Hostname: page-component-cd9895bd7-p9bg8 Total loading time: 0 Render date: 2024-12-26T01:28:53.740Z Has data issue: false hasContentIssue false
  • English
  • Français

Stationary planar-surface target detection in an unknown indoor environment

Published online by Cambridge University Press:  25 March 2015

Honghui Yan ,
Qiaozhen Liu  and
Reiner S. Thomä
Honghui Yan*
Affiliation:
Electronic Measurement Research Lab, Institute for Information Technology, Ilmenau University of Technology, Ilmenau 98693, Germany
Qiaozhen Liu
Affiliation:
Beijing Institute of Astronautical Systems Engineering, Beijing 100076, China
Reiner S. Thomä
Affiliation:
Electronic Measurement Research Lab, Institute for Information Technology, Ilmenau University of Technology, Ilmenau 98693, Germany
*
Corresponding author: H. Yan, Email: [email protected]
Get access Rights & Permissions [Opens in a new window]

Abstract

It is difficult to detect a stationary object in practice, especially in an unknown indoor environment, because (a) there is no distinct speed difference between the targets and the background; (b) responses of the targets are contaminated by dense unknown clutter; (c) a priori knowledge of the background is not always available for some scenarios. In this paper, a set of ultra-wideband sensors are used to detect a stationary target with a planar diffuse surface. It is shown that, the relative spectrum-shifts of the data after data-projection operation, are closely connected to the illumination-angle differences. Based on this, a detector is designed, and the location and the orientation of the target are determined. In order to mitigate the influence of clutters, a “time-shift & accumulation” scheme is designed to enhance the signal. As a consequence, the signal-to-interference-and-noise ratio is increased. In addition, results from measurement in a realistic indoor environment are provided.

Keywords

Radar signal processing and system modelingRadar applicationsStationary target detection
Type
Research Paper
Information
International Journal of Microwave and Wireless Technologies , Volume 8 , Issue 3: Journee Nationale des Micro-ondes (JNM) 2015 , May 2016 , pp. 603 - 613
Copyright
Copyright © Cambridge University Press and the European Microwave Association 2015 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

[1]Scheer, W.L.M.J.A. (ed.): Principles of Modern Radar, vol. III of Radar Applications, SciTech Publishing, an imprint of the IET, Edison, NJ, 2014.Google Scholar
[2]Moura, J.M.F.; Jin, Y.: Time reversal imaging by adaptive interference canceling. IEEE Trans. Signal Process., 56 (1) (2008), 233–247.Google Scholar
[3]Varslot, T.; Yazici, B.; Yarman, C.-E.; Cheney, M.; Scharf, L.: Time-reversal waveform preconditioning for clutter rejection, in Proc. Int. Waveform Diversity and Design Conf., 2007, 330–334.Google Scholar
[4]Borcea, L.; Papanicolaou, G.; Tsogka, C.; Berryman, J.: Imaging and time reversal in random media. Inverse Probl., 18 (2002), 1247.Google Scholar
[5]Zhang, W.; Hoorfar, A.; Li, L.: Through-the-wall target localization with time reversal music method. Progress Electromagn. Res., 106 (2010), 75–89.Google Scholar
[6]Wang, L.J.Z.H.F.: Experimental investigation of selective localization by decomposition of the time reversal operator and subspace-based technique. IET Radar, Sonar Navig., 2 (6) (2008), 426–434.Google Scholar
[7]van den Bos, A.: The multivariate complex normal distribution-a generalization. IEEE Trans. Inf. Theory, 41 (2) (1995), 537–539.Google Scholar
[8]Kobayashi, H.; Mark, B.L.; Turin, W.: Probability, Random Processes, and Statistical Analysis, Cambridge University Press, Cambridge, UK, 2012.Google Scholar
[9]Poor, H.V.: An Introduction to Signal Detection and Estimation, Chapter III, 2nd ed., Springer-Verlag, New York, 1994.CrossRefGoogle Scholar
[10]Zetik, R.; Sachs, J.; Thoma, R.S.: Uwb short-range radar sensing – the architecture of a baseband, pseudo-noise UWB radar sensor. IEEE Instrum. Meas. Mag., 10 (2) (2007), 39–45.Google Scholar
[11]Prati, C.; Rocca, F.: Improving slant-range resolution with multiple SAR surveys. IEEE Trans. Aerosp. Electron. Syst., 29 (1) (1993), 135–143.Google Scholar