Hostname: page-component-586b7cd67f-vdxz6 Total loading time: 0 Render date: 2024-11-23T08:27:24.158Z Has data issue: false hasContentIssue false
  • English
  • Français

The adsorption of 1,4-dioxan, tetrahydrofuran and tetrahydropyran from binary solution with methanol on Al3+ and Cr3+-exchanged montmorillonite

Published online by Cambridge University Press:  09 July 2018

C. Breen  and
A. Deane
C. Breen
Affiliation:
School of Chemical Sciences, National Institute for Higher Education, Glasnevin, Dublin 9, Eire
A. Deane
Affiliation:
School of Chemical Sciences, National Institute for Higher Education, Glasnevin, Dublin 9, Eire
Get access Rights & Permissions [Opens in a new window]

Abstract

Surface excess isotherms were determined for the adsorption of 1,4-dioxan (DIOX), tetrahydropyran (THP) and tetrahydrofuran (THF) from binary solution with methanol (MeOH) on Al3+- and Cr3+-exchanged, montmorillonite containing different amounts of pre-adsorbed water. The isotherm type is dominated by the binary mixture whereas the amplitude, which follows the sequence DIOX > THP > THF, is further influenced by the exchange cation, Al3+ > Cr3+, and the water content of the clay. The sorption of DIOX and THP from MeOH exhibit a type IV isotherm in the Schay-Nagy classification on both cation-exchanged forms, whilst that of THF from MeOH is of type I and THF is the preferred adsorbate. The azeotropic point for the type IV isotherms is close to a 1:1 mole ratio for the samples dried at 120°C but when the samples are rehydrated at 12% r.h. following thermal pretreatment at 120°C the azeotropic point shifts in favour of the cyclic ethers DIOX and THP, making them the preferred component over a substantial portion of the composition range.

Type
Research Article
Information
Clay Minerals , Volume 22 , Issue 2 , June 1987 , pp. 199 - 205
Copyright
Copyright © The Mineralogical Society of Great Britain and Ireland 1987

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

Adams, J.M., Reid, P.I. & Walters, M.J. (1977) The cation exchange capacity of clays. School Sci. Rev. 59, 722– 725.Google Scholar
Adams, J.M., Clement, D.E. & Graham, S.H. (1982) Synthesis of methyl t-butyl ether from methanol and isobutene using a clay catalyst. Clays Clay Miner. 30, 120–134.CrossRefGoogle Scholar
Bennet, H. & Reid, R.A. (1971) Chemical Methods of Silicate Analysis. Academic Press, London, pp. 71–79.Google Scholar
Cornford, P.V., Kipling, J.J. & Wright, E.H.M. (1962) Adsorption from solution: thickness of the adsorbed layer. Trans. Farad. Soc. 58, 74–85.Google Scholar
Davis, J. & Everett, D.H. (1983) Adsorption from solution. Pp. 136–144 in: Colloid Science (Everett, D. H., editor). Specialist Periodical Reports, The Royal Society of Chemistry, London.Google Scholar
Everett, D.H. (1964) Thermodynamics of adsorption from solution. Part 1. Perfect systems. Trans. Faraday Soc. 60, 1803–1813.Google Scholar
Jaycock, M.J. & Parfitt, G.D. (1981) Chemistry of Interfaces. Ellis-Horwood Ltd., Chichester, U.K., pp. 234– 272.Google Scholar
Parfitt, G.D. & Willis, E. (1964) Adsorption at the solid-liquid interface. I. Alkylbenzenes on graphon from solutions in n-heptane. J. Phys. Chem. 68, 1780–1786.Google Scholar
Schay, G. (1969) Surface and Colloid Science. Wiley Interscience, New York, p. 155.Google Scholar
Schay, G. & Nagy, L. (1961) Nouveaux aspects de l'interpretation des isothermes d'adsorption de melanges liquides binaires sur des surfaces solides. J. Chim. Phys. 58, 149–158.Google Scholar