Hostname: page-component-586b7cd67f-tf8b9 Total loading time: 0 Render date: 2024-11-22T07:54:17.226Z Has data issue: false hasContentIssue false

Reconfigurable radar transmitter based on photonic microwave signal generation

Published online by Cambridge University Press:  25 March 2011

Francesco Laghezza*
Affiliation:
Department of Information Engineering, University of Pisa, via Caruso 16, 56122 Pisa, Italy. Phone:  + 39 0502217673. CNIT-RaSS (National Inter-University Consortium for Telecommunications – Radar and Surveillance System Research Center), via Moruzzi 1, 56124 Pisa, Italy.
Fabrizio Berizzi
Affiliation:
Department of Information Engineering, University of Pisa, via Caruso 16, 56122 Pisa, Italy. Phone:  + 39 0502217673. CNIT-RaSS (National Inter-University Consortium for Telecommunications – Radar and Surveillance System Research Center), via Moruzzi 1, 56124 Pisa, Italy.
Amerigo Capria
Affiliation:
CNIT-RaSS (National Inter-University Consortium for Telecommunications – Radar and Surveillance System Research Center), via Moruzzi 1, 56124 Pisa, Italy.
Andrea Cacciamano
Affiliation:
CNIT-RaSS (National Inter-University Consortium for Telecommunications – Radar and Surveillance System Research Center), via Moruzzi 1, 56124 Pisa, Italy.
Giovanni Serafino
Affiliation:
Scuola Superiore Sant'Anna, via Moruzzi 1, 56124 Pisa, Italy.
Paolo Ghelfi
Affiliation:
CNIT-NLPN (National Inter-University Consortium for Telecommunications – National Laboratory of Photonics Network), via Moruzzi 1, 56124 Pisa, Italy.
Antonella Bogoni
Affiliation:
CNIT-NLPN (National Inter-University Consortium for Telecommunications – National Laboratory of Photonics Network), via Moruzzi 1, 56124 Pisa, Italy.
*
Corresponding author: F. Laghezza Email: [email protected]

Abstract

In this paper we propose a photonic technique for a reconfigurable microwave signal generation based on the beating of two laser modes coming from a regenerative fiber mode-locked laser (FMLL) into a photodiode. The excellent performance of this kind of pulsed laser guarantees high stability on the directly generated microwave signal even at ultrahigh frequencies (up to W band). Therefore, by using the proposed architecture, the performance of a reconfigurable full digital coherent radar system can be enhanced for example in terms of moving target indicator (MTI) improvement factor and analog to digital converter maximum signal to noise ratio. Differently from the conventional radar oscillators, whose performance strongly deteriorate with increasing frequencies, the photonic radio frequency (RF) generation always shows an excellent spectral purity. Moreover, thanks to the achievable high repetition rates and the coherence properties of the FMLL, this laser scheme has also been proposed for digitizing, directly at RF, the received signal by electro-optical sampling. Thus the advantage of using just one device for signal generation in both the transmitter and receiver chain, makes the proposed solution a cost-effective architecture for microwave signal generation.

Type
Research Papers
Copyright
Copyright © Cambridge University Press and the European Microwave Association 2011

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

[1]Peacock, C.J.; Pearson, G.S.: Digital radar, in Proc. of the IET Int. Conf. on Radar System, 2007.CrossRefGoogle Scholar
[2]Chan, Y.K.; Lim, S.Y.: Synthetic aperture radar (SAR) signal generation. Prog. Electromagn. Res. B, 1 ( 2008), 269290.CrossRefGoogle Scholar
[3]Dispenza, M. et al. : Tuneable optoelectronic oscillator based on a frequency shifter, in Proc. of the 6th European Radar Conf., 2009, paper 262.Google Scholar
[4]Song, S.-C.; Hong, Y.-S.: A new approach for evaluating the phase noise requirements of STALO in a Doppler radar, in Proc. of the 37th European Microwave Conf., October 2007, Munich, Germany.Google Scholar
[5]Brooker, M.: The Design and Implementation of a Simulator for Multistatic Radar Systems. Department of Electrical Engineering, University of Cape Town, June 2008.Google Scholar
[6]Pierno, L.; Dispenza, M.; Tonelli, G.; Bogoni, A.; Ghelfi, P.; Potì, L.: A photonic ADC for radar and EW applications based, in MWP 2008, Australia.CrossRefGoogle Scholar
[7]Ghelfi, P.; Serafino, G.; Berizzi, F.; Bogoni, A.: Generation of highly stable microwave signals based on regenerative fiber mode locking laser, Proc of Laser and Electro-Optics Conference, CLEO 2010.CrossRefGoogle Scholar
[8]Goldberg, L.; Taylor, H.F.; Weller, J.F.; Bloom, D.M.: Microwave signal generation with injection laser diodes. Electron. Lett., 19 (13) (1983), 491493.CrossRefGoogle Scholar
[9]Cox, C.H. III: Limits on the performance of RF-over fiber links and their impact on device design. IEEE Trans. Microw. Theory Tech., 54 (2) (2006), 906920.CrossRefGoogle Scholar
[10]Bogoni, A.; Berizzi, F.: PHOtonic-based Full Digital Radar, Tech. Rep. WP1-Feasibility Study, National Lab of Photonic Network and RaSS Center, 2009.Google Scholar
[11]MAXIM: Clock (CLK) Jitter and Phase Noise Conversion, Application Note 3359, December 10, 2004.Google Scholar
[12]Walt Kester: Converting Oscillator Phase Noise to Time Jitter, Analog Device MT-008 Tutorial.Google Scholar
[13]Banchi, L.; Rossi, F.; Ferianis, M.; Bogoni, A.; Potì, L.; Ghelfi, P.: Synchronization of 3 GHz repetition rate harmonically mode-locked fiber laser for optical timing applications, in Proc. of DIPAC 2007 the 37th European Microwave Conf., October 2007, Italy.Google Scholar
[14]Serafino, G. et al. : Photonic Generation of RF Multiple Carriers Using a Mode-Locked Laser and a Single Photodiode, Paper Number 7960-27, Photonics West, San Francisco 2010.Google Scholar