Hostname: page-component-cd9895bd7-q99xh Total loading time: 0 Render date: 2024-12-23T23:15:48.208Z Has data issue: false hasContentIssue false

Impulse response analysis of coherent waveguide communication

Published online by Cambridge University Press:  06 December 2017

Yanghyo Kim*
Affiliation:
Jet Propulsion Laboratory, Pasadena, CA, USA University of California Los Angeles, CA, USA
Adrian Tang
Affiliation:
Jet Propulsion Laboratory, Pasadena, CA, USA University of California Los Angeles, CA, USA
Jason Cong
Affiliation:
University of California Los Angeles, CA, USA
Mau-Chung Frank Chang
Affiliation:
University of California Los Angeles, CA, USA
Tatsuo Itoh
Affiliation:
University of California Los Angeles, CA, USA
*
Corresponding author: Yanghyo Kim Email: [email protected]

Abstract

An impulse response method is carried out to analyze waveguide's information capacity within a coherent communication system. Such capability is typically estimated according to group delay variations (seconds/bandwidth/distance) after carrier-modulated data undergoes a dispersive medium. However, traditional group delay methods often ignore non-linear effects by assuming input data stream only occupies narrow bandwidth such that a propagation constant can be linearized centered at the carrier frequency. Such a constraint can be lifted with a proposed baseband equivalent impulse response method by using frequency domain convolution and multiplication. Once the impulse response in frequency domain is secured, its time domain counterpart can be calculated based on inverse Fourier transformation. Such analysis can fully reveal data pulse's broadening and gauge its inter-symbol interference by simply convolving input data with extracted impulse response, not limited to specific frequency range or type of waveguide.

Type
Research Papers
Copyright
Copyright © Cambridge University Press and the European Microwave Association 2017 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

[1]Yeh, C.; Shimabukuro, F.; Siegel, P.H.: Low-loss terahertz ribbon waveguide. Appl. Opt., 44 (28) (2005), 59375946.Google Scholar
[2]Tanaka, Y. et al. : A versatile multi-modality serial link, in IEEE Int. Solid-State Circuits Conf., 2012, 331–332.Google Scholar
[3]Kim, Y.; Nan, L.; Cong, J.; Chang, M.C.F.: High-speed mm-wave data-link based on hollow plastic cable and CMOS transceiver. IEEE Microw. Wireless Compon. Lett., 23 (12) (2013), 674676.Google Scholar
[4]Volkaerts, W.; Thienen, N.V.; Reynaert, P.: An FSK plastic waveguide communication link in 40 nm CMOS, in IEEE Int. Solid-State Circuits Conf., 2015, 1–3.CrossRefGoogle Scholar
[5]Song, H.I.; Jin, H.; Bae, H.M.: Plastic straw: future of high-speed signaling. Nat. Sci. Rep., 5 (2015), 16062.Google Scholar
[6]Kikuchi, K.: Fundamentals of coherent optical fiber communications. IEEE J. Lightwave Technol., 34 (1) (2016), 157179.Google Scholar
[7]Kapron, F.P.; Keck, D.B.: Pulse transmission through a dielectric optical waveguide. Appl. Opt., 10 (7) (1971), 15191523.Google Scholar
[8]Kim, Y.; Cho, W.; Du, Y.; Cong, J.; Itoh, T.; Chang, M.C.F.: Impulse response analysis of carrier-modulated multiband RF-interconnect (MRFI). Springer Analog Integr. Circuits Signal Process., 93 (3) (2017), 395413.Google Scholar
[9]Azadet, K. et al. : Equalization and FEC techniques for optical transceivers. IEEE J. Solid State Circuits, 37 (3) (2002), 317327.Google Scholar
[10]Maeng, M. et al. : 0.18-µm CMOS equalization techniques for 10-Gb/s fiber optical communication links. IEEE Trans. Microw. Theory Tech., 53 (11) (2005), 35093519.Google Scholar
[11]Gondi, S.; Razavi, B.: Equalization and clock and data recovery techniques for 10-Gb/s CMOS serial-link receivers. IEEE J. Solid State Circuits, 42 (9) (2007), 19992011.Google Scholar
[12]Gloge, D.: Impulse response of clad optical multimode fibers. Bell Syst. Tech. J., 52 (6) (1973), 801816.Google Scholar
[13]Dannwolf, J.W.; Gottfried, S.; Sargent, G.A.; Strum, R.C.: Optical-fiber impulse-response measurement system. IEEE Trans. Instrum. Meas., 25 (4) (1976), 401406.Google Scholar
[14]Okamoto, K.: Comparison of calculated and measured impulse responses of optical fibers. Appl. Opt., 18 (13) (1979), 21992206.Google Scholar
[15]Chatterjee, M.R.; Green, L.S.: Derivation of impulse response and transfer function of an optical fiber under chromatic dispersion and application to a linear fiber-optic communication system. IEEE South. Tier Tech. Conf., (1990), 209216.Google Scholar
[16]Cho, W. et al. : A 5.4-mW 4-Gb/s 5-band QPSK transceiver for frequency-division multiplexing memory interface, in IEEE Custom Integrated Circuits Conf., 2015.Google Scholar
[17]Cho, W. et al. : A 38 mW 40Gb/s 4-lane tri-band/16-QAM transceiver in 28 nm CMOS for high-speed memory interface, in IEEE Int. Solid State Circuits Conf., 2016.Google Scholar
[18]Pozar, D.M.: Microwave Engineering, 3rd ed. John Wiley & Sons, Inc, Hoboken, USA, 2005.Google Scholar
[19]Afsar, M.N.: Precision dielectric measurements of nonpolar polymers in the millimeter wavelength range. IEEE Trans. Microw. Theory Tech., 33 (12) (1985), 14101415.Google Scholar
[20]Kam, D.G.; Kim, J.: 40-Gb/s package design using wire-bonded plastic ball grid array. IEEE Trans. Adv. Packag., 31 (2) (2008), 258266.Google Scholar
[21]Du, Y. et al. : A 16-Gb/s 14-mW tri-band cognitive serial link transmitter with forwarded clock to enable PAM-16/256-QAM and channel response detection. IEEE J. Solid State Circuits, 52 (4) (2016), 11111122.Google Scholar
[22]Kim, Y. et al. : Analysis of noncoherent ASK modulation-based RF-interconnect for memory interface. IEEE J. Emerg. Sel. Top. Circuits Syst., 2 (2) (2012), 200209.Google Scholar
[23]Yeh, C.; Shimabukuro, F.I.: The Essence of Dielectric Waveguide. Springer, New York, USA, 2008.Google Scholar
[24]Collins, R.E.: Field Theory of Guided Waves, 2nd ed. John Wiley & Sons, Inc, New York, USA, 1990.Google Scholar
[25]Imbriale, W.A.; Otoshi, T.Y.; Yeh, C.: Power loss for multimode waveguides and its application to beam-waveguide system. IEEE Trans. Microw. Theory Tech., 46 (5) (1998), 523529.Google Scholar