Hostname: page-component-78c5997874-fbnjt Total loading time: 0 Render date: 2024-11-19T10:57:11.025Z Has data issue: false hasContentIssue false
  • English
  • Français

Organized structures in a compressible, turbulent boundary layer

Published online by Cambridge University Press:  21 April 2006

Eric F. Spina  and
Alexander J. Smits
Eric F. Spina
Affiliation:
Gas Dynamics Laboratory, Department of Mechanical and Aerospace Engineering, Princeton University, Princeton, NJ 08544, USA
Alexander J. Smits
Affiliation:
Gas Dynamics Laboratory, Department of Mechanical and Aerospace Engineering, Princeton University, Princeton, NJ 08544, USA
Get access Rights & Permissions [Opens in a new window]

Abstract

Experimental results are presented that show the existence of organized structures in a compressible, turbulent boundary layer. Results were obtained using arrays of hot wires and wall pressure transducers in a Mach-3 zero-pressure-gradient boundary layer. The VITA method of conditional sampling was used to deduce average pressure events at the wall and mass flux events throughout the boundary layer; these results show qualitative similarity to those found in incompressible flows. By conditioning upon the middle hot wire from a three-wire probe, evidence is found suggesting that structures exist of a height comparable with the boundary-layer thickness. Furthermore, two-point conditional sampling was used to show that an average pressure event could be extracted by conditioning upon mass-flux events. From this procedure we found that the structures maintain their shape as they travel downstream and also that their spanwise extent is very limited.

The inferred angle from correlations between two hot wires, and between a hot wire and a wall-pressure transducer, indicate that the average structure is inclined at approximately 45° for a large part of the boundary layer. This result agrees well with structures observed in schlieren photographs of supersonic boundary layers. Measurements of the instantaneous angle show a wide distribution of structure angles, and the general behaviour of the large-scale structures is consistent with the hairpin loop model of wall turbulence.

Type
Research Article
Information
Journal of Fluid Mechanics , Volume 182 , September 1987 , pp. 85 - 109
Copyright
© 1987 Cambridge University Press

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

Blackwelder, R. F. & Kaplan, R. E. 1976 On the wall structure of the turbulent boundary layer. J. Fluid Mech. 76, 89.Google Scholar
Bogard, D. G. & Tiederman, W. G. 1986 Burst detection with single-point velocity measurements. J. Fluid Mech. 162, 389.Google Scholar
Brown, G. L. & Thomas, A. S. W. 1977 Large structure in a turbulent boundary layer. Phys. Fluids 20, 243.Google Scholar
Chen, C. P. & Blackwelder, R. F. 1978 Large-scale motion in a turbulent boundary layer: a study using temperature contamination. J. Fluid Mech. 89, 1.Google Scholar
Deckker, B. E. L. 1980 An investigation of some unsteady boundary layers by the schlieren method. Intl Symp. on Flow Visualization, Ruhr-Universität.
Deckker, B. E. L. & Weekes, M. E. 1976 The unsteady boundary layer in a shock tube. Proc. Instn Mech. Engrs 190, 287.Google Scholar
Dussauge, J. P. & Gaviglio, J. 1981 Bulk dilatation effects on Reynolds stress in the rapid expansion of a turbulent boundary layer at supersonic speed. Proc. Third Symp. on Turbulent Shear Flows, Univ. California, Davis.
Fernholz, H. H. & Finley, P. J. 1980 A critical commentary on mean flow data for two-dimensional compressible turbulent boundary layers. AGARDograph No. 253.
Hanly, R. D. 1975 Effects of transducer flushness on fluctuating surface pressure measurements. AIAA Paper 75–534.
Head, M. R. & Bandyopadhyay, P. 1981 New aspects of turbulent boundary-layer structure. J. Fluid Mech. 107, 297.Google Scholar
Jayaram, M., Taylor, M. W. & Smits, A. J. 1987 The response of a compressible turbulent boundary layer to short regions of concave surface curvature. J. Fluid Mech. 175, 343.Google Scholar
Johansson, A. V. & Alfredsson, P. H. 1982 On the structure of turbulent channel flow. J. Fluid Mech. 122, 295.Google Scholar
Kline, S. J., Cantwell, B. J. & Lilley, G. M. 1981 Proc. 1980–81 AFOSR-HTTM Stanford Conf. on Complex Turbul. Flow: Comparison of Computation and Experiment, Vol. 1. Thermo Sci. Div., Stanford University, Stanford, CA.
Kline, S. J., Reynolds, W. C., Schraub, F. A. & Runstadler, P. W. 1967 The structure of turbulent boundary layers. J. Fluid Mech. 30, 741.Google Scholar
Kovasznay, L. S. G. 1950 The hot-wire anemometer in supersonic flow. J. Aero. Sci. 17, 565.Google Scholar
Moin, P. & Kim, J. 1985 The structure of the vorticity field in turbulent channel flow. Part 1. Analysis of instantaneous fields and statistical correlations. J. Fluid Mech. 155, 441.Google Scholar
Morkovin, M. V. 1962 Effects of compressibility on turbulent flows. Int. Symp. on the Mechanique de la Turbulence, p. 367. Centre National de la Recherche Scientifique, Paris.
Offen, G. R. & Kline, S. J. 1974 Combined dye streak and hydrogen bubble visual observations of a turbulent boundary layer. J. Fluid Mech. 62, 223.Google Scholar
Offen, G. R. & Kline, S. J. 1975 A proposed model of the bursting process in turbulent boundary layers. J. Fluid Mech. 70, 209.Google Scholar
Owen, F. K. & Horstman, C. C. 1972 On the structure of hypersonic turbulent boundary layers. J. Fluid Mech. 53, 611.Google Scholar
Owen, F. K. & Horstman, C. C. 1981 Turbulent measurements in an equilibrium hypersonic boundary layer. AIAA Paper 74–93.
Owen, F. K., Horstman, C. C. & Kussoy, M. I. 1975 Mean and fluctuating flow measurements of a fully-developed, non-adiabatic, hypersonic boundary layer. J. Fluid Mech. 70, 393.Google Scholar
Rajagopalan, S. & Antonia, R. A. 1979 Some properties of the large structure in a fully developed turbulent duct flow. Phys. Fluids 22, 614.Google Scholar
Robinson, S. K. 1985 Instantaneous velocity profile measurements in a turbulent boundary layer. Chem. Engng Commun. 43, 347.Google Scholar
Robinson, S. K. 1986 Space—time correlation measurements in a compressible turbulent boundary layer. AIAA Paper 86–1130.
Settles, G. S. 1975 An experimental study of compressible turbulent boundary layer separation at high Reynolds number. Ph.D. thesis, Mechanical and Aerospace Engineering Department, Princeton University
Smith, C. R. 1984 A synthesized model of the near-wall behavior in turbulent boundary layers. In Proc. Eighth Symposium on Turbulence (ed. G. K. Patterson & J. L. Zakin), Department of Chemical Engineering, University of Missouri-Rolla.
Smits, A. J., Hayakawa, K. & Muck, K. C. 1983 Constant-temperature hot-wire anemometer practice in supersonic flows. Part I—The normal wire. Exp. Fluids.
Smits, A. J. & Muck, K. C. 1987 Experimental study of three shock wave/turbulent boundary layer interactions. J. Fluid Mech. 182, 291.Google Scholar
Spina, E. F. & Smits, A. J. 1986 Organized structures in a supersonic, turbulent boundary layer. MAE Rep. 1736. Princeton University.
Subramanian, C. S., Rajagopalan, S., Antonia, R. A. & Chambers, A. J. 1982 Comparison of conditional sampling and averaging techniques in a turbulent boundary layer. J. Fluid Mech. 123, 335.Google Scholar
Taylor, M. W. 1984 A supersonic turbulent boundary layer on concavely curved surfaces. M.S.E. thesis, Mechanical and Aerospace Engineering Department, Princeton University
Thomas, A. S. W. & Bull, M. K. 1983 On the role of wall-pressure fluctuations in deterministic motions in the turbulent boundary layer. J. Fluid Mech. 128, 283.Google Scholar
Van Dyke, M. 1982 An Album of Fluid Motion. Stanford: Parabolic.
Wyngaard, J. C. 1968 Measurements of small-scale turbulence with hot-wires. J. Phys. E: Sci. Instrum. 1, 1105Google Scholar