Hostname: page-component-586b7cd67f-l7hp2 Total loading time: 0 Render date: 2024-11-26T05:14:49.797Z Has data issue: false hasContentIssue false
  • English
  • Français

Gain enhancement of UWB antenna using partially reflective surface

Published online by Cambridge University Press:  22 March 2018

Pravin R. Prajapati  and
Shailesh B. Khant
Pravin R. Prajapati*
Affiliation:
Center of Research in Optical, Microwave and Antenna (CROMA) Department of Electronics and Communication Engineering, A D Patel Institute of Technology, Gujarat, India, 388121
Shailesh B. Khant
Affiliation:
Center of Research in Optical, Microwave and Antenna (CROMA) Department of Electronics and Communication Engineering, A D Patel Institute of Technology, Gujarat, India, 388121
*
Author for correspondence: Pravin R. Prajapati, E-mail: [email protected]
Get access Rights & Permissions [Opens in a new window]

Abstract

This paper proposes, a high gain, Fabry Perot cavity antenna with coplanar waveguide (CPW) fed ultra wide band (UWB) radiating element. The proposed antenna has flat edge arrow shape-based radiating element, which act as a main radiating element and responsible for UWB radiation. This UWB microstrip antenna is parasitically coupled with an array of square parasitic patches (PPs), which act as partially reflective surface. The square patches are fabricated at the bottom of inexpensive FR4 substrate and suspended in the air with the help of dielectric rods at 1.5λ0 height. High gain is obtained by resonating PPs at near close frequencies of 3.8–8.8 GHz UWB, where partially reflective surface gives almost positive reflection phase gradients. Two laboratory prototypes of antenna, one with and another without partially reflective surface are fabricated and tested. Details of the proposed antenna design and role of partially reflective surface in gain enhancement of planar CPW fed UWB antenna are described, and typical experimental results are presented and discussed.

Keywords

Antenna designmodelling and measurementspassive components andcircuits
Type
Research Papers
Information
International Journal of Microwave and Wireless Technologies , Volume 10 , Special Issue 7: Electronic Warfare , September 2018 , pp. 835 - 842
Copyright
Copyright © Cambridge University Press and the European Microwave Association 2018 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1.Federal Communications Commission, (2002) Federal Communications Commission Revision of Part 15 of The Commission'S Rules Regarding Ultra-Wideband Transmission System from 3.1 to 10.6 GHz, Washington, DC, USA.Google Scholar
2.Allen, B, Dohler, M, Okon, E, Malik, W, Brown, A, Edwards, D (eds). (2007) Ultrawide Band Antenna and Propagation for Communications, Radar and Imaging. England: John Wiley & Sons.Google Scholar
3.Liang, XL (2012) Ultra Wideband Antenna Design: Ultra Widebad Current Status and Future Trends. Chapter 7. InTech Publication.Google Scholar
4.Gopalkrishna, M, Krishna, DD, Chandran, AR and Anandan, CK (2007) Square monopole antenna for ultra wide band communication applications. Journal of Electromagnetics Waves and Applications 21(11).Google Scholar
5.Singhal, S, Pandey, A and Singh, A (2017) CPW-fed circular-shaped fractal antenna with three iterations for UWB applications. International Journal of Microwave and Wireless Technologies 9(2), 373–379.Google Scholar
6.Ghosh, A and Das, S (2014) Gain Enhancement of Slot Antenna Using Laminated Conductor Layers, International Conference on Devices, Circuits and Communications (ICDCCom), Ranchi, India, 1–4.Google Scholar
7.Zhao, X, Huang, Y, Li, J, Zhang, Q and Wen, G, (2017) Wideband High Gain Circularly Polarized UHF RFID Reader Microstrip Antenna And Array. AEU - International Journal of Electronics and Communications 77, 76–81.Google Scholar
8.Lin, YF, Chang, MJ, Chen, HM and Lai, BY (2016) Gain enhancement of ground radiation antenna for RFID tag mounted on metallic plane. IEEE Transactions on Antennas and Propagation 64(4), 1193–1200.Google Scholar
9.Cheung, SW, Li, QL, Wu, D, Yuk, TI and (2016) Microwave Lens Using Multi-Layer Substrates For Antenna Gain Enhancement. 10th European Conference on Antennas and Propagation (EuCAP), Davos, 1–4.Google Scholar
10.Guan, DF, Zhang, YS, Qian, ZP, Li, Y, Cao, W and Yuan, F (2016) Compact microstrip patch array antenna with parasitically coupled feed. IEEE Transactions on Antennas and Propagation 64(6), 2531–2534.Google Scholar
11.Costa, F and Monorchio, A (2011) Design of sub-wavelength tunable and steerable fabry-parot leaky wave antennas. Progress in Electromagnetics Research 111, 467–481.Google Scholar
12.Meng, FY, Lyu, YL, Zhang, K, Wu, Q and Li, LW (2012) A detached zero index metamaterial lens for antenna gain enhancement. Progress In Electromagnetics Research 132, 463–478.Google Scholar
13.Amiri, MA, Balanis, CA and Birtcher, CR (2017) Gain and bandwidth enhancement of a spiral antenna using a circularly symmetric HIS. IEEE Antennas and Wireless Propagation Letters 16, 1080–1083.Google Scholar
14.Konstantinidis, K, Feresidis, P and Hall, S (2014) Multilayer partially reflective surfaces for broadband fabry-perot cavity antennas. IEEE Transactions on Antennas and Propagation 62(7), 3474–3481.Google Scholar
15.Boutayeb, H, Denidni, TA and Nedil, M (2007) Bandwidth widening techniques for directive antennas based on partially reflecting surfaces. Progress in Electromagnetics Research, PIER 74, 407–419.Google Scholar
16.Ge, Y, Esselle, KP and Bird, TS (2009) Designing A Partially Reflective Surface With Increasing Reflection Phase For Wide-Band EBG Resonator Antennas. IEEE Antennas and Propagation Society International Symposium, Charleston, SC, 1–4.Google Scholar
17.Pozar, D (1998) Microwave Engineering, 2nd edn., New York, NY: Wiley.Google Scholar
18.CST Microwave Studio Simulator, Version 2017.Google Scholar
19.Feresidis, AP and Vardaxoglou, JC (2001) High gain planar antenna using optimised partially reflective surfaces. IEE Proceedings Microwaves, Antennas and Propagation 148(6), 345–350.Google Scholar
20.Tomislav, D (2011) Dynamic Beamwidth Control in Partially Reflective Surface Antennas. PhD Thesis, University of Zagreb, Zagreb.Google Scholar
21.Khosronejad, M and Gentili, GG (2016) Directivity enhancement of a dual-band antenna based on partially reflective surface. 10th European Conference on Antennas and Propagation (EuCAP), Davos, 1–5.Google Scholar
22.Trentini, GV (1956) Partially reflecting sheet arrays. IRE Transactions on Antennas and Propagation 4, 666–671.Google Scholar
23.Vaidya, AR, Gupta, RK, Mishra, SK and Mukherjee, J (2012) Efficient high gain with low side lobe level antenna structures using parasitic patches on multilayer superstrate. Microwave and Optical Technology Letters 54(6), 1488–1493.Google Scholar
24.Vaidya, AR, Gupta, RK, Mishra, SK and Mukherjee, J (2012) High gain low side lobe level fabry parol cavity antenna with feed patch array. Progress in Electromagnetics Research C 28, 223–238.Google Scholar
25.Balanis, CA (1997) Antenna Theory Analysis and Design, 2nd edn., Canada: John Wiley & Sons.Google Scholar