Hostname: page-component-745bb68f8f-mzp66 Total loading time: 0 Render date: 2025-02-03T01:49:12.148Z Has data issue: false hasContentIssue false
  • English
  • Français

Integration of RF rectenna with thin film solar cell to power wearable electronics

Published online by Cambridge University Press:  28 April 2020

B. Naresh ,
Vinod Kumar Singh Open the ORCID record for Vinod Kumar Singh [Opens in a new window]  and
V. K. Sharma
B. Naresh
Affiliation:
Department of Electrical Engineering, Bhagwant University, Ajmer, Rajasthan, India
Vinod Kumar Singh*
Affiliation:
Department of Electrical Engineering, Bhagwant University, Ajmer, Rajasthan, India
V. K. Sharma
Affiliation:
Department of Electrical Engineering, Bhagwant University, Ajmer, Rajasthan, India
*
Author for correspondence: Vinod Kumar Singh, E-mail: [email protected]
Get access Rights & Permissions [Opens in a new window]

Abstract

This paper reports an integration of dual band microstrip antenna with thin film amorphous silicon solar cell which creates a wearable system to harvest microwave energy. The multiple layers in the encapsulation of the thin film solar cell are used as a substrate for microstrip antenna. The rectifier and matching circuit are designed on cotton jeans material and the whole system is mechanically supported by the foam of 5 mm thick. The performance of the antenna is studied for the mechanical bending condition. The device has maintained good power conversion efficiency. The efficiency of the voltage doubler is tested by varying radio frequency power levels from −30 to10 dBm. The voltage doubler conversion efficiency at 1.85 and 2.45 GHz are 58 and 43%, respectively, for a load of 7.5 kΩ for an input power level of −5 dBm.

Keywords

Dual bandflexible substratemulti-layerring antennasolar cellwearable
Type
Wireless Power Transfer and Energy Harvesting
Information
International Journal of Microwave and Wireless Technologies , Volume 13 , Issue 1 , February 2021 , pp. 46 - 57
Check for updates
Copyright
Copyright © Cambridge University Press and the European Microwave Association 2020

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

Jokic, P and Magno, M (2017) Powering smart wearable systems with flexible solar energy harvesting. 2017 IEEE International Symposium on Circuits and Systems (ISCAS), Baltimore, MD.CrossRefGoogle Scholar
Wu, T, Arefin, MS, Redouté, J and Yuce, MR (2017) Flexible wearable sensor nodes with solar energy harvesting. 2017 39th Annual International Conference of the IEEE Engineering in Medicine and Biology Society (EMBC), Seogwipo,2017, pp. 3273–3276.CrossRefGoogle Scholar
Hu, Y, Rieutort-Louis, W, Huang, L, Sanz-Robinson, J, Wagner, S, Sturm, JC and Verma, N (2012) Flexible solar-energy harvesting system on plastic with thin-film LC oscillators operating above ft for inductively-coupled power delivery,” Proceedings of the IEEE 2012 Custom Integrated Circuits Conference, San Jose, CA, 2012, pp. 1–4.Google Scholar
Li, Y and AU-Shi, R (2015) An intelligent solar energy-harvesting system for wireless sensor networks. EURASIP Journal on Wireless Communications and Networking 2015, 1–12.CrossRefGoogle Scholar
Tanaka, M, Suzuki, Y, Araki, K and Susuki, R (1995) Microstrip antennas with solar cells for microsatellites. Electronics Letters 31, 5–6.CrossRefGoogle Scholar
Vaccaro, S, Mosig, JR and de Maagt, P (2002) Making planar antennas out of solar cells. Electronics Letters 38, 945–947.CrossRefGoogle Scholar
Henze, N, Giere, A, Fruchting, H and Hofmann, P (2003) GPS patch antenna with photovoltaic solar cells for vehicular applications,” in Proceedings of the IEEE Vehicular Technology Conference VTC 2003, Orlando, FL, vol. 1, pp. 50–54.Google Scholar
Nair, S, Roo Ons, MJ, Ammann, MJ, McCormack, SJ and Norton, B (2008) A metal plate solar antenna for UMTS pico-cell base station, Loughborough Antennas and Propagation Conference, Loughborough, pp. 373–376. doi: 10.1109/LAPC.2008.4516944.CrossRefGoogle Scholar
Vaccaro, S, Torres, P, Mosig, JR, Shah, A, Zürcher, J-F, Skrivervik, AK, de Maagt, P and Gerlach, L (2000) Stainless steel slot antenna with integrated solar cells. Electronics Letters 36, 2059–2060.CrossRefGoogle Scholar
Andia Vera, G, Georgiadis, A, Collado, A and Via, S (2010) Design of a 2.45 GHz rectenna for electromagnetic (EM) energy scavenging, IEEE Radio and Wireless Symposium, RWW 2010 - Paper Digest, pp. 61–64.Google Scholar
Collado, A and Georgiadis, A (2013) Conformal hybrid solar and electromagnetic (EM) energy harvesting rectenna. IEEE Transactions on Circuits and Systems I: Regular Papers 60, 2225–2234.CrossRefGoogle Scholar
Sun, H, Guo, YX, He, M and Zhong, Z (2013) A dual-band rectenna using broadband yagi antenna array for ambient RF power harvesting. IEEE Antennas Wireless Propagation Letter 12, 918–921.CrossRefGoogle Scholar
Song, C, Houng, Y, Zhou, J, Zhang, J, Yuan, S and Carter, P (2015) A high efficiency broadband rectenna for ambient wireless energy harvesting. IEEE Transactions Antennas Propagation 63, 3486–3495.CrossRefGoogle Scholar
Bandyopadhyay, S and Chandrakasan, AP (2012) Platform architecture for solar, thermal, and vibration energy combining with MPPT and single inductor. IEEE Journal of Solid-State Circuits 47, 2199–2215.CrossRefGoogle Scholar
Popovic, B (2004) Recycling ambient microwave energy with broad-band rectenna arrays. IEEE Transactions on Microwave Theory and Techniques 52), 1014–1024.Google Scholar
Ghovanloo, M and Najafi, K (2004) Fully integrated wideband high-current rectifiers for inductively powered devices. IEEE Journal of Solid-State Circuits 39, 1976–1984.CrossRefGoogle Scholar
Curty, J-P, Declercq, M, Dehollain, C and Joehl, N (2007) Design and Optimization of Passive UHF RFID Systems, 1st Edn. New York: Springer Science Business Media.Google Scholar
Niotaki, K and Collado, A (2014) Georgiadis, etc “solar/electromagnetic energy harvesting and wireless power transmission. Proceedings of the IEEE 102, 1712–1722.Google Scholar
Niotaki, K, Giuppi, F, Georgiadis, A and Collado, A (2014) Solar /EM energy harvesting for autonomous operation of a monitoring sensor platform. Wireless power Transfer 1, 44–50.CrossRefGoogle Scholar
Yehui, H, Leitermann, O, Jackson, DA, Rivas, JM and Perreault, DJ (2007) Resistance compression networks for radio-frequency power conversion. IEEE Transactions on Power Electronics 22, 41–53.Google Scholar
Marian, V, Allard, B, Vollaire, C and Verdier, J (2012) Strategy for microwave energy harvesting from ambient field or a feeding source. IEEE Transactions on Power Electronics 27, 4481–4491.CrossRefGoogle Scholar
Song, C, Huang, Y, Carter, P, Zhou, J, Yuan, S, Xu, Q and Kod, M (2016) A novel six-band dual CP rectenna using improved impedance matching technique for ambient RF energy harvesting. IEEE Transactions on Antennas and Propagation 64, 3160–3171. doi: 10.1109/TAP.2016.2565697.CrossRefGoogle Scholar
Surface Mount Mixer and Detector Schottky Diodes (2013) Data Sheet Skyworks Solutions, Inc., Woburn, MA, USA.Google Scholar
Pavone, D, Buonanno, A, D'Urso, M and Corte, F (2012) Design considerations for radio frequency energy harvesting devices,”. Progress In Electromagnetics Research B 31, 19–35.Google Scholar
Chaudhary, G, Kim, P, Jeong, Y and Yoon, JH (2012) Design of high efficiency RF-DC conversion circuit using novel termination networks for RF energy harvesting system. Microwave and Optical Technology Letters 54, 2330–2335.CrossRefGoogle Scholar
Hameed, Z and Moez, K (2017) Design of impedance matching circuits for RF energy harvesting systems. Microelectronics Journal 62, 49–56.CrossRefGoogle Scholar
Wang, X, Zhang, L, Xu, Y, Bai, Y-F, Liu, C and Shi, X-W (2013) A tri-band impedance transformer using stubbed coupling line. Progress in Electromagnetics Research 141, 33–45.CrossRefGoogle Scholar
Amaro, N, Mendes, C and Pinho, P (2011) Bending effects on a textile microstrip antenna. 2011 IEEE International Symposium on Antennas and Propagation (APSURSI), Spokane, WA, pp. 282–285.CrossRefGoogle Scholar
Sankaralingam, S and Gupta, B (2010) Development of textile antennas for body wearable applications and investigations on their performance under bent conditions. Progress in Electromagnetics Research B 22, 53–71.CrossRefGoogle Scholar
Montero, R, Espí, P, Cordero, C and Martínez Rojas, J (2019) Bend and moisture effects on the performance of a U-shaped slotted wearable antenna for off-body communications in an Industrial Scientific Medical (ISM) 2.4 GHz band. Sensors 19, 1804. doi: 10.3390/s19081804.CrossRefGoogle Scholar