Hostname: page-component-586b7cd67f-r5fsc Total loading time: 0 Render date: 2024-11-25T10:13:00.109Z Has data issue: false hasContentIssue false
  • English
  • Français

Wideband and compact slot loaded annular ring microstrip antenna using L-probe proximity-feed for wireless communications

Published online by Cambridge University Press:  10 April 2015

Anil Kumar Singh ,
Ravi Kumar Gangwar  and
Binod K. Kanaujia
Anil Kumar Singh
Affiliation:
Electronics and Instrumentation Engineering, Faculty of Engineering and Technology, M.J.P. Rohilkhand University, Bareilly-243006, India Department of Electronics Engineering, I.S.M. Dhanbad, Jharkhand-826004, India
Ravi Kumar Gangwar
Affiliation:
Department of Electronics Engineering, I.S.M. Dhanbad, Jharkhand-826004, India
Binod K. Kanaujia*
Affiliation:
Department of Electronics and Communication Engineering, AIACTR, Geeta Colony-110031, Delhi, India. Phone: +9111 22048047
*
Corresponding author: B. K. Kanaujia Email: [email protected]
Get access Rights & Permissions [Opens in a new window]

Abstract

A wideband orthogonally slot cut annular ring microstrip antenna fed by L-shaped probe is investigated using modal expansion cavity model and circuit theory approach. Simulation of the proposed antenna is performed using Ansoft HFSS and simulated results are compared with the measured and theoretical results. The impedance bandwidth of about 37.46% is observed at resonant frequency 3.15 GHz. The proposed antenna realizes an improvement in bandwidth of 13.46% and miniaturization in physical dimension about 10% from earlier reported structures. An improvement in bandwidth and miniaturization is due to thick substrate, L-probe feed, and orthogonally loaded slots. The measured results of fabricated antennas are in good agreement with simulated and theoretical results.

Keywords

Antennas and propagation for wireless systemsAntenna designModeling and measurements
Type
Research Papers
Information
International Journal of Microwave and Wireless Technologies , Volume 8 , Issue 7 , November 2016 , pp. 1085 - 1093
Copyright
Copyright © Cambridge University Press and the European Microwave Association 2015 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

[1] Mink, J.W.: Circular ring microstrip antenna elements. IEEE AP-S Int. Symp., Digest, 18 (1980), 605–608.Google Scholar
[2] Carver, K.R.: Microstrip antenna technology. IEEE Trans. Antenna Propag., 29 (1981), 2–24.CrossRefGoogle Scholar
[3] Gautam, A.K.; Yadav, S.; Kanaujia, B.K.: ACPW-fed compact UWB microstrip antenna. IEEE Trans. Antenna Wireless Propag. Lett., 12 (2013), 151–154.Google Scholar
[4] Kanaujia, B.K.; Vishvakarma, B.R.: Analysis of gunn integrated annular ring microstrip antenna. IEEE Trans. Antenna Propag., 52–1 (2004), 88–97.CrossRefGoogle Scholar
[5] Ohmine, H.; Sunahara, Y.; Matsunaga, M.: An annular- ring microstrip antenna fed by a co-planer feed circuit for mobile satellite communication use. IEEE Trans. Antenna Propag., 45–6 (1997), 1001–1008.CrossRefGoogle Scholar
[6] Kanaujia, B.K.; Vishvakarma, B.R.: Design considerations for the development of the annular ring microstrip antenna. Int. J. Electron., 89–8 (2002), 665–667.CrossRefGoogle Scholar
[7] Bhattacharya, A.K.; Garg, R.: A microstrip array of concentric annular rings. IEEE Trans. Antenna Propag., AP-33-6 (1985), 655–659.CrossRefGoogle Scholar
[8] EI-Khamy, S.E.; EI-Awadi, R.M.; EI-Sharrawy, E.-B.A.: Simple analysis and design of annular ring microstrip antennas. IEE Proc., 133–3 (1986), 198–202.Google Scholar
[9] Bhattacharya, A.K.; Garg, R.: Input impedance of annular ring microstip antenna using circuit theory approach. IEEE Trans. Antenna Propag., AP-33-4 (1985), 369–374.Google Scholar
[10] Ribero, J.-M.; Damiano, J.-P.; Staraj, R.: Accurate analysis and synthesis of annular ring microstrip antennas. IEE Proc. Microw. Antenna Propag., 144–5 (1997), 341–346.Google Scholar
[11] Chen, S.C.; Liu, G.C.; Chen, X.Y.; Lin, T.F.; Liu, X.G.; Duan, Z.Q.: Compact dual-band GPS microstrip antenna using multilayer LTCC Substrate. IEEE Antennas Wireless Propag. Lett., 9 (2010), 421–423.Google Scholar
[12] Iwasaki, H.: A circularly polarized small-size microstrip antenna with across slot. IEEE Trans. Antennas Propag., 44–10 (1996), 1399–1401.CrossRefGoogle Scholar
[13] Chen, H.D.: Compact circularly polarized microstrip antenna with slotted ground plane. Electron. Lett., 38–13 (2002), 616–617.Google Scholar
[14] Gautam, A.K.; Kanaujia, B.K.: A novel dual-band asymmetric slot with defected ground structure microstrip antenna for circular polarization operation. Microw. Opt. Technol. Lett., 55 (2013), 1198–1201.Google Scholar
[15] Wong, K.L.; Hsu, W.H.; Wu, C.K.: Single-feed circularly polarized microstrip antenna with a slot. Microw. Opt. Technol. Lett., 18 (1998), 306–308.Google Scholar
[16] Lu, J.H.; Yu, H.C.; Wong, K.L.: Compact circular polarization design for equilateral triangular microstrip antenna with spur lines. Electron. Lett., 34 (1998), 1989–1990.Google Scholar
[17] Wong, H.; So, K.K.; Ng, K.B.; Luk, K.M.; Chan, C.H.; Xue, Q.: Virtually shorted patch antenna for circular polarization. IEEE Antennas Wireless Propag. Lett., 9 (2010), 1213–1216.Google Scholar
[18] Nasimuddin; Esselle, K.P.; Verma, A.K.: Wideband circularly polarized stacked microstrip antennas. IEEE Antennas Wireless Propag. Lett., 6 (2007), 21–24.Google Scholar
[19] Latif, S.I.; Shafai, L.: Microstrip square-ring antenna with capacitive feeding for multi-frequency operation, in IEEE Antennas and Propagation Society Int. Symp., 2008, 1–4.CrossRefGoogle Scholar
[20] Latif, S.I.; Shafai, L.: Electromagnetically-coupled multiple square rings for multi-frequency operation, in IEEE Antennas and Propagation Society Int. Symp., 2009, 1–4.CrossRefGoogle Scholar
[21] Pandey, G.P.; Kanaujia, B.K.; Gupta, S.K.; Gautam, A.K.; De, A. Analysis and design of frequency agile stacked circular microstrip patch using extended cavity model for wireless systems. Int. J. Microw. Opt. Technol. (USA), 4 (2012), 268–277.Google Scholar
[22] Gupta, S.K.; Sharma, A.; Kanaujia, B.K.; Rudra, S.; Misra, R.R.; Pandey, G.P.: Orthogonal slot cut stacked circular patch microstrip antenna for multiband operations. Microw. Opt. Technol. Lett., 55–4 (2013), 873–882.Google Scholar
[23] Lo, W.K.; Hu, J.-L.; Chan, C.H.; Luk, K.: L-shaped probe-feed circularly polarized microstrip patch antenna with a cross slot. Microw. Opt. Technol. Lett., 25–4 (2000), 251–251.3.0.CO;2-H>CrossRefGoogle Scholar
[24] Guo, Y.-X.; Luk, K.-M.; Lee, K.-F.: L-probe proximity-fed annular ring microstrip antennas. IEEE Trans. Antenna Propag., 49–1 (2001), 19–21.Google Scholar
[25] Kokotoff, D.M.; Aberle, J.T.; Waterhouse, R.B.: Rigorous analysis of probe-fed printed annular ring antennas. IEEE Trans. Antennas Propag., 47 (1999), 384–388.Google Scholar
[26] Hoffman, R.K.: Handbook of Microwave Integrated Circuits, Artech House, Norwood, MA, 1987.Google Scholar
[27] Edwards, T.C.: Foundations for Microstrip Circuit Design, John Wiley & Sons, Chichester, 1983.Google Scholar
[28] Chew, W.C.: A broad-band annular-ring microstrip antenna. IEEE Trans. Antenna Propag., AP-30 (1982), 918–922.Google Scholar