Hostname: page-component-f554764f5-44mx8 Total loading time: 0 Render date: 2025-04-14T00:32:27.583Z Has data issue: false hasContentIssue false
  • English
  • Français

Design and Fabrication of Magnet Coils

Published online by Cambridge University Press:  08 October 2010

M. Jaski
M. Jaski*
Affiliation:
Advanced Photon Source, Argonne National Laboratory, Argonne, IL 60439, USA
*
†Email address for correspondence:[email protected]
Get access

Abstract

Users at the Advanced Photon Source (APS) requested a special purpose undulator that required 456 electromagnetic coils. This paper discusses the design and fabrication techniques used at the APS to build these room-temperature coils. The coils are made from insulated square copper conductor and are vacuum impregnated with epoxy.

Type
Poster paper
Information
Diamond Light Source Proceedings , Volume 1 , Issue MEDSI-6 , October 2010 , e7
Copyright
Copyright © Diamond Light Source Ltd 2010

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable

References

REFERENCES

Hexion Specialty Chemicals, Inc., Houston, TX. http://www.hexion.com/Products/TechnicalDataSheet.aspx_id=2635&terms=hexion+505.Google Scholar
Tanabe, J. T. 2005 Iron Dominated Electromagnets, 1st edn. pp. 267–284, World Scientific Publishing Co. Pte Ltd.CrossRefGoogle Scholar