Hostname: page-component-78c5997874-lj6df Total loading time: 0 Render date: 2024-11-02T18:24:21.905Z Has data issue: false hasContentIssue false

Hilt's Law and the Volatile Contents of Coal Seams

Published online by Cambridge University Press:  01 May 2009

Extract

Arbitrary relations between volatile percentage and depth of the seams can be established readily for both the South Wales and Kent coalfields by means of the Hilt rates: this is perhaps most clearly indicated by the South Wales sequences, which are considered first. If we take as a horizontal datum plane a seam which contains 40 per cent of volatiles we can calculate from the Hilt rate the depth for any given sequence at which the Nine-Foot seam would lie below that datum. Thus, at New Bridge the recorded volatile content of the Nine-Foot seam is 28; a least squares solution gives 26·7; adopting a value of 27 and a Hilt rate of 5·32, that seam would be 2,440 feet below the datum. At Treherbert the recorded volatile is 11, while a least squares solution gives 11·5; the depth of the Nine-Foot seam below the datum would thus be 5,400 feet. It is clear, therefore, that if the 40 per cent seam were regarded as a horizontal plane, depression was at one time more rapid in the west than in the east. It is known that a rapid increase in the thickness of the measures below the Pennant Sandstone takes place westward, but the difference of 3,000 feet indicated above is much more than occurred by differential warping during the formation of the lower measures among which the Nine-Foot seam lies. The tendency which is evident, however, in these lower measures must have continued into much later Coal Measure times, in which case a 40 per cent datum was itself warped down.

Type
Articles
Copyright
Copyright © Cambridge University Press 1949

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

British Regional Geology, South Wales. Mem. Geol. Surv.Google Scholar
British Regional Geology, Central England. Mem. Geol. Surv.Google Scholar
Cannon, C. G., Griffiths, M., and Hirst, W., 1944. The Carbonisation of Coal in The Ultrafine Structure of Coals and Cokes. The British Coal Utilization Research Association.Google Scholar
Dines, H. G., 1933. The Sequence and Structure of the Kent Coalfield. Geol. Surv. Summ. Prog, for 1932, p. 15.Google Scholar
Handbook of Physical Constants, 1942. Geol. Soc. Amer., Special Paper No. 36.Google Scholar
Hickling, H. G. A., 1932. The Properties of Coals as determined by their Mode of Origin. Journ. Inst. Fuel.Google Scholar
Illing, V. C., 1944. In discussion of papers by O. T. Jones and A. W. Skempton. Quart. Journ. Geol. Soc., c, p. 158.Google Scholar
Millott, J. O'n., 1946. The Seams encountered in a deep boring at Pie Rough, near Leek, Staffordshire. Trans. Inst. Min. Eng., 105, 528.Google Scholar
Pollard, A. W., and Strahan, A., 1908. The Coals of South Wales, 2nd ed., 1915. Mem. Geol. Surv.Google Scholar
Raistrick, A., and Marshall, C. E., 1939, The Nature and Origin of Coal and Coal Seams. English Universities Press, Ltd., London.Google Scholar
Regional Survey Reports, 1946. South Wales Coalfield. Ministry of Fuel and Power.Google Scholar
Trotter, F. M., 1949. The Devolatilization of Coal Seams in South Wales. Quart. Journ. Geol. Soc., civ (1948), 387.Google Scholar
Wellman, H. W., 1948. Metamorphic Gradients in the Kent Coalfield. Econ. Geol., xliii, 506.Google Scholar
White, D., 1908. Søme problems of the formation of Coal. Econ. Geol. iii, 292.CrossRefGoogle Scholar