind plates accelerated from rest in still air. J. Fluid Mech. 11, 460–464.Google Scholar
Smits, A. J.: 1982 A visual study of separation bubble. In Proc. 2nd Intl. Symp. on Flow Visualisation, Bochum, Sept. 9–12, 1980 (ed. W. Merzkirch). Hemisphere.
Streeter, V. L. (ed.) 1961 Handbook of Fluid Dynamics, pp. 21–29 to 21–40. McGraw-Hill.
Tulapurkara, E. G., Gowda, B. H. Lakshmana & Balachandran, N. 1988 Laminar flow through slots. J. Fluid Mech. 190, 179–200.Google Scholar
Unal, M. F. & Rockwell, D., 1988a On vortex formation from a cylinder. Part 1. The initial instability. J. Fluid Mech. 190, 491–512.Google Scholar
Unal, M. F. & Rockwell, D., 1988b On vortex formation from a cylinder. Part 2. Control by splitter-plate interference. J. Fluid Mech. 190, 513–529.Google Scholar