Hostname: page-component-cd9895bd7-jn8rn Total loading time: 0 Render date: 2024-12-24T20:49:25.743Z Has data issue: false hasContentIssue false
  • English
  • Français

Design and model studies for solid-state power amplification at 210 GHz

Published online by Cambridge University Press:  19 April 2011

Sebastian Diebold ,
Ingmar Kallfass ,
Hermann Massler ,
Matthias Seelmann-Eggebert ,
Arnulf Leuther ,
Axel Tessmann ,
Philipp Pahl ,
Stefan Koch  and
Oliver Ambacher
Sebastian Diebold*
Affiliation:
Karlsruhe Institute of Technology (KIT), Kaiserstrasse 12, D-76131 Karlsruhe, Germany.
Ingmar Kallfass
Affiliation:
Karlsruhe Institute of Technology (KIT), Kaiserstrasse 12, D-76131 Karlsruhe, Germany. Fraunhofer Institute for Applied Solid-State Physics (IAF), Tullastrasse 72, D-79108 Freiburg, Germany.
Hermann Massler
Affiliation:
Fraunhofer Institute for Applied Solid-State Physics (IAF), Tullastrasse 72, D-79108 Freiburg, Germany.
Matthias Seelmann-Eggebert
Affiliation:
Fraunhofer Institute for Applied Solid-State Physics (IAF), Tullastrasse 72, D-79108 Freiburg, Germany.
Arnulf Leuther
Affiliation:
Fraunhofer Institute for Applied Solid-State Physics (IAF), Tullastrasse 72, D-79108 Freiburg, Germany.
Axel Tessmann
Affiliation:
Fraunhofer Institute for Applied Solid-State Physics (IAF), Tullastrasse 72, D-79108 Freiburg, Germany.
Philipp Pahl
Affiliation:
Karlsruhe Institute of Technology (KIT), Kaiserstrasse 12, D-76131 Karlsruhe, Germany.
Stefan Koch
Affiliation:
Sony Deutschland GmbH, Sensing Systems Laboratory, Hedelfinger Strasse 61, D-70327 Stuttgart, Germany.
Oliver Ambacher
Affiliation:
Fraunhofer Institute for Applied Solid-State Physics (IAF), Tullastrasse 72, D-79108 Freiburg, Germany.
*
Corresponding author: S. Diebold Email: [email protected]
Get access Rights & Permissions [Opens in a new window]

Abstract

The high millimeter-wave (mmW) frequency range offers new possibilities for high-resolution imaging and sensing as well as for high data rate wireless communication systems. The use of power amplifiers of such systems boosts the performance in terms of operating range and/or data rate. To date, however, the design of solid-state power amplifiers at frequencies about 210 GHz suffers from limited transistor model accuracy, resulting in significant deviation of simulation and measurement. This causes cost and time consuming re-design iterations, and it obstructs the possibility of design optimization ultimately leading to moderate results. For verification of the small-signal behavior of our in-house large-signal transistor model, S-parameter measurements were taken from DC to 220 GHz on pre-matched transistors. The large-signal behavior of the transistor models was verified by power measurements at 210 GHz. After model modification, based on process control monitor (PCM) measurement data, the large-signal model was found to match the measurements well. A transistor model was designed containing the statistical information of the PCM data. This allows for non-linear spread analysis and reliable load-pull simulations for obtaining the highest available circuit performance. An experimental determination of the most suitable transistor geometry (i.e. number of gate fingers and gate width) and transistor bias was taken on 100 nm gate length metamorphic high electron mobility transistor (mHEMT) transistors. The most suitable combination of number of fingers, gate width and bias for obtaining maximum gain, maximum output power, and maximum power added efficiency (PAE) at a given frequency was determined.

Keywords

modellingsimulationcharacterizations of devicescircuits power amplifierslinearizers
Type
Research Papers
Information
International Journal of Microwave and Wireless Technologies , Volume 3 , Special Issue 3: Special Issue on European Microwave Week 2010 , June 2011 , pp. 339 - 346
Copyright
Copyright © Cambridge University Press and the European Microwave Association 2011

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

[1]Deal, W.; et al. : Demonstration of a S-MMIC LNA with 16-dB Gain at 340-GHz, in IEEE Compound Semiconductor Integrated Circuit Symp., October 2007, 1–4.CrossRefGoogle Scholar
[2]Tessmann, A.; Leuther, A.; Massler, H.; Bronner, W.; Schlechtweg, M.; and Weimann, G.: Metamorphic H-Band Low-Noise Amplifier MMICs, in IEEE/MTT-S Int. Microwave Symp., June 2007, 353–356.CrossRefGoogle Scholar
[3]Radisic, V.; et al. : A 50 mW 220 GHz power amplifier module, in Microwave Symp. Digest (MTT), 2010 IEEE MTT-S Int., May 2010.CrossRefGoogle Scholar
[4]Kallfass, I.; et al. : A 200 GHz monolithic integrated power amplifier in metamorphic HEMT technology, IEEE Microw. Wirel. Compon. Lett., 19 (6) (2009), 410–412.CrossRefGoogle Scholar
[5]Martin, G. H.: On-wafer large-signal model verification, In 38th ARFTG Conf. Digest-Winter, vol. 20, December 1991, 5–14.CrossRefGoogle Scholar
[6]Leuther, A.; et al. : 50 nm MHEMT technology for G- and H-band MMICs, in IEEE 19th Int. Conf. on Indium Phosphide and Related Materials, May 2007, 24–27.CrossRefGoogle Scholar
[7]Tessmann, A.; Kallfass, I.; Leuther, A.; Massler, H.; Schlechtweg, M.; and Ambacher, O.: Metamorphic MMICs for operation beyond 200 GHz, in European Microwave Integrated Circuit Conf., October 2008, 210–213.CrossRefGoogle Scholar
[8]Seelmann-Eggebert, M.; Merkle, T.; van Raay, F., Quay, R.; and Schlechtweg, M.: A systematic state-space approach to large-signal transistor modeling, IEEE Trans. Microw. Theory Tech., 55(2) (2007), 195–206.CrossRefGoogle Scholar