Hostname: page-component-586b7cd67f-g8jcs Total loading time: 0 Render date: 2024-11-22T20:51:16.914Z Has data issue: false hasContentIssue false
  • English
  • Français

Influence of Dodecylamine Chloride on the Surface Free Energy of Kaolinite

Published online by Cambridge University Press:  02 April 2024

Bronisław Jańczuk ,
Emil Chibowski ,
Tomasz Białopiotrowicz ,
Lucyna Hołysz  and
Anna Kliszcz
Bronisław Jańczuk
Affiliation:
Department of Physical Chemistry, Institute of Chemistry, Maria Curie-Sklodowska University, 20-031 Lublin, Poland
Emil Chibowski
Affiliation:
Department of Physical Chemistry, Institute of Chemistry, Maria Curie-Sklodowska University, 20-031 Lublin, Poland
Tomasz Białopiotrowicz
Affiliation:
Department of Physical Chemistry, Institute of Chemistry, Maria Curie-Sklodowska University, 20-031 Lublin, Poland
Lucyna Hołysz
Affiliation:
Department of Physical Chemistry, Institute of Chemistry, Maria Curie-Sklodowska University, 20-031 Lublin, Poland
Anna Kliszcz
Affiliation:
Department of Physical Chemistry, Institute of Chemistry, Maria Curie-Sklodowska University, 20-031 Lublin, Poland
Rights & Permissions [Opens in a new window]

Abstract

Core share and HTML view are not available for this content. However, as you have access to this content, a full PDF is available via the ‘Save PDF’ action button.

Contact angles of glycerol and diiodomethane drops were measured on the surface of kaolin pellets covered with different amounts of dodecylamine chloride (DDACl) to as much as one monolayer. For a glycerol drop, the contact angle changed from 25.7° (bare surface) to 45.4° for the surface precoated with 0.125 monolayer of DDACl, but remained nearly constant above this level up to one monolayer. For a diiodomethane drop, the contact angle changed from 28.6° (bare surface) to 58.1° for one DDACl monolayer precoating. Using these contact angles and a modified Young equation, the dispersive and nondispersive components of the surface free energy of DDACl-covered kaolin were calculated. These data showed that in the extreme case (one monolayer) the dispersive component was reduced by the DDACl from ∼36 mJ/m2 (bare surface) to 25.4 mJ/m2, i.e., the value characteristic for paraffin (25.5 mJ/m2); however, the nondispersive component was not reduced to zero. A minimum value (15.83 mJ/m2) was determined for the sample covered with 0.125 DDACl monolayer (calculated), and a slight increase in the nondispersive component was observed for greater coverages. Such a change of the nondispersive component suggests that, at higher coverages, some adsorbed DDACl molecules were oriented with their polar ends off the surface. Based on the values of the γsfd and γsfn, the work of water spreading was calculated. This work was positive for the bare surface (32.8 mJ/m2) and methanol-treated (36.5 mJ/m2) kaolin surface, but negative for 0.125 DDACl monolayer precoating (-31.1 mJ/m2). It remained essentially unchanged for higher coverages. These data mean that bare and methanol-treated kaolinite surfaces were hydrophilic and that DDACl-treated surfaces were hydrophobic.

Keywords

Contact angleDodecylamine chlorideHydrophobicityKaoliniteSurface free energy
Type
Research Article
Information
Clays and Clay Minerals , Volume 38 , Issue 1 , February 1990 , pp. 53 - 56
Copyright
Copyright © 1990, The Clay Minerals Society

References

Dann, J. R., 1970 Forces involved in the adhesive process. Critical surface tension of polymeric solids as determined with polar liquids J. Colloid Interface Sci. 32 302 – 320.CrossRefGoogle Scholar
Fowkes, F. M., 1964 Attractive forces at interface Ind. Eng. Chem. 56 12 40 – 52.CrossRefGoogle Scholar
Good, R. J. and Elbing, E., 1970 Generalization of theory for estimation of interfacial energies Ind. Eng. Chem. 62 3 54 – 78.CrossRefGoogle Scholar
Jańczuk, B. and Białopiotrowicz, T., 1988 Components of surface free energy of some clay minerals Clays & Clay Minerals 36 243 – 248.CrossRefGoogle Scholar
Jańczuk, B. and Białopiotrowicz, T., 1989 Surface free energy components of liquids and low energy solids and contact angle J. Colloid Interface Sci. 127 189 – 204.CrossRefGoogle Scholar
Jańczuk, B., Białopiotrowicz, T. and Wójcik, W., 1989 The components of surface tension of liquids and their usefulness in determinations of surface free energy of solids J. Colloid Interface Sci. 127 59 – 66.CrossRefGoogle Scholar
Jańczuk, B., Chibowski, E., Hajnos, M., Białopiotrowicz, T. and Stawiński, J., 1989 Influence of exchangeable cations on the kaolinite surface free energy determined from contact angles Clays & Clay Minerals 37 269 – 272.Google Scholar
Jańczuk, B., Holysz, L., Białopiotrowicz, T. and Chibowski, E., 1989 Studies of dispersion and nondispersion components of the surface free energy of soil minerals in a presence of water film Polish J. Soil. Sci. .Google Scholar
Jouany, C. and Chassin, P., 1987 Determination of the surface energy of clay-organic complexes by contact angle measurements Colloids Surfaces 27 289 – 303.CrossRefGoogle Scholar
Kaelble, D. H. and Cirlin, F. H., 1971 Dispersion and polar contributions to surface tension of poly(methylene oxide) and Na-treated polytetrafluoroethylene J. Polymer Sci. Sec A-2 9 363 – 368.CrossRefGoogle Scholar
Marmur, A., 1983 Equilibrium and spreading of liquids on solid surfaces Adv. Colloid Interface Sci. 19 75 – 102.CrossRefGoogle Scholar
Neumann, A. W., Good, R. J., Good, R. J. and Stromberg, R. R., 1979 Techniques of measuring contact angles Surface and Colloid Science, Vol. 11 New York Plenum Press 31 – 91.CrossRefGoogle Scholar
Owens, D. K. and Wendt, R. C., 1969 Estimation of the surface free energy of polymers J. Appl. Polymer Sci. 13 1741 – 1747.CrossRefGoogle Scholar
Panzer, J., 1973 Components of solid surface free energy from wetting measurements J. Colloid Interface Sci. 44 142 – 161.CrossRefGoogle Scholar
Swartzen-Allen, S. L. and Matijevic, E., 1974 Surface and colloid chemistry of clays Chem. Rev. 74 385 – 400.CrossRefGoogle Scholar